I've ready quite a few posts with regard to the following problem:
once connected with the car kit in handsfree mode, everything works fine except the carkit mic doesn't work, you have to use the device's mic, which is absurd.
I've gone through the Himalaya forum, upgrading, Wm2004, magician forum, blue angel, etc... and I cannot seem to manage to find a solution.
Universal owners: are you able to connect to the carkit and use the carkit's microphone? If you are, can you let me know what you've done?
Thank you!!
do you have the solution? I have the same issue..
Whenever I use my bluetooth headset (Motorola HS850) I can hear the person on the other end just fine but they cannot hear me unless I literally SCREAM. Since that's obviously not a decent workaround I've taken to not using my headset. I miss it and want to use it again.
I've searched the forums and read through this thread completely. I cannot find a single answer that everyone agrees upon.
Can someone please tell me how to increase the volume of the mic of my headset?
I'm runnning Mr Clean's 2.3 ROM (non-UK version).
I have the same problem with all 3 my BT headsets, my bluetrek G2, my i-tech stereo headset and my Sony Ericson BT Car Kit.
What is worse: even when using the the wizard as a normal phone people complain they can't hear me and I also have difficulty in hearing them. I am on the same rom as you.
Without the headset everthing's fine. I hear them, they hear me, no problems at all. Add the headset and the problems begin.
melvynadam said:
I've searched the forums and read through this thread completely. I cannot find a single answer that everyone agrees upon.
Can someone please tell me how to increase the volume of the mic of my headset?
Click to expand...
Click to collapse
try to increase value of HEADSET_UPLINK_VOLUME registry key. it worked for me.
Thanks, that was the key that looked most promising in the thread I refered to in the OP.
I have in fact already tried changing that from 13 to DD but to no avail. What did you change it to?
melvynadam said:
Thanks, that was the key that looked most promising in the thread I refered to in the OP.
I have in fact already tried changing that from 13 to DD but to no avail. What did you change it to?
Click to expand...
Click to collapse
i've changed it to DD. works with me..
Anyone else?
Hard to believe I'm the only one with this issue. Anyone else got a solution I can try?
(in other words: BUMP)
i have the same problem.. i jsut bought a Jabra JX10 after having a Moto BT850 and there's no volume for the BT headset.. highly annoying becuase noone can hear me.. i'm going to try the registry setting for the headset, but instead of DD i'm trying CC which worked wonders for using the regular mic.. we'll see
Hi guys
Did either of you get anywhere with this? My O2 Xda Mini S also has this issue. Geesh you'd think they'd test these things before releasing products!
I've tried setting the following to FF & CC under *all* 4 of the AUDIOGAIN folders:
EARPHONE_UPLINK_VOLUME
HEADSET_UPLINK_VOLUME
RECEIVE_UPLINK_VOLUME
I then rebooted, and things are no different. It's weird though because if you take off the Bluetooth (I use the Jabra BT500) and talk directly into the Mic, it sounds perfect - just not when worn on the ear! I thought my old BT200 was faulty due to this, which is why I wrongly bought a new one :roll: Thanks O2/HTC!
Come on guys, let's get this sorted for everyone. Who knows something and isn't telling?
Who knows something and isn't telling?
Click to expand...
Click to collapse
I wish I did. Sadly I've given up and no longer use my BT headset. I miss it like crazy but like you, reached a dead end. If someone has a solution please, please share.
Looks like nobody is able to help us with this.
Is yours an O2 Xda Mini S?
If so have you reported it to O2 technical as I have?
What Bluetooth(s) have you tried?
I started this thread to identify working Bluetooth headsets, but so far only one reply. Maybe it's a brand-by-brand issue:
http://forum.xda-developers.com/viewtopic.php?p=330649#330649
O2 suggested replacing the phone against my wishes (as others have reported the volume issues and reg hacks). I will report back if I still have the problem with the replacement.
have you guys compared roms? I noticed two people were using the same rom? If everyone with this issue is using the same rom, then maybe that could be the underlying issue...? I'm using the Cingular 2.25 rom and never had this problem.
I was using O2 v2.21.4.101
ROM
I'm using Mr. Clean's 2.24a ROM and love it. I downloaded the ROM on the advice of a friend who uses the same ROM and successfully uses a BlueTooth headset so I'm reasonably confident that it's not the ROM.
re help
well I'm using a wizard with the cingular cf2 multi installer. the wizard is an imate kjam and hs850. after reading this thread u might want to try the settings for the mic agc. enable it and see. my problem is when ppl talk its low. I have to press the headset against my ear so I can hear them. as well as them hearing me. so we all in the boat. I will try the enable mic agc and report back.
cheerz
agc?
again
AGC? Anyone? Bueller?
AGC = Microphone Auto Gain Control.
It should be in the Settings under the System tab if your rom has it. Basically this only works with the built-in mic though and not wireless headsets.
No AGC doesn't help, but I suspect this is some issue to do with the level at which the Wizard uses echo cancellation. I think it is expecting a louder voice through the Bluetooth and as it doesn't hear a voice above the correct level, it barely transmits the audio.
I use the Jabra BT500 and if I take it off my ear and talk normally into the mic hole, callers can hear me really really well. It's just in the 'on-ear' position that it doesn't work.
*Update* I have received a replaced Xda Mini S, and tried it with its original v1.x ROM and the new v2.x ROM. Both have the same problem. So, I have tried:
Different Jabra headset
Different Xda Mini S
Different ROM
Changing all the registry settings as per the other thread
...all in different combinations
I therefore suspect it may simply be that the Wizard is incompatible with Jabra bluetooth headsets.
melvynadam, what headset are you using?
CJSnet said:
melvynadam, what headset are you using?
Click to expand...
Click to collapse
Motorola HS850. I used to have a Motorola phone and a Pa1m0ne Tungsten T3 but decided that I'd rather carry a single device. The HS850 worked wonderfully with the Motorola phone and I really miss having a BT headset.
Hi Friends,
I have an MDA pro with Qtek 9000 ROM (1.30.77 WWE). I would like to hear music over my BT headset (HBH-608). I found some hack is available. I tried with "vjvolubilis" but it doesn't work.
May be I missed something. Any idea about how to get it working?
Thanx and regards,
Ranju
...try these threads...
http://forum.xda-developers.com/viewtopic.php?p=340573
http://forum.xda-developers.com/viewtopic.php?p=340489
My HBH-608 has only handsfree profile. A2DP will not work for me. Actually I was looking for some hack (if already made by one of our friends) to send all the sound to handsfree.
I found one thing is that, audio goes to the handsfree (headset) everytime I start the "sdialer.exe". :idea:
But it's back to the internal speaker after the application is exited. I think this is matter of some registry hack.
Hi
I've just purchased HTC TyTN, when I talk to ppl over the bluetooth handsfree I can hear the opponent fine, but they cannot hear me. I have to SCREAM in the mic. This was also an issue on the HTC Prophet I had, but was fixed in HTC Universal and now TyTN has the same issue. I have read the same issue on the wizzard aswell, but no sollution there. And most the registery advices there I did not have in my registery at all.
Any help would be appreciated.
Hello. i have an omnia i900 and an stereo bt jabra8040. well my problem is that when someone calls me i have to shout to hear me. is there any way to fix that? i have tried also with ather bts but i had the same resaults. is there any registry hack? thanks!!