Hello. I'm wrecking my brain trying to understand this. Yesterday my phone started exhibiting weird charging behavior. It charges fine when plugged into PC, but does not always charge when plugged into wall unit or car charger. I tried multiple cables/charger combinations which all work as expected with my other phones/tablets. It is only with S7 Edge that I started having an issue. Wireless charging works fine as well. I tested multiple charges/cables while the phone is turned off and the result is the same--works well when plugged into PC, and not well when plugged into wall/car charger. When I use wall charger, it may take me multiple attempts to initiate "charge" status. Is my port messed up? Do I have an issue with (some) charging pins? Has anyone experienced similar issues?
Thanks!
Related
Hi there,
I have a big problem with charging my Galaxy S4. It only charges with my notebook USB Port, my AC-adapter does not work.
In the battery menu I can see that AC is connected, when I plug my adapter in. But charging does not work with my device.
Over USB I can charge slowly. This isn't a software problem, I have done some resets and firmware changes since the problem.
Maybe my phone got a little bit wet earlier. Could this be the problem? Can I fix this with changing the USB port part of the hardware?
colli666 said:
Hi there,
I have a big problem with charging my Galaxy S4. It only charges with my notebook USB Port, my AC-adapter does not work.
In the battery menu I can see that AC is connected, when I plug my adapter in. But charging does not work with my device.
Over USB I can charge slowly. This isn't a software problem, I have done some resets and firmware changes since the problem.
Maybe my phone got a little bit wet earlier. Could this be the problem? Can I fix this with changing the USB port part of the hardware?
Click to expand...
Click to collapse
Already Tried to replace the charging cable?
Androiders96 said:
Already Tried to replace the charging cable?
Click to expand...
Click to collapse
Yes, I tried another cable but had no success
I dunno if I can ask it here, but i don't charge over usb, i mean it just "hold" the power level for me. Is that normal ?
Is your AC outlet working ?
Having issue where S4 only charges with USB and vibrates when using AC charger
I've been having some issues with my S4. I did recently get it a little wet, but it's working fine in all cases except charging. I have my phone next to my bed charging every night. I noticed it was dead one morning, but I figured I didn't connect the charger properly. The next night I noticed it was vibrating every 5 seconds or so, but the phone had turned off due to a low battery. Very strange behavior.
I realized that it would start charging, but it would stop between 1-3 minutes. The the phone would vibrate and not charge.
I've ready MANY posts from others with the same issue and someone mentioned their phone charges over USB. Seemed odd, but I tried it and voila, my phone charged perfectly. I have many samsung cables, none of which work. It's definitely not the cable. I can plug a samsung cable into my phone connected to AC and it doesn't work. I pull the USB portion out of the AC charger and plug into a computer and it immediately and consistently charges. The battery holds its charge as expected, so it doesn't appear to be a battery issue.
I've tried the developer mode options - no luck.
I've tried bending the charging prong - no luck.
I've tried blowing out the charging port with compressed air - no luck.
I recently got an update pushed to my phone (Sprint), but I don't think it was happening right after the update. Seems like a likely software issue.
I did get my phone a little wet recently, actually it was my young children throwing water at me.
I've read so many posts and nobody seems to have a good answer for this issue. Any suggestions are appreciated.
So we've been combatting some finicky charging issues with my wife's new S5 for the past week.
I've worked out a lot of the weirdness due to the fact that my HTC M8's charging brick apparently doesn't work with anything other than the M8 (I have no idea yet what is different about it... 1.5A).
Anyway, despite this we have had no issues using the supplied charger/cable (only used it on first day).
We haven't had any issues using an old Droid 2 charger and cable (1.0 A I think)...although likely it was a slow charge.
But, since we've been out of town for a few days without all our cables, the only think that has worked with NO issue is using a 2.1A output power brick to recharge the phone. Also, it seems that the 2.1A iPad charger worked as well.
What is weird is we also tried 2 identical 1A iPhone charges. Upon first plugin with a 10' 24/28AWG cable, it didn't charge. I removed it and plugged it into the other one and it began charging. I then removed it and plugged it back in the first and it started to charge fine (and yes, I tripled check the connection on the first try).
In short, we seem to just have very strange results. Sometimes it will say it is charging for a few seconds and then stop and sometimes it will not charge using a certain combination, but when you unplug it, try something else, then back to the first it will work!
We've also had issues with the charger in the car where it would keep blinking her phone on and off with a sound. I suspect that this was due to a slow charge bringing the phone to full charge, then dropping (even though plugged in), then going back to full again. But this is just based on what my wife described.
Can anyone explain and/or tell me what the minimum required and the recommended specifications are for a charger/cable on this phone?
