From yesterday (18/07/2019), my OP5 have started facing issue.
First when i tried to charge my phone , LED was showing red but the battery was not charging. Then i restarted my phone. So it was charging but slow charging (still red LED).
did some google research and finally cleared device cache memory through recovery.
I rebooted and plugged my charger. First it showed red (slow) , then after few minutes it showed blue led (DASH).
I thgt problem is solved.
Today morning again kept for charging and now it is slowing red LED. if i press the plug into port storngly after few minutes it becomes blue.
Im not able to understand whether its hardware or software issue.
Please guuide
boyz211 said:
From yesterday (18/07/2019), my OP5 have started facing issue.
First when i tried to charge my phone , LED was showing red but the battery was not charging. Then i restarted my phone. So it was charging but slow charging (still red LED).
did some google research and finally cleared device cache memory through recovery.
I rebooted and plugged my charger. First it showed red (slow) , then after few minutes it showed blue led (DASH).
I thgt problem is solved.
Today morning again kept for charging and now it is slowing red LED. if i press the plug into port storngly after few minutes it becomes blue.
Im not able to understand whether its hardware or software issue.
Please guuide
Click to expand...
Click to collapse
To check if it's a hardware issue you should exchange your dash charger and the original dash charge cable if possible or clean all the pins and check if they're damaged.
Related
Has anyone else noticed when you plug in the Phone to be recharged, occasionally the 'red' indicator does not come on or disappears?
It's now happened to me several times ~ I plug the Phone in for a recharge, initially the red light comes on then after a few seconds it goes out leaving no indication if it's charging or when it's complete.
Beards
Read this that i posted several days ago and check your charger
http://forum.xda-developers.com/showthread.php?t=446583&highlight=power+supply
"Wiggle" the charger around and see if the charge light goes on and off!
Beards said:
Has anyone else noticed when you plug in the Phone to be recharged, occasionally the 'red' indicator does not come on or disappears?
It's now happened to me several times ~ I plug the Phone in for a recharge, initially the red light comes on then after a few seconds it goes out leaving no indication if it's charging or when it's complete.
Beards
Click to expand...
Click to collapse
Could it due to bad physical connection?
No guys.
I'Ve cheched all connections.
Besides, if I leave it plugged in whilst there is no light showing and switch off the Phone the red charging light then comes on.
Beards
Well this is now really starting to bug me.
I've carried out a Hard Reset thinking something was interferring with the charge light procedure but even on a default machine with the device running the red light simply does not come on.
Swith the Phone off, then connect and the red light appears.
So.... when my machine is running I don't get the indicator (but it is charging I know because after leaving it for 30mins I've checked and sure enough it's charging).
Any other ideas???
My Trinity does this when overheating, it stops charging and blinks the LED. Unplug for 10 minutes and replug.
tnyynt said:
My Trinity does this when overheating, it stops charging and blinks the LED. Unplug for 10 minutes and replug.
Click to expand...
Click to collapse
Now that's an answer I was not expecting...... Thanks tnyynt, I'll give that a go on my next charge cycle.
Edited:
No... that didn't work.... but thanks all the same.
I have now resigned myself to the fact if I want to see the red charging light the only way is to first power down the Phone, then connect to the mains electric and then the red charge light comes on.
If I want I can then switch the Phone back on again whilst charging until the green charged light shows.
Beards
Hey guys, I have a Optimus San Francisco (Portuguese version of the ZTE Blade) and I've been having some serious problems with its battery.
Ever since I rooted it and flashed some custom ROMs, I have never been able to properly calibrate the battery. No matter if I use the Battery Calibration app or Clockwork Mod, the phone will simply NOT charge the battery to 100%. It will stop at 66% or some other random number. In the (very) rare occasions that I did get it up to 100%, the issues remained.
No matter what I try, the problem persists. I bought a new battery from ebay (just arrived, today) and, to eliminate any possible source, flashed a new ROM (I started on SS RLS5, went to CM7.1 Beta, CM7 Stable, and am now on GLS beta 22).
Just like an hour ago or something I flashed GLS beta 22, wiped user and cache partitions and wiped battery stats. I put the new battery in (was about empty), it booted and was at 1%. I connected it to the charger (remember, no batterystats.bin) and it didn't go past 1%. Then, it powered off. Right now it's supposedly charging while powered off, with the red LED.
Any ideas? Seriously, I haven't been able to use this phone on day-to-day basis for MONTHS.
Might be that your hw is faulty. Is the led working? The led should change from red to green when the charge is over 90%.
Here are the battery calibration steps you could still try:
1.Connect the phone to the charger with the phone powered on, and allow the phone to charge until the notification LED is green, indicating the device is fully charged.
2.Disconnect the phone from the charger, and power it off.
