Hi Everyone!
I've recently installed a Chinese (Funrover) Android HU into my 7th gen Honda Accord. For the first few weeks everything worked fine. Then I tried to install the rearview camera that came with the HU. On the first try before putting the camera to it's final place I tested it and it worked fine. After I put it in it's actual place and tried again, it didn't work. The camera lights up, so power is fine but the HU doesn't switch to the camera's feed.
Next day I had some issues with the HU - the sound just went away. This still happens randomly.
And now recently the HU started turning off randomly, sometimes it doesn't even start up when I start the car. It does work sometimes though. Also it sometimes tries to power on en-route, but usually fails and goes blank again in a few seconds. I noticed that this usually happens when I'm braking and also at the same time the car's original built-in bluetooth unit (which I've never used so I'm not sure how it works) would flash it's leds as if it's getting power from the same source.
Does anyone have any ideas what to check / how to fix this?
Thanks in advance
(let me know if you need any more details)
Related
Hello ,
I bought this head unit to fit into my Audi A3, bought the fitting cage and wiring harness for the amplified rear Audio. Connected it up and it’s was all fine besides some questionable sound quality and then the next time I switched it on I was met with a blank screen. It’ll beep when I reconnect the power but that’s about it.
I was advised to load the boot menu by holding reset and power for 5 seconds then releasing reset followed by power which gave me three beeps but no boot menu! I also tried disconnecting my car battery to reset everything but it made no difference, it still won’t boot back up.
Has anyone come across this before? Is this an issue with the unit or could it not be getting the power it needs? I’m in desperate need of some help, any advice at all would be a massive help!
Thanks!
Darren
Hi,
I've bought a new Head Unit, and I wired everything on the car.
It's working like a charm, but, there a big but.
The Head Unit which should go to sleep / deep sleep or whatever when I remove my car key after 30 seconds, stays on.
For the time being I've unpluger the ACC cable (the red wire) so that the Head Unit only receives power when the car key is plugged in.
Do you know why am I facing this Issue and how to resolve it ? I had hope to enjoy a fast boot and not a full boot everytime I use my car.. it would be nice
I have another question also, if you know about it, I'm trying to get the light buttons always on, because they're not very visible to me. Si I went to the special menu (with the 126 code) and tried changing the parameter "Power LED control" to "By Power" instead of "By head light" but they still won't turn on unless head light is on. Am I missing something ?
I'm not sure what head unit you have but a) what is your amp wire from the head unit connected to? B) there's is usually an illumination wire, what is that connected to?
Sent from my SM-G950U using Tapatalk
Also do not know what head unit you have but it sounds like it is not wired up correctly.
If you dont get much help on these forums maybe go visit an auto electrician as they should be able to advise further.
Hi I have an android head unit for my car that I have managed to mess up by putting Spotify into the auto start slot (was navi) as I thought it would be good to come on at the start. The problem I now have is that is has the volume of the sat nav which goes down to 3 and then off. I've tried pressing the reset button on the front of the unit (nothing changed) and also uninstalling Spotify/Navi/maps and it's still the same ???
Is there a way to factory reset these head units?
Thanx for any help I receive ?
Hi,
I've been looking for support for a chinese headunit MCX-1705AD without luck. This unit was working fine for 3 weeks, bluetooth, radio, reverse camera was all working fine and now all the apps either open and then close or become unresponsive. I have tried to access infotainment from settings to reset it from there but the screen closes like the other apps. I have also soft reset the device from the front panel which does not do anything. I assume I need a firmware upgrade and I have tried contacting the seller who are useless. I hope someone on here han help me.
yasin187 said:
Hi,
I've been looking for support for a chinese headunit MCX-1705AD without luck. This unit was working fine for 3 weeks, bluetooth, radio, reverse camera was all working fine and now all the apps either open and then close or become unresponsive. I have tried to access infotainment from settings to reset it from there but the screen closes like the other apps. I have also soft reset the device from the front panel which does not do anything. I assume I need a firmware upgrade and I have tried contacting the seller who are useless. I hope someone on here han help me.
Click to expand...
Click to collapse
I have the same model and problems as you. I already solved the problems and the head unit is working normal now.
1. Turn off the player by turn car key to off position.
2. Frequently touch the screen with 5 fingers at the same time turn on the player by your car key to on position.
3. On your screen conner will show detected and the player go to recovery mode you have to wait for a few minutes until the system reboot.
Hello all,
I have a TS10 4G/32G 9Inch Model installed at a Hyundai.
The unit randomly doesnt start, and have different behaviours.
1. Screen lits, but no image, Guess the unit starts in background, since Radio comes up, and you can ear music, and Carplay also works, because if A call comes in you can accept call from the buttons at the wheel, and sound works normally. But no Image can be seen.
2. Unit Lits, Hyundai Logo appear, and unit freezes there, Waited quite long, and doesnt go further from Logo Screen.
3. Starts quite fast, probably from sleep mode and works fine
4. Starts to Hyundai boot logo, takes maybe 20 or 30 sec (Booting?), and then works fine.
Sometimes you start the car, and it starts, you stop and start again and problem happens.
If problem is occuring, if you press the reset button, sometimes it comes up, other times it take 10 resets before it starts.
Dont know if this issue has been addressed here, if it was im sorry to duplicate, I looked and couldnt find.
Hope someone can help me.
Thank you.