have zte blade 3 , power off press up and volume button goes off the boots into Chinese menu writing on screen not the usual green android picture and recovery selections options ? is this a different menu ? its is branded skinny new Zealand Zte blade 3
Related
I was trying to add some files to System/lib to fix Arabic language problem after i do that and get out of root explorer i tried to access root again .. found it not working then i shutdown my tablet ..turn it on again .. tablet is not starting up and freeze on ideos logo...
- i search the web for any solution some one says press volume up+home +power ..result written on the screen enter fastboot press home+back to restart
- tried to make recovery by pressing home+send +power also nothing happened
My device Model .. Huawei ideos s7 -104- android2.2.2
can any one help me coz.. i don't have official device support in my country..
after rooted with custom recovery ( CWM or TWRP )
~~~~~
been searching the web and seen people reporting that it's a bug with JB and that you have to use USB cable attached to PC in order to cold boot into bootloader with hardware buttons... or that holding both volume button as you power on does NOT work...etc ... so as far as I can read... people are relying on tricks or at the mercy of having to boot from inside android ( fully boot )...
what if your system does NOT boot and you need to get into bootloader and recovery ??
well... I found out how !! :laugh:
/ with the device OFF
/ hold down "POWER BUTTON" for 3 seconds and let go..
/ as soon as you let go of the "POWER BUTTON"... HOLD IN THE VOLUME DOWN BUTTON... and you will automatically be in bootloader mode
/ Select with volume rocker & confirm with power button
I get stuck on the splash screen when I select recovery.
Sent from my Nexus 4 using xda premium
hello. I have a problem. My ZTE Blade 3 will not start. nacikam when the power button the phone only vibrates every second until you let go of the button, nothing displays. FTM mode is activated (vol- + power) did not cause it can be run through (vol- + usb connection), but turns off after a few moments. I can still run it through (vol- + vol + + usb connection). I would like to install the firmware and run the phone. I tried to install via QPST but I do not know how. The phone is detected as ZTE Handset Diagnostic Interface (DFU) (COM17). Please help to repair your phone. I warn that I do not have service BOX. Thanx for help and advice
I have ZTE Blade 3 Pro
Phone turns on normally and works.
But I can't enter recovery mode in order to reset the phone and/or flash firmware.
What happens is after holding the button combination green android logo shows up and just hands there.
Anyone knows how can I enter recovery mode ?
Actually I got a lenovo a1000 . I have to access the stock recovery mode .
I pressed all three buttons volume+ volume - and power.
I got the vibration and gives me a screen equally divided in to 3 colors. i.e, Blue, Green and Red.
How could I get the recovery menu?
same here , i reset my phone and it didn't solve