Phone doesn't boot anymore - Galaxy Note 3 Q&A, Help & Troubleshooting

Hi,
I have bought a second life Samsung Note 3 ( SM-N9005 ) here in the Netherlands.
I was so tempted to install a custom ROM, that I immediately installed TWRP with Odin v3.09. It took me several times to install TWRP 3.3.0-0, as the phone returned with its own T-mobile logo. (I had forgotten to set the developers options before doing something.)
Then I tried to install lineage-16.0-20190907-nighty-hlte-signed.zip file via TWRP. It fails with an error 7.
and: E3004: This package is for device: hlte, hltespr, hltexx; this device is hltechn.
(does this means there is a (replaced) main-board in this phone?)
I have updated the modem and bootloader files via Odin, selected BL with the file N9005_Nordic_XXUGPQB1-Modem_XXSGBQD1-Bootloader.tar. But I can't see if this has succeeded or not. TWPR doesn't see this file on my SD card, so I used Odin.
Is there a way to get around this and install LineageOS 16.0 on this phone?
It shows only the booting logo SM-N9005, but then it 'hangs'.

TMobile are you sure its an N9005 .
Boot to download mode to check .

There is a placard under the battery, stating: model SM-N9005 SSN: -N9005GSMH
in download mode:
Odin mode
product name: SM-N9005
current binary: Custom
system status: Custom
reactivation lock: Off
qualcomm secureboot: enable (CSB)
RP swrev: S2, T2, R2, A3, P3
secure download: enable
udc start

TWRP should not see your tar file only Odin .

I was able to install TWRP. When I boot in recovery mode, TWRP starts fine.
When I try to install LineageOS zip file and trying to install LineageOS, it fails with an error 7.
This package is for device: hlte, hltespr, hltexx; this device is hltechn.
How can a phone, that shows to be an EU model sm-n9005, coming up with a message it is a hltechn, in TWRP?

I have spent enough time and money on this phone. -- Project cancelled --
Lucky the phone came with a nearly new, Samsung cover.
So my own original Note 3 with Lollipop, looks as new again.

Related

strange behaviour of Galaxy Note 4

I bought a Note 4 with Android 6.0.1. I do not know if the phone is rooted. The seller told me that it has a problem: sometimes when you turn on the phone it starts normally, everything works, it charges normally, but sometimes it starts with a black screen with the Android robot and a message like ”could not do normal reboot” and sometimes does not start at all. I have to take off the battery, wait few minutes, put the battery back, wait 5-10 minutes and then the phone opens normally again. It is a little strange.
I want to install clean Android 4.4.4 without any rooting or custom ROM. Just the original Android 4.4.4. I found the file on samsung-updates.com, but I am a little afraid of doing just a simple resoft with Odin, because I do not know what will happen next. What do you suggest?
Thank you for any help!
You can flash the 4.4.4 ROM without root via Odin all fine, but as you are on MM already, you will be needing to be a full wipe, and stock recovery can't do full wipe, it can wipe fine, but not everything, so for that you need to flash TWRP recovery. Then in TWRP's advanced wipe section select everything and do the wipe. Turn off the phone, turn it back on in download mode and flash the desired 4.4.4 ROM. Don't know why you are hesitant to root anyway!
So it will be no risk, even if the phone is rooted now?
And when that robot appears, the following text is displayed:
Could not do normal boot.
ddi : mmc_read failed
ODIN MODE (HIGH SPEED)
PRODUCT NAME: SM-N910F
CURRENT BINARY: Samsung Official
SYSTEM STATUS: Custom
REACTIVATION LOCK: OFF
KNOX WARRANTY VOID: 0x0
QUALCOMM SECUREBOOT: ENABLE (CSB)
AP SWREV: S1, T1, R1, A1, P1
SECURE DOWNLOAD : ENABLE
UDC START
How can I repair the phone?