Recently my OP2 doesn't seem to charge properly. Meaning...with the USB cord connected to the base it charges for a min then stops. The light stays on as if it's charging but it's not. I have to unplug it and plus it back in and it's fine for a few min then it stops and I have to do it again. This just started happening. I haven't dropped it or anything. The charge port is fine. Anybody else have this problem or HAD this problem...any info would help...
I have this exact same problem with my less than a week old OPT. I think its the charging cable gone bad. Using Ampere to check the charging current, I find that it never goes over 200ma and after about a minute (or lesser) disconnects because the software cuts it off when the current is too low. For now, charging with the phone turned off works, since no software to cut off the charger, but I do not know if this is bad for the battery. I am trying to find another Type C cable now, see if I can confirm this. Will post back if I do.
UPDATE: Was the cable. Friend's xiaomi cable worked perfectly and charged my phone back to 100% while I had dinner. Amazon is giving me a free replacement, so not complaing too much ...
hi guys, I have a very strange problem, when the phone is charging, closes anything I open, I am obliged to remove from office for poetrlo use without problems, you have any idea?
I have encountered strange issue too. It continuesly disconnect with charing.
When i connect the with charger it repeatedly connects & disconnects with charging. I m using Adaptive Wall charger supplied by the Samsung. Even tried different charging cables and chargers too.
Lately I've been having issues with my phone and charging. It started with the stock OEM charger getting steadily harder and harder to use.. so I bought an Aukey charger to replace it with and it completely refuses to work on my phone, so I tried another phone and tablet and it works great. I tried my super old Galaxy note 2 charger with a motorola usb cable from my maxx and it works fine... I then tried that usb cable on the aukey QC 2.0 charger and it won't work... tried the same cable again on my phone with the sammy charger and it worked... tried a QC 3.0 aukey wall charger and it won't work... yet I have a QC 2.0 incipio car charger. it was working with the USB moto cable I've had in my car since I got my Bionic... then it just stopped charging my phone, got a new USB and it works great now except the moto usb will work for friends, just not my phone.
I have absolutely no idea what's causing this... I thought maybe there was lint in the charging port so I took a tootpick and cleaned it out, got a small piece of lint, same thing with all the chargers. I can't find anything online, and being a tinkerer I've tried everything I can think of before asking. I'm starting to think the phone itself is having problems and the port is actually bad or there's something wrong in the software causing it to have problems with turbo or QC chargers.
any ideas?
There is a general inconsistency with this device and Quick Chargers... if you look in the Accessories area there are several threads discussing it.
Personally, I use the Aukey QC 2.0 charger for travel with an Eversame premium braided cable and it works fine, yet others use the same combination and it won't Turbo charge or in some cases charge at all.
I also face the same issue. Some USB cables work with my Moto X Style and some doesn't .
i am having an even worse issue and i am sure its a software problem, recently my moto x stopped charging using the moto charger so in the last two months i have 4 different chargers who worked for some time each now it just doesnt work at all, i have cleaned the port numerous times then it just stopped working so when the phone finally died all of a sudden it started charging but as soon as it switched to turbo mode the charge would stop and start over again. i have deduced its a software problem as once the phone tries to go to turbo charging mode it cant sustain the charge and cancels it. amphere even shows its discharging while on the charger , however if it starts charging while the phone is off with a low voltage adapter and turn on the phone once you dont remove the cable it will charge (extremely slowly but it will charge).
redtrinstar said:
i am having an even worse issue and i am sure its a software problem, recently my moto x stopped charging using the moto charger so in the last two months i have 4 different chargers who worked for some time each now it just doesnt work at all, i have cleaned the port numerous times then it just stopped working so when the phone finally died all of a sudden it started charging but as soon as it switched to turbo mode the charge would stop and start over again. i have deduced its a software problem as once the phone tries to go to turbo charging mode it cant sustain the charge and cancels it. amphere even shows its discharging while on the charger , however if it starts charging while the phone is off with a low voltage adapter and turn on the phone once you dont remove the cable it will charge (extremely slowly but it will charge).
Click to expand...
Click to collapse
FYI... There is no software problem with charging, if there was it would affecting hundreds of thousands of people. And I doubt you have 2 software problems, a bad kernel and a bad bootloader/recovery image, because 2 different things control charging when powered on and powered off.
Issue here is you likely have a high resistance connection somewhere between the USB port and the battery itself, or a bad charging circuit... It's hardware.
while i can understand where you are coming from when the phone is in factory mode (motorola customer care told me to try) its charging fine also turbo charging is working now just it doesnt recognize the sim card. it was a suggestion from Motorola customer service desk, as i live outside of the us they gave me some options to try. they said it was a software glitch where the phone may have gotten an overload from a bad connection and caused the phone to not recognize the charger. however while the phone is off this check is not performed which is why i was getting a lower amp charger to work as the phone did not have to enable the protocol that allows for quick charge/turbo charge voltages.