After connecting my tytn with a BT handsfree device, I'm not able to reconnect again; even the BT button in the comm manager has the yellow x on it and pressing it has no effect at all.
The only way to have the BT connection working is to restart my device.
I'm the only one experiencing this problem?
Forgot
My firmware is:
HTC English
QTEK_001
1.35.255.2 11/14/06
1.35.255.102
1.18.00.10
32.55.7018.01H
14955.2.3.0
2.3
1.09
solution
turn off device discovery
Related
when i first got my mda II it worked fine, but after an hour of so, after i turned it off, it wouldnt turn on again. after fiddling with it, i got it to turn on again by pressing the call button, then really quick after pressing the on button, but that only works sometimes. the only sure bet to turning it on again is a soft reset, which is VERY inconvenient... it anyone has any idea whats going on, PLEASE help me
thanks alot
Power on problem!! MDA II after upgrade to wm2003se
Hi,
I've got the same problem. I bought MDA II with wm2003. Fiew days after I installed wm2005 but it was unstable and many programs didn't working correctly so I downgraded it to wm2003se. Everything looks quite ok except the problem with power on with no activity (sometimes it srarts with power_on+red_call pressed at the same time but after that green led no blinking).
Now this is:
ROM version: 2.06.00WWE
ROM date: 06/14/04
Radio version: 1.18.00
Protocol version: 1337.38
ExtROM version: 1.72.165
Is there any idea to resolve this problem?
Best regards,
Slawek
i am currently having problems with the new rom, 1.12.00, after a soft reset, when i try to turn the bluetooth on, it shows a message that says i have to turn-off flight mode first. a few soft resets later, it will go back to normal.
how do you downgrade radio versions???
tnx for any reply
There is a new Radio 1.13 uploaded to ftp site. Read here....
http://forum.xda-developers.com/viewtopic.php?t=25465&highlight=
Active Sync can't either connect or when it does it fails after about 2 minutes. I can only connect via USB and can't with Bluetooth. I've set the phone up according to directions for BT but nothing.
I'm using....
ROM version 2.15.502.3
ROM date 04/09/07
Radio version 1.40.30.00
Is activesync failing after two minutes for both bluetooth and usb or just for bluetooth?
Hi,
GSM/3G module not work anymore (disabled phone icon and message of “No service”) and when i compose the number with the phonepad; i'm forced to soft reset my P3600 and often when the green shield of Windows Mobile 5 appears.
At the bootstrap, when is shown white page with the HTC logo, it appear written “the M 05”, “B 05”, “D 1,23”, and appear moreover written “R NONE” and “G NONE” instead of the indication of the module versions for the radio etc.
Still and many times over i have installed, always with positive outcome, also the shipped ROM with GPS enabled downloaded from the site of HTC Europe, but the result is the same: P3600 not work anymore and it is blocked also when i try to close the phone pressing the off button for some seconds.
What can i do? There is a hardware problem? I must send it in attendance as it is still in guarantee?
GPS Enabled
ROM version: 1.23.408.2 ITA
Radio version: 1.38.00.11
Extended ROM version: 1.23.408.103
Hello,
I am unable to connect with my TYTN to any wifi network, secured/unsecured. After turning wifi on (in comm manager), those lines near wifi icon (indicating that device is searching for wifi networks) appears just for 1sec, and then disappears. And that is all...
Please is there any known solution or is my wifi really dead?
My ROM: Schap's 4.31 (I already tried different ROM without any luck)
My Radio: 1.50.00.00
Thank for any answer...
Does your MAC address show ok? It may be worth having a look at this thread.
http://forum.xda-developers.com/showthread.php?t=322225
many thanks, but my TYTN is now bricketized :-(
downgrading to SPL 1.10 ok, but
while downgrading SPL (to 1.04), after message of succesfully flash on PC screen - PDA display turned off and my TYTN stops responding completely...
authorized service is my only last chance...
Sorry to hear it bricked. You could try this which has been recommended by another member before.
1.) Remove battery
2.) Connect Hermes to charger or USB
3.) Insert the battery while Hermes is connected to charger
4.) Red light should turn Amber
5.) Soft Reset
here
VC_48 said:
Hello,
I am unable to connect with my TYTN to any wifi network, secured/unsecured. After turning wifi on (in comm manager), those lines near wifi icon (indicating that device is searching for wifi networks) appears just for 1sec, and then disappears. And that is all...
Please is there any known solution or is my wifi really dead?
My ROM: Schap's 4.31 (I already tried different ROM without any luck)
My Radio: 1.50.00.00
Thank for any answer...
Click to expand...
Click to collapse
dont know if you already installed these ?
i hope it helps for you..
Pinguin666 said:
dont know if you already installed these ?
i hope it helps for you..
Click to expand...
Click to collapse
What does that .cab do?