3.Reconnect the phone to the charger with the phone powered off, and allow the phone to charge until the notification LED is green.
4.Disconnect the phone from the charger and power it on.
5.Once the phone is powered completely on, power it off again and reconnect it to the charger until the notification LED is green.
6.Disconnect the phone, power it on in clockwork recovery, and wipe batt stats. You need to use this sequence only once.
Yes, while tinkering with this new ROM I tried a "LED test" and the LED did flash red and green.
I've seen those instructions and the problem is, the battery percentage gets stuck at a certain level and will not get past that. So, the LED is always red.
Apparently I solved the problem by using another USB cable and my set top box's USB. Looks like the problem was in ZTE's charger.
Hello
My battery sucked, like going from 100 to 20 in 10secs so i asked for a new one from huawei greece. They sent me a new battery and when i put it into the phone and tried to boot it phone didn't boot. I thought it was because the battery was empty and when i connected it to charge first the light was blinking red and then phone boot up to the battery screen. 15min later i realised the phone was boot up and the red light was blinking red and not like staying red which is the light when you charge it with no battery. the percetange was 0%. i left it there for a little bit but nothing happend. then i tried to turn it off while it was connecting to the charger but that just boot up again with the same red blinking light and 0% percentage. I'm on aurora sp on top of aurora v20. When i try the old battery everything is working ok like it charges and everythinh. Could someone help me out?
Strange
Try this connect your phone to usb power without battery inserted. Then turn on when phone boot insert your new battery into your phone let charge until green led or 100%. And install Battery Stats and post details about your batt.
dark_vader said:
Strange
Try this connect your phone to usb power without battery inserted. Then turn on when phone boot insert your new battery into your phone let charge until green led or 100%. And install Battery Stats and post details about your batt.
Click to expand...
Click to collapse
i've tried that nothing changed. i let it boot up without the battery then put it back in without pulling off the charger and it still seemed to be without battery just with the usb cable. i got back to official gingerbread, no rooting and stuff now but still doesn't charge. the weird thing is that the very first time that iconnected it to the charger, when the phone was off, the light started blinking red without phone getting into "battery screen" and after a while it was at battery charging screen. 15min later it was booted up and "no charging" status
Cybergiannis said:
i've tried that nothing changed. i let it boot up without the battery then put it back in without pulling off the charger and it still seemed to be without battery just with the usb cable. i got back to official gingerbread, no rooting and stuff now but still doesn't charge. the weird thing is that the very first time that iconnected it to the charger, when the phone was off, the light started blinking red without phone getting into "battery screen" and after a while it was at battery charging screen. 15min later it was booted up and "no charging" status
Click to expand...
Click to collapse
Okay. Ask Huaei to change your battery since it's damage for another one you have and can active warranty do that
Heyas guys,
I had my N4 on charge overnight, woke up to the alarm i set but as soon as i touched my phone it turned off and wouldn't turn on again.
on charge it showed a steady red LED. i realised that the charging cable had its D+ and V+ (Green and Red wires) broken so i assumed the battery had just reversed its flow of current and drained.
I tried all the button combos to no avail, so i ordered a NEW battery and replaced it just then.
still no boot, steady red LED on charge.
Any Solutions? (i've searched)
and any way of getting the data off somehow?
thanks!
Hi all. my Samsung S7 Edge was working fine albeit a bit sluggish at times but it was okay. I was down to 14% charge and so connected it to its Samsung charger with a non stock cable which is its usual charging process. It was otherwise okay and the screen went off so it was completely black, the red charging LED came on and I left it like that for a little while. It is still in that precise state and no sequence of button pressing for any amount of time gets any response at all. Nothing, no vibrate, no charging indicator, no flicker - absolutely nothing changing. Red LED and blank screen, no response. I would like to discharge the battery asap and have clamped the Vol- and on/off button pressed for 20 minutes and it is not connected to anything. It is not rooted and there is no response if I connect it to a computer. Is it bricked? How can a phone 'brick' while working as it should?
So I removed the back, disconnected the battery for a minute or so and reconnected it. The red light had gone off and now nothing, no light at all and it is connected to the charger with the Samsung cable. I have tried a different charger - my laptop. I happen to have an unused battery I was going to replace this one with so I have now also tried another battery. The phone is just dead and no response at all so I guess there is only one option - bin it!
Well I happened to have a smashed S7 Edge so a working motherboard which I replaced and obviously cured it. Restoring as much as I can remember but can anyone still suggest anything I can do that may kick start this motherboard?
The same happened with my S7 Edge, yesterday. Just a blinking blue led and I couldn't turn it on. So I waited till the battery was empty and tried to recharge it. No red led no button combos are working, nothing. The phone is dead.
Was there an update?