How to boot yotaphone 2 without EDP screen, lineageos does that fine? - YotaPhone

So i have flashed everything from android 4.3 to 6 and the same thing happens, powered by android and then boot loop at the blue screen (boot animation). Lineageos boots just fine, but the two roms i have found don't charge at all unless i put it in downloading mode and still just 65%, also camera did not work, and a lot of other stuff. Currently struggling to edit that boot.img thing but, it's just too much, i don't know this stuff. Worst case i'll wait for the official lineageos.

Bump !
Or to say it in other words, any solution for this ?
I am on the latest 6.01 b147 version and would love to boot w/o EDP attached.
Ender

Related

[Q] Problem: Phone stuck at ROM Booting animation.

Hello everybody.
I am a Defy Red Lense user with a recently flashed PA 2.14 build (coming from 2.00 version of same ROM). At first 3-4 boots everything was ok, till I made some changes on phone config (namely enabling 16 bit transparency as recommended by it's maker, and then some small changes in Paranoid Android Settings) and asked me to reboot. Ok so I went to reboot and as usual, it booted me into bootmenu, and I chose "boot" and "2ndinit" as usual. After a odd bootloop (where the phone wouldn't go through the blue, then green LED sequence and would then reboot, show Moto logo boot animation, rinse and repeat, etc) that I ended by pressing vol - and entering, again, into bootmenu, I chose again boot and 2ndinit and then something really weird happened:
After almost half an hour i'm still stuck at the very ROM booting animation (the Paranoid Android one, no the Moto logo), just like the guys that tried that new kernel that were reporting 15+ min first boot times. As a clarification, my first boot with just flashed 2.14 took, at most, 5 minutes. And there is another odd vehaviour, concerning the PA boot animation: it gets randomly stuck for a few secs and continues as usual, with no looping from 0 just like the normal loopboot.
So here comes the questions:
- What is really happening? is it really booting or the phone is just stuck in ROM bootanimation? How long should I wait to consider shutting it down?
- Is there some way to get out of it/shutting it down without damaging the device? Can I just pull the battery off without bricking the device?
Looking fowardd for some theories behind this issue :good:
Well, seems like it was OK to unmount the battery while on ROM booting animation, since I haven't had mayor problems after doing so and rebooting. Now the phone works just fine.
Tho im still curious the reason behind this pseudo-bootloop. Thanks for reading anyways :good:

Storm Bricked and Fastboot Broken

Hi all,
I got my Wileyfox storm running stock CMOS 13.0 in April and had no problems for about a month. Eventually, I got a pop-up notification with an "Incremental Update" for the phone. I downloaded it and when ready to install, I did so - or at least tried. The update finished and booted into recovery for some reason. At the time I didn't question it and just rebooted the phone from recovery. This led to a boot hang on the "Cyanogen Mod Ready" boot screen.
After searching around for a fix I eventually tried to flash over the stock ROM via Fastboot - which for some reason errored on emmc_appsboot and the phone rebooted itself - with a penguin instead of the Wileyfox boot logo and STILL hangs on the Cyanogen screen. I can also now not boot into fastboot and not boot to fastboot from recovery either (which I CAN still boot to).
Does anyone have any ideas on how to fix this ASAP??? Help would be greatly appreciated!
Many thanks.
I've finally found something that works, unplug the battery for a day or two, then plug in and charge and turn on and might boot properly. Frustrating having to do it every time you get into the bootloop hang and doesn't work every time but still probably salvageable.....I discovered after being bricked for 14 months.

