Uni stucked on splashscreen - JASJAR, XDA Exec, MDA Pro General

My Universal is stucked on splashscreen, after every softreset.
Despite Pocket Plus installed, doesn't boot neither in standard or safe mode, as the dialog window, doesn't even came up.
Any idea to get rid of this without an hardreset (if it works also...)?
Even worst, the charging LED doesn't lit at this stage, and battery should be draining. So I've to hardreset very soon...

Related

Wizard Died? (Startup issue!) Please Help!

Hello dear XDA-dev members;
I had a problem this morning with my Wizard. I have a G3 device which i had downgraded to Button ROM for unlocking etc. It was working really fine until this morning. Last night i have turned off the phone radio (wireless and bluetooth was not enabled)and the battery was charged almost at %60.
This morning i woke up, i saw that he was entered in USB recovery mode itself. (the screen with red, green, blue, with my IPL 1.0 / SPL 1.0) , i was terrified because nobody touched my phone. Then i have pushed over power button, it shut-down. I've just waited a few minutes then i've just pushed again over power button, it started with my windows mobile 5 splash screen and showing my ipl/spl. the screen is really bright at this moment but fades out, when he started to fade out, he just shut-down itself.
I've read and searched over the forum, and though that it was my battery which was dead. I've plugged it with wall charger and waited almost one hour, and the charger led was red. I've tried to turn on, he just came on and go over my Today screen! and the charger led turned to green. Almost 45 seconds later the phone turned off itself. I've tried to re-start but it's same. I'm getting windows splash screen, and the screen brightness starts to fade out and the phones shuts down.
I've tested my battery with a volt-meter, i'm getting 4.86 volts. i have also checked power pins inside the phone, i'm also getting power there (4.6 volts) when it's connected with wall-charger, so i think that it's fine.
I have tried to hard reset, pushing communication + voice command button + soft reset button, i had the black screen, he said that it was ok, but same here. I was running with Button rom as i said before. (1.05)
Please help.
if you still can get into bootloader, it should be fine
It was entered into bootloader mode itself. When i'm trying to start it, the splash screen comes on, it shows WM5 and my IPL/SPL and 20 seconds after, it shut down. I really need help because it's my only phone that i own.
etron45 said:
It was entered into bootloader mode itself. When i'm trying to start it, the splash screen comes on, it shows WM5 and my IPL/SPL and 20 seconds after, it shut down. I really need help because it's my only phone that i own.
Click to expand...
Click to collapse
Have you had your phone more than a year? It may be the battery.
Replacement batteries cost only $5 on ebay or Amazon. Just get a battery so you can be sure that isn't the problem. In any event, you will probably need a new battery so you may as well try this.
joihan777 said:
Have you had your phone more than a year? It may be the battery.
Replacement batteries cost only $5 on ebay or Amazon. Just get a battery so you can be sure that isn't the problem. In any event, you will probably need a new battery so you may as well try this.
Click to expand...
Click to collapse
I've gone to buy a new battery, but it's the same thing. It just shuts-down irregullary at splash screen, or today screen.
Some faults in memory result in the device needing to soft reset in an attempt to reclaim memory. Perhaps you could try flashing to another rom. I dont own a g3 so I cant really advise you any further.
Mine not exactly like you but automatic bootloader or stuck at IPL screen. It was out of nowhere but thought a bad flash. When trying the hard reset, it would come as "failed".
Nearly threw phone thinking too old and dead but this came to rescue. http://forum.xda-developers.com/showthread.php?t=276963. If not tried, give it a shot.
WARNING: Use card reader to save your MINISD data's and if successful, first format card before reinserting.

Big Problem - after connecting USB or wall charger - switch off.

