Lenovo zuk z1 when powered on shows up cynogen logo and automatically power off until entire charging is over?How to solve it please help
I also faced this problem i would say do qpst and then one by one flash rom upto pie or oreo if u want in sequence.
Related
yesterday i just locked my boot loader and then i manually restarted the device, it booted till zuk logo and then it vibrated and restated again and then it booted till zuk logo and it restated again. in every 2 sec. device is restating. i tried to shutdown the device but that is also not happening it is just restarting again and again -_- . some more issues :
1. not going into recovery mode
2.not going into fastboot mode
3.not shutting down.
4.not getting detected into pc by adb or any other driver.
5.not getting into qualcomm mode.
i just dont knw what to do i just tried every thing but the phone is restarting again and again :'(
if someone knws what could be the problem and solution then please help me.
i have the same probleme what did you do pls!!!!!
i find it thanks gooooood
http://www.androidbrick.com/lenovo-zuk-phones-qfil-roms-unbrick-guide/
Hello,
I am also facing the same problem
I am not able to open the port .
Can you say me how did you open the Qualcomm HS-USB Qdloader 9008
Help me
hello i'm facing an issue with my zuk z1. I flashed zui 2.5 rom in it through qpst and also unlocked my bootloader and flashed twrp it was just working fine, then i decided to flash the nougat firmware because i was getting some random reboots.
today i flashed a firmware(nougat) for ham and then twrp asked me for reboot i selected reboot and selected system (i usually power it off and then power it on manually) and after that it just started booting up infinite times it just shows a penguin logo for just a fraction of second and automatically reboots in just 2-3 seconds and also vibrated while rebooting
Please help me what should i do ?
Whenever I install COS 12.1, my phone went to bootloop
Phone works fine in Nougat and zui but whenever I install cos via fastboot or twrp, it went to bootloop.
Any solutions???
Also any link for Qfil COS 12.1 room?
Hi, in August 2016 I made a Zuk Z1 system upgrade to a version of Cyanogen OS 12.1 and after a couple of days it started to reboot even 7-8 hours a day until after days it stopped restarting but if I press the power button vibrate on screen off.
It does not go fastboot or recovery. Zuk has never been modded.
How can I fix it?:crying:
Yesterday I installed the latest TWRP for my Lenovo Vibe P1ma40,everything seems fine,after that Im going to reboot it to normal boot,after showing the phone logo its turning back to TWRP.I make it too many times but it failed to boot in normal boot.
Anyone can fix my phone please?
My phone k6 note restart on logo in charging time only
but software is running properly but restart on logo
i will change battery but not working
it is ic problem yes or no? anyone answer pls
Hi
I'm facing a problem with my tablet. It shut down after official update and gets a bootloop. I'm not able to get into recovery mode beacuse when I press power+vol up it gets stuck on Lenovo logo. I was able to enter a fastboot mode so I decided to flash ROM. I tried official Lenovo assistant and Qfil + Many roms (stock, dumps from other users) but I always gets a bootloop. I can't turn off a tablet, because it turn on by itself and gets into bootloop until battery dead. What is a cause? How to fix it?
Update: I leave it plugged in to PC via USB cable and after many bootloops my PC shows tablet as a hard drive (I was shocked). Then tablet shows animated Lenovo screen, then Lenovo screen with Snapdragon and finally on screen I saw menu with language selection. My joy was short, because right after choosing language I get a information: Battery temperature is to low. Charging has been stoped" Then tablet shut down again and goes to many bootloops until it will turn on again with the same information. Is this a battery problem?