I picked this head unit up and it works well when it works. It will work fine one day and then the next time I get in the truck it won't power on. I've found that if I pull the unit out, unplug the wiring harness and plug it back in it comes back to life. Last time I did this it hard reset and I lost all customization. I had the accessory turned on setting it back up. Turned the acc off, started the truck and it's dead again. Anyone have an idea why? Cheap Chinese torture device? Thanks!
Related
HelloAll,
Ive had my new head unit installed for two days now, and been through all the settings etc checked all the leads and cant see anything wrong, but have had to put my car battery on charge twice now.
It seems the head unit drains the battery when I turn the car ignition off.
Also I have an airbag fault, but I thought this was just due to me unpluging the passenger side airbag warning light when I was fitting the unit.
its a Erisin ES3015V 8" VW Android 5.1
The only thing I left unpluged was the old GPS antenna as not needed (would this cause a drain if touching something, forgot to tape it up)
Also due to the instructions being in pigeon english can any one advise how I should set the dip switches on the back.
see pics attached.
Many kind regards
Guy
HAGster1969 said:
HelloAll,
Ive had my new head unit installed for two days now, and been through all the settings etc checked all the leads and cant see anything wrong, but have had to put my car battery on charge twice now.
It seems the head unit drains the battery when I turn the car ignition off.
Also I have an airbag fault, but I thought this was just due to me unpluging the passenger side airbag warning light when I was fitting the unit.
its a Erisin ES3015V 8" VW Android 5.1
The only thing I left unpluged was the old GPS antenna as not needed (would this cause a drain if touching something, forgot to tape it up)
Also due to the instructions being in pigeon english can any one advise how I should set the dip switches on the back.
see pics attached.
Many kind regards
Guy
Click to expand...
Click to collapse
You may have swapped B+ and ACC. Normally B+ is yellow and carries +12 continuously. While ACC is normally red and should only carry +12 when your key is in ACC or further.
Concerning Airbag-light. Some cars need an airbag-light reset through the OBD-bus or manufacturer-bus. Sometimes it's good enough to disconnect the battery for some hours to clear various lights. I doubt that in your case since your battery been drained already. Maybe not low enough to clear the OB-computer.
thank you for the reply.
I might have sorted the power drain, flipping dip switch no 3 to off has now enabled the unit to shut down fully when the keys are removed from ignition, and now the standby option works so i can takekeys out and then have unit in instant on mode for 30 secs, 2 mins up to 2 hours etc before it completly shuts down.
I was thinking the light just needs a reset ill go see my friend who has a vag box to reset the light
Thank You
Similar problem
Hello,
Sorry to bring this back up...
I have a similar situation, but my unit Eonon GA6157f is installed in an Audi a3 with a BOSE unit.
h t t p ://www.eonon.com/Android-Car-GPS/Vehicle-Specific-GPS/GA6157F.html?Catype=1
(remove spaces)
The above solution did not work...
Does anyone else have any ideas of how to solve this?
I get a dead battery after 24 to 36 hours
thanks
Hello.
I have same problem with Audi A3 with Bose. Any solution?
I installed one of these units in my Alfa 147 yesterday and am having a problem where it will boot from completely off most of the time. Occasionally it will boot from standby in around 3 seconds, but most of the time i have to sit through the entire boot from cold sequence.
I definitely have my ignition and constant wires the right way around, and I don't think it's a battery issue. I tested the voltage of the constant 12V and it only dipped to 10 or 11V when starting the engine. The problem also arises when just turning the key to the second position which rules out the starter motor bringing the voltage too low.
Any suggestions on how to fix this would be much appreciated.
Side note: the surround/bezel which came with the cage (from xtrons) doesn't fit over the head unit. Anyone else have this problem? It's pretty ugly having the cage exposed.
I have the same unit and I just installed it. I tried connecting by either switching A4 and A7 (my car is Peugeot 107 and this is how it should be, similar to your Alfa I believe), and without switching them, and it's the same. Also, I set the timeout on powering off when ACC is off to 10 minutes, but my head unit turns off immediately.