Reboot and RED LED. I know red means bad and i dont have any idea whats wrong.
The whole problem is described in the title.
Some details:
I switched my battery with my friend who has a prophet also. Problem remains the same. When i connect USB or wall charger device switches off and RED LED appears.
My battery charges on the other devices (friends prophet).
Is my dev bricked? Whats wrong ?
Im using ShadoW 1.0 (clean edition) ROM (WM6).
I know that the ROM in my dev is working because when i charge batter in other device and put it into mine - dev boots up and works normally.
(tryed also in boot loader mode - switches also off )
Question: what happens if you try to charge the device while it is off (completely off)?
There may be a problem with the USB driver in which case the device should still charge normally when it is off.
If that is the case try another ROM, or at least a hard reset.
Hard reset already. cant connect to any laptop with usb because every laptop will make the device switch off, even when i boot in RGB mode (boot loader) - thus cant change the rom :/
Hi. I've the same problem.
My prophet walking strangely.
1. When I plugged into a PC he does not want turns on. When he turns on, it for some time.
2. When it is in charge, the red light 3s, then sometimes it goes boot loader mode, once it does nothing else
3. Without battery it is the same.
same problem
any solution for your problem???

Bell Vogue keeps rebooting

Hi everyone,
I have had some trouble with my Vogue. At first it simply would not turn on. I would get a red light when I plugged the phone in to charge it. I have been using my old phone for several months now. Today I went out to the nearest Bell store and it seems like anything new is going to cost in the $500 area because I still have 1 year left on my contract. So I have renewed my interest in getting my Vogue working again
The original thread describing my original problem (with the red light) is here:
http://forum.xda-developers.com/showthread.php?t=546674
I purchased a new battery and now when I plug it in on the USB I can turn it on (no lights, red, green, or otherwise) but it does turn on. It boots up just passed the blue “Bell” splash screen and then reboots. It does this over and over again.
I am able to get into the boot loader screen by holding down the power and camera buttons and pressing the reset button.
Any ideas on what I can do? Any suggestions are welcome.
Regards,
The Fish
Reflash your rom when you get to the bootloader screen.
If you are unlocked flash nfsfan or whatever, just rename the nbh file to 'VOGUIMG.nbh' and it will flash.
If you were on stock you'll need the nbh from the stock package.
OK, here is an update
I have tried a hard-reset (press Send and End buttons at the same time and press reset button). This worked but the phone still kept rebooting. Tried the original battery, phone booted a little further up before rebooting.
I got the phone into boot loader mode and left it plugged in on the USB cable for a few minutes. This time when I rebooted I became ecstatic. I got all the way to the “align your screen” stage before hearing the “phone is dying” sound and the phone turned off. So here is what I think may have happened:
I have long lost the home charger kit. So I have, for as long as I can remember, been charging it by plugging it into a PC via the USB. This is fine except that Windows will only power the USB for the device if there is a driver installed. The device/phone looks different to Windows when it is in boot loader mode then when it is fully booted up. If the device is so dead as to not even have a flicker of life I don't think Windows sees it.
I have been doing this tonight under Linux. Linux seems to either have the driver, a more generic driver or powers the USB all the time for any device. I noticed this same behavior when charging my Moto Razr the same way. Under Linux it just worked by plugging it in. Under Widows I had to install the driver. So maybe here is what happened.
The battery got SO dead that it was not able to boot the phone up far enough for Windows on the PC to see it, recognize it and begin powering the USB port. Perhaps leaving the phone in bootloader mode and plugged into a Linux box got the battery a little more charged till I got to the point of being able to align the screen.
Anyway, I am more then ever convinced that this is some kind of battery/power issue. The phone is now lying here powered up and charging (already at 20%). The carrier customizations ran, rebooted while I crossed my fingers, and came back up. I even called *BELL and got a message about activating my phone. Tomorrow if the phone is charged up and behaving normally I will get an ESN change done and be back in the world of decent smartphones. Man have I ever missed my Google Maps
The next step is to flash a more up-to-date ROM... if I dare mess with a good thing.
The Fish

