Hello, he flashed with my flash in EDL mode my Xiaomi Mi A1 and after about 400 seconds to success, my surprise is the phone is not only flashes the LED when connected in EDL mode to the PC.
In addition, there is no series of commands with the volume and power button, a part that has been tested to charge the battery, disconnect and connect it ..
Related
hi
my redmi note 4g is not booting to system...it keeps rebooting itself..i tried to get to recovery and fastboot mode...i did manage to enter but for only few seconds and back to same ...it shows only mi logo...and it starts only when connect it to charger or to pc...guys pls help me
shimjitlal said:
hi
my redmi note 4g is not booting to system...it keeps rebooting itself..i tried to get to recovery and fastboot mode...i did manage to enter but for only few seconds and back to same ...it shows only mi logo...and it starts only when connect it to charger or to pc...guys pls help me
Click to expand...
Click to collapse
Try jump starting it. Just remove the battery and connect the phone to the charger for 5 sec (mi logo will appear but the phone won't start) and then just insert the battery and press and hold the power and volume down key when you see charging logo and navigate to fastboot mode and flash the stock ROM.
Nope
rajatgupta1998 said:
Try jump starting it. Just remove the battery and connect the phone to the charger for 5 sec (mi logo will appear but the phone won't start) and then just insert the battery and press and hold the power and volume down key when you see charging logo and navigate to fastboot mode and flash the stock ROM.
Click to expand...
Click to collapse
After removing the battery and plugging in the charger, mi logo is not appearing. Instead, fastboot mode is getting opened and the loop starts until you unplug the cable.
I am now in EDL mode, I exit can't EDL mode
Hold power button for a little while...
Yes, just hold the power button down for about 10 seconds and it should boot. If not, then try holding it down for about 30 seconds instead. You should see the red LED blink just before it comes on.
does not exit edl mode
MI S2 MODEL M8103E6G
does not exit edl mode
phone cannot power on will boot to edl mode always.
please help.......:crying:
userfile said:
MI S2 MODEL M8103E6G
does not exit edl mode
phone cannot power on will boot to edl mode always.
please help.......:crying:
Click to expand...
Click to collapse
Wrong forum, aren't you able to read?
If you have some ROM that fits your cellphone just flash it. Worked for me in my Xiaomi Mi a3 using Miflash.
Good look.
Hello. I have a redmi pro helio x25 version and its warranty out. The device dont power on when i push power button. Only power on when i plug to usb port. I can flash perfect on my windows, and see the “ok signal” when flashtool finish. The devices only say mi logo and arround 30 secs its reboots. I can enter on fastboot mode. It have bootloader blocked. I release the buttons flex to disscart buttons problem but still problem.
I flash another devices on past with succes, but this one its ressist to fix. Any help are wellcome.
RESOLVED
today my redmi was dead without a reason. i just send a text message and power off the screen, after 10 sec the phone has became unsesponsive
i have try to press the powe button alone or with vol+/vol- for 2/3min, put the phone in charge, but nothing happens :crying:
If i connect the phone to pc it is recognized as Qualcom HS-USB QDLoader 9008 (COM20), if i try to flash a new firmware i have a timeout error
I have attached the flashlogfile :crying:
Some suggestions?
At 100° retry to bootup the phone, i just connected the pc cable when at the same time i pressed vol- and power. The fastboot screen has appear anche afther that i just rebooted the phone, all data is intact, only the clock time was resetted
My Device is bricked. One fine day, the mobile was not charged inadvertently and phone discharged to 0%. Later on connecting the phone to a charger, the phone did not turn on. When pressing the power button, the MI logo flashed and phone turned off. The hardware was checked by a technician; No fault was found except he said the Os might have corrupted. Flashing the device might turn it back on. But I didn't want to lose data, so I stopped.
However, the phone could be switched to fastboot mode by pressing the power button and volume down key.
I needed the data back so in an attempt to unlock the bootloader, I typed the command
`fastboot oem unlock`
The command prompt printed Successful. Finished in...,
the phone restarted but as it is, did not turn back on.
When I am trying to switch to fastboot mode it just doesn't blink or doesn't flash the logo as it used to do earlier.
However, the device seems to get connected to the pc. I had installed adb drivers and MI Flash tool.
The Mi Flash tool on refreshing identified a device with an id.
In this scenario if I have to turn on the fastboot mode and flash a custom rom and save my data, what can I do?