I've since figured out that in my case i was just expecting too much of it. I thought that it would stay in standby indefinitely as long as it had a power source. Turns out it will only stay in standby for as long as you set the ACC off timeout for, which is 1 hour maximum. I think this must be because it consumes too much power even in standby and would drain your car battery over night.
The way mine behaves now is that if i turn the ignition off it will go in to standby for one hour. During this hour it will turn back on within a couple of seconds when the ignition is turned back on. After that hour, it will need to boot from cold. This isn't actually too bad as it usually takes less than 10 seconds for a cold boot.
My main gripe with this unit now is how much the screen is recessed behind the bezel. Due to the angle it's at in my car this means that the bezel obstructs half of the notification bar when i'm sat in my natural driving position.
Actually, it turns out it works OK for me as well. I dropped the adapter that switches A4 and A7, and it works fine. It has it's flaws (today being a really sunny day, I wished display was a bit brighter), but it's a nice upgrade on my 2008 car stereo.
I know what you mean about the brightness. It's just about usable on a bright day though so not a deal breaker.
I can recommend the DVR019 dash cam if you don't have one by the way. Super cheap and easy to install - just requires USB connection to the head unit.
Let me know if you figure out anything useful about this unit.
Are you guys happy with the sound quality? I am looking into buying same unit.
Did you buy any special harness to connect to the car?
Set timeout to autosleep instead of timed, that way it'll always boot in seconds, mine starts instantly even two days later
Sent from my SM-G960F using Tapatalk
Mr.R™ said:
Set timeout to autosleep instead of timed, that way it'll always boot in seconds, mine starts instantly even two days later
Sent from my SM-G960F using Tapatalk
Click to expand...
Click to collapse
Can you explain how to do that? I only have the option for 10 minutes, 30 minutes and 1 hr and it doesn't work on any
Xtrons Androind installing
Hi!
Did you get any answer or solutions to this, after all..? I have the same problem, and originally installed the car navigator to get powered from the ACC cable.
I didnt try this yet, but i bet to use the 10min / 30min / 1 hour switch off, the navigator should be wired to the yellow 12V cable to get continuos electricity, and not to the ACC cable, what gives eletricity ONLY when you turn on the car..
Of course without the turn off timer, it would drane out the whole battery.. I think 30min delay would be pretty cool, the time to go for examle to a store and come back, and find the android system still fast and rdy to go..
Hi guys
I wanted to upgrade the user interface on my Android head unit. ( Carsara, Android 8,1,)
Started upgrading via USB, the update went thru and i thought it was finish. So I turned off the car to restart it. I started the car, but the screen was completely black. Nothing is working
Later I find out that i should have waited 15-20 minutes for the update to reboot, something i didn’t do. In other words, I turned off the power before it was finished with the reboot. And now it’s dead
Any suggestions so I can get it back to life? Or is it a lost case?
I’ve got a px5 unit using Hal9k android 8 and fcc launched and the last couple of weeks the unit has been restarting from cold every time I start the car even though I have the unit in sleep mode so it should wake up straight away.
Today my other half has messaged me to say the car isn’t starting so I’m assuming the battery is dead.
Does anyone think the behaviour of the android unit sounds like it’s draining the battery? Up until the last couple of weeks the unit worked fine and just woke from sleep every time I used the car.
I checked the cables behind the unit at the quadlock connector and everything and it all looked fine but my gut feeling is telling me the android unit is causing a drain.
Hi
I'm hoping someone can help me out. I have the above head unit in my car, and it works pretty well. But it boots from cold all the time. There is an inbuilt option where I can choose standby for 5, 10, 20, 30 and 60 minutes, which means if I return to my car within that time chosen my head unit comes on immediately, but it's maxed out at 60 mins, all other times it cold boots, and takes an age.
My last head unit in a different car did the same thing, found the remedy in switching the red and yellow wires. Worked perfectly. Tried that remedy with this head unit and it actually made it worse. Is still booting from cold, but now setting the standby time doesn't work at all. I can't take it back to the garage unitl next week..
So, Has anyone had any luck forcing it to go into standby? (I read someone had connected the red and yellow from the head unit to the red from the car. Not sure what this will do)
Thanks
T