[Q]Bootloop and Battery not charging

Hi, so my phone decided to stop working all of a sudden.
I was just doing things on my pc when I heard my phone rebooting, after I had recenly plugged it in.
It's running the latest stock ROM and not rooted. When I try switch it on it shows the Samsung Logo and on some occations some pixels create a fuzzy area underneath the logo text and at the bottom of the screen, it then switches off and after a while tries to boot again. When I try charge the phone it goes to the battery icon with the loading circle but nothing moves and yet again some of the pixles of the battery icon become distorted and then it switches off and tries again(also it vibrates twice before showing the battery icon). I can boot into Dowload mode and my PC recognises the phone(as well as odin) but I can't boot into recovery, or Safe Mode for that matter. I can remove the battery when in dowload mode and the phone remains on but I need the battery inserted to start up anything. I've only had my phone for two months now. Maybe I could be moisture from my shower earlier, I'll leave my phone in a bowl of rice overnight to see if that does anything.
Please try help me fix my problem. I've been looking for a solution all night.
Also due to me being overseas I can't format my phone as I'll lose my WhatsApp validation and all the pictures I've taken so far will be lost.
Thanks in advance.
It's not a software problem so you don't need to format.
My guess would be that you need a new battery.
Lennyz1988 said:
It's not a software problem so you don't need to format.
My guess would be that you need a new battery.
Click to expand...
Click to collapse
The battery isn't even swollen though?
I just tried starting up the phone by turning it on, then plugging in the cable and hitting the battery out but it still didn't boot.
Unfortunately I'm far away from a big city so I can't get another battery to test it to be absolutely sure though.
Update:
I just tried booting it again and it got to the other Samsung screen where the LED is Blue and the Logo flashes blue behind it(Only got here once, hasn't gotten this far again yet). I left it for a bit but it just got stuck there and there was the same distorted pixels like in any other type of screen I get to also the logo stopped flashing when I tapped the screen and pressed the home button(this is when the distorted pictures started again).
Here is an attached Image of the flickering part of the screen. It gets stuck on this screen and flickers at the bottom and just underneath the Logo and eventually turns off.
No one know the problem?
BaD_RoBoTs said:
No one know the problem?
Click to expand...
Click to collapse
It's a hardware failure. Let's hope it's your battery even though it's not swollen.
Lennyz1988 said:
It's a hardware failure. Let's hope it's your battery even though it's not swollen.
Click to expand...
Click to collapse
I tried a new battery today and it had exactly the same problems
So by some miracle it booted all the way to the lock screen and then rebooted from there right back to the lock screen again and I unlocked it and the home screen was fine and the phone seemed to function for a few seconds then it restarted and then got stuck at the Samsung logo again, I did manage to see that there was 17% Battery left so It has enough power to boot it. So I dunno what the hell could be causing it. It's such a weird problem I have no idea of how to fix it(within the warranty that is). I forgot to mention that the screen has 3 stress fracture cracks on the screen so somehow I think it is bending in my pocket, so that might be a reason why it's acting so weirdly.
I also noticed that if I leave the battery out for a decent amount of time and try boot the phone up it boots up for about 20 seconds and then reboots again into a bootloop again. Also the battery percentage is at 0% apon boot, by this stage I've plugged it into my PC to try pull files off of it(Which I managed to get some files off).

Lumia 950 Not Working

Hello Everybody.
I Need some help with my Lumia 950, it's in Boot Loop, Going to Windows Logo and Restarting.
I Already used many ways to factory reset or flash the device, using WDRT, WPinternals, Windows Phone Image Designer, thor2.exe and more.
All the times the flashing process goes well and it finishes the process showing a green screen after the flashing and starting the boot process, going to Microsoft logo, windows logo, windows logo again and just after, the screen goes black and the phone vibrates and restart.
I Really need some help, it's happens when i was recharging the phone at my workstation, it was with 8% battery, so i put the charger (from Sony Brand) and when i came back to check my phone, it was in boot loop.
My phone are really hot, sometimes the screen, battery and the enclosure are really hot, many more than other phones charging.
I already bought a new battery and checked with a multimeter the voltage of the old and the new battery.
So... i'm stuck... i really don't know how to solve this problem... I don't access to a official maintenance center at my country (Brazil), and the parts for this phone are almost impossible to get here (from official ways)...
So. Anyone knows how to solve this ? or passed by the same problem ?
Thanks

Categories

Resources