N910F Boot loop

Hi
I am stuck with Pulsing blue LED and the "Powered by Android" screen,
have access to both the recovery and the download Mode,
I also have Odin (version 3.13) on my computer along with TWRP (3.1.1 trlte and 3.2.1 version)
My device is a Samsung Galaxy Note 4 N910F bought in shop, no special carrier. It was bought in the Netherlands.
I have tried everything that I have read. The furthest that I can go is the Second Samsung Logo with the Flashing Light
Whenever I try to Flash the stock Firmware for my N910F, everything goes well in Odin but then when the phone reboots, it (sometimes) install the system update until 30% then shows erasing then either crashes right there and then or load the system update bar, completes it then shuts down.
I have tried multiple firmwares, even recovery firmwares. All the same problem. I can see the firmware is flashed, because when I enter recovery mode after I flashed a different ROM, it shows the version I flashed.
I cannot seem to install TWRP because it was never rooted.
Whatever I do, at some point, my phone either gets stuck in a bootloop, freezes with the LED light or shuts down.
And I have also proceeded to use different batteries.
Do you have any options?
Thank you
Heat????
I'm far from an expert here, but I've just experienced a similar problem where my N910F started boot looping / freezing within 15s to 2 min after unlocking. Unfortunately my micro Sd (SanDisk 256GB) was corrupted a week ago, so before doing anything else I did some research (XDA/YouTube) and probably found pretty much what you've found. I frequently change batteries so I could discount that as an issue. Someone suggested using the Samsung Smart switch here https://www.samsung.com/uk/getting-started/smart-switch/, but I haven't used it (yet) so I can't tell. I presume you had the latest firmware from Sams https://www.sammobile.com/firmwares/galaxy-note4/SM-N910F/.
My issue was that I needed to recover data, docs, photos, phone numbers etc. When boot looping the note 4 got very hot . In particular around and to the left of the camera (looking at the rear). Thinking it could possibly be the dreaded eMMC problem which also manifests itself by creating heat, I thought cooling the device might help. I placed the Note on a cooler box freezing block and voilĂ ! No boot loop. I was able to remove all, but necessary apps and do a full copy to my PC. Storage was reduced from around 90% to 50% and memory 80% to 60%. It's now been stable for 12 hours, but the jury is still out. Next will be full reset with he latest available firmware 6.0.1 as mine was still on 5.1.1.
Good luck and hope this may be of some help.
I've got this problem, too, when using the unofficial Lineage 15.1 rom. SIM death and boot loop. After flashing the latest stock rom through odin, it passed but the screen was black and no system was installed. The blue notification light was constantly stuttering, though. And I couldn't even go to recovery!
When flashing, a 910F can get hot - use a cool temperature room and/or a fan blowing onto the device.
If it's not too late...

LG G2 D801 Bootloop after flash/reboot

Hello,
I'm currently experiencing a bootloop on my phone, it gets to the resurrection remix logo screen during boot then restarts. I've tried booting into recovery and download mode. When I try to boot into recovery it loads the factory reset screen as usual but when I say yes to the reset in order to launch TWRP it just goes to the LG logo, then remix and restarts all over. I got into download mode one time since this started but since then I've made countless attempts to boot into it again and can't.
What I was doing right before this happened is, I recently completely wiped my phone, flashed stock firmware, wiped, then installed resurrection remix. Everything was going perfect, it started no problem, I went through and cleaned up some apps I didn't want etc normal setup steps then I used the power menu to boot into recovery instead of just using the hardware keys and the bootloop started.
Besides the not booting, the other major issue here is that it never stays connected to the pc via adb long enough to do any actions or flash a single file. By the time the pc sees it and adb sees it, I have roughly 2 seconds before it restarts again.
I really really really need any help I can get please ASAP as this is my mom's phone and she needs it for work in 4 hours. This issue started about four hours ago and I've been trying to fix it ever since. I feel like I have looked everywhere on here and through google but probably missed the solution. Before you ask, I'm 28 not a teenager and work in IT as a career for the last 12 years so don't get the wrong impression. She asked me to work on it because I had set it up a few months back with a lollipop version of resurrection remix and magisk, but in the last month or so she was having really poor performance and issues with settings crashing and a few other apps.
I hope you don't need any more info from me, if you do however I'll be here trying to fix it until she goes to work at least. I really could use the help and would greatly appreciate it.
Thank You

[QUESTION] LineageOS Install

I'm currently installing lineageos in my phone, it is booting for the first time and it looks fine, I've heard that the first time booting up the phone with a custom rom can take a while, 1-10 minutes. My phone has been in the lineageos booting screen for quite a while now and im getting worried. Do i need to wipe my phone and reinstall lineageos? EDIT: It is now in the same boot screen for around 40 minutes now. Edit 2:It got stuck on one part of the animation and the only thing in he screen is the curved blue line without any animations EDIT 3: Problem is solved, i reinstalled lineageos and it is working well

Categories

Resources