Galaxy A7 SM-A700F - No boot after Flash

Good evening!
This is my first post and I would get a fix on my device, if is possible.
I found every kind of tutorial to flash this device.
I used differents version of Odin with no success
My device is:
Samsung Galaxy A7 SM-A700F
In ODIN MODE appear those details:
CURRENT BINARY: Samsung Official
SYSTEM STATUS: Custom
REACTIVATION LOCK: OFF
Secure Download: Enabled
KNOX WARRANTY VOID: 1
RP SWREP: 2
I tried to put into this device Android 4.4 (original rom) and the last one.
I can access only on Download Mode, but not in Recovery Mode... I would make a wipecache, or reset nand, but I can't get into Recovery Mode.
I bought online as not working phone, so I don't know what can I do on it.... Could be bricked?

Needing help - Stuck in Odin

Hi all,
Please bear with me, I'm in way over my head here and don't understand most of what I've done. I was experimenting when I probably shouldn't have been.
So, I installed DarkLord's Note 7 kernel and rom. I found it to be quite buggy and am now wanting to wipe my phone and install Phronesis-N9005-N7-v6.0.
Problem is, when trying to boot into TWRP, I'm met with the the following:
ODIN MODE
Product name: SM-N9005
Current binary: Custom
System status: Official
Reactivation lock(kk): Off
Knox Kernel lock: 0x0
Knox warranty void: 0x1
Qualcomm secureboot: Enable (csb)
Rp swrev: S2, T2, R2, A3, P3
Write protection: Enable
UDC start
Downloading...
Do not turn off target
I've had it on for hours and it didn't do anything.
I managed to reboot it and it ran as it did before, in Darklords rom.
I read I have to install the official firmware and install it via Odin but I can't find anything about my device. On the back of it, it says:
SM N9005
FCC ID - A3LSMN9005
SNN - N9005GSMH
When I enter it into sammobile, nothing comes up.
Have I got this wrong? Should I be looking for something else?
You are booting to download mode not recovery .
Boot to recovery TWRP
#N9005 model firmware are on sammobile etc.
https://forum.xda-developers.com/galaxy-note-3/general/samsung-galaxy-note-3-sticky-roll-t3237249
Booting into recovery via TWRP manager just results in the same Odin screen for me
As for the firmware - I'm not really sure which region I should pick out of those. I just thought this was an international model, but then I downloaded an app called Phone INFO and it tells me it's Vietnam. Could this be because of the rom already on there? It does also say it's a Note 7, so I'm assuming it's incorrect.
TWRP manager
DO NOT USE just boot to recovery via the vol up home and power buttons as normal .
Copy Phronesis to ext sd card and flash as per instructions .
You have N9005 Pick your area /network where you are .
Phone Info can only go by what's on your phone and you flashed DarkLord's Note 7 firmware .
Booting via manager was a last resort. I was trying the usual way and it also resulting in the same thing.
Boot to download/ Odin mode flash stock rom .
Thanks JJEgan, I figured out how to use Odin3 and Odin mode, then install Phronesis. All is good now

Frustrated - Can not unbrick!

Have been using a S5 for several years which I unlocked bootloader and rooted at the beginning. Been running a NI2 firmware with no problems. Decided I wanted to try a Lineage rom and when I tried to flash it, it failed. I wanted to update to later android so I flash a Stock firmware through ODIN and it work fine for several days. For reasons unknown to me I went into recovery again and did a factory reset. Now when I turned on phone this is all I get and it will no longer let me boot into recovery mode. No matter what key combination I push, I just get the following screen:
ODIN MODE
PRODUCT NAME: SM-G900V
CURRENT BINARY: Samsung Official
SYSTEM STATUS: Official
REACTIVATION LOCK: OFF
QUALCOMM SECUREBOOT: ENABLE (CSB)
AP SWREV: S1, T2, A1, A2, P1
SECURE DOWNLOAD: ENABLE
UDC START
Software Update Failed
etc etc etc
Tried flashing different firmware in ODIN (3.09 and 3.10) and still boot into same
screen with following line added:
SW REV CHECK FAIL : [aboot] Fused 2 > Binary 1
Have tried Samsung Switch, Kies and Verizon Software Update to no avail. Have uninstalled drivers and reinstalled several times. Also ADB does not recognize phone.
At wits end - any suggestions appreciated!
kd3yt said:
Have been using a S5 for several years which I unlocked bootloader and rooted at the beginning. Been running a NI2 firmware with no problems. Decided I wanted to try a Lineage rom and when I tried to flash it, it failed. I wanted to update to later android so I flash a Stock firmware through ODIN and it work fine for several days. For reasons unknown to me I went into recovery again and did a factory reset. Now when I turned on phone this is all I get and it will no longer let me boot into recovery mode. No matter what key combination I push, I just get the following screen:
ODIN MODE
PRODUCT NAME: SM-G900V
CURRENT BINARY: Samsung Official
SYSTEM STATUS: Official
REACTIVATION LOCK: OFF
QUALCOMM SECUREBOOT: ENABLE (CSB)
AP SWREV: S1, T2, A1, A2, P1
SECURE DOWNLOAD: ENABLE
UDC START
Software Update Failed
etc etc etc
Tried flashing different firmware in ODIN (3.09 and 3.10) and still boot into same
screen with following line added:
SW REV CHECK FAIL : [aboot] Fused 2 > Binary 1
Have tried Samsung Switch, Kies and Verizon Software Update to no avail. Have uninstalled drivers and reinstalled several times. Also ADB does not recognize phone.
At wits end - any suggestions appreciated!
Click to expand...
Click to collapse
You need to install using odin the last update avaliable for G900V. The last update is QF2. Download from updato and flash it..
Tried flashing QF2 and Odin failed again. I did manage to pick up a new in the box S5 and it arrived today. Works great and it is on 6.0.1 DPF4.
Just wanted everyone to know that the phone is now working!! Had not done anything to the phone since last post. Yesterday took it downstairs to an old computer running XP. When I turned the phone one got a surprise, it booted to the Verizon splash screen and stuck there. Installed ODIN on the computer, was able to put phone in download mode and then ODIN worked and was able to flash the DQH2 rom and phone works great. I now have a back up phone!
kd3yt said:
Just wanted everyone to know that the phone is now working!! Had not done anything to the phone since last post. Yesterday took it downstairs to an old computer running XP. When I turned the phone one got a surprise, it booted to the Verizon splash screen and stuck there. Installed ODIN on the computer, was able to put phone in download mode and then ODIN worked and was able to flash the DQH2 rom and phone works great. I now have a back up phone!
Click to expand...
Click to collapse
glad to hear it all worked out! I was in a very similar situation for the past week (S3 to the rescue), but using the latest Odin and the latest update for my VZW S5, I'm back on the S5. Now to search for regaining root....
RA

Little help.?

before begin, im sorry for my bad english. now i had a big problem so far and make me crazy some times.
i have note 3 (ha3g) with TWRP 3.1.1-0 installed but not rooted yet. i have been istalled any Custom rom but stuck on boot, all of it! i trying SD version still same problems. if you have an idea please help me..
If you are on KitKat
First flash lollipop bootloader
I have root my note 3 ( hltexx , Qualcomm adreno 330) with Odin but I have problem to install TWRP, I try couple time and when I go to recovery I get message:
Fail to normal boot to recovery
Odin mode error
Downloading mode..
Now , I have a question: I try to install recovery with Odin and have no luck , try with Oficial TWRP app from Play store and it's the same problem..
Can I use Rom Manager from Play Store to download and install Rom without TWRP?
And why I can't install and have problem with Recovery?
@jjoeshua, what is the model # of the phone in download mode?
This is what I get when I try to go to Recovery:
Could not do normal boot
ODIN MODE
product name: sm-n9005
Current binary:custom
System status:custom
Reactivation lockff
Knox warranty void: 0x1 (4)
Qualcomm secureboot:enable (csb)
RPswrev:s2 , t2 , r2 , a3, p3
Secure download: enable
Udc start
Downloading. ....
Do not turn off target!!
This is my model number and firmware :
What Twrp to download?
Hltexx
Hlte
Ht3g
Twrp for now 3: https://twrp.me/samsung/samsunggalaxynote3qualcomm.html

Categories

Resources