Factory mode - Galaxy Note 3 Q&A, Help & Troubleshooting

Hi all phone keeps booting into factory mode, even if flash new rom any ideaw/solutions this is screen shot, I've flashed bobcat, alliance and darklord with same outcome this is screen shot
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}

Google ?

Or search XDA .

Or search XDA while you search in google
lol
Search how to flash firmware with Odin, simple stuff and it should get you out of your pickle

Fully aware how 2 use odin but not sure how that's going to help I've installed 2/3 firmwares to no success m8No m8

Do you not upgrade firmware through Kies.
Sent from my SM-N930F using XDA-Developers Legacy app

No m8 I don't really upgrade just either bang a rom on it or download firmware and odin it

Fully aware how 2 use odin but not sure how that's going to help I've installed 2/3 firmwares to no success m8No m8

Kies as in to fix factory mode .

You can download stock firmware from sammobile
These are odin compatible.
I had a similar situation when i flashed custom rom with latest twrp. (I used twrp 3.0) So i got stuck on download mode. After many searches i found how to use odin and flashed stock firmware. Then rooted it, changed recovery to custom and then flashed custom rom with twrp 2.8.7
Also provide your model no. and what you flashed so that more experienced guys can help you to come out from download/factory/odin mode.

Will do I've flashed a few bobcat and darklord to name 2 of them with same outcome I'll take screenshot on boot up

Just went ahead and googled for the heck of it... would "This" be a solution to your problem?

Related

Correct boot.img

Could anyone provide the stock boot.img for the SMG530AZ on 5.1.1
I recently updated the phone to lollipop and I rooted with kingroot and replaced that with supersume and flashed what I thought was the original boot.img the problem I have now is that my phone starts works and is rooted but the wifi does not work and will not turn on.
Go to settings > About Phone and tell me the compilation number. @markocl17
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Sent from my SAMSUNG-SM-G530AZ using XDA-Developers mobile app
Ok, so here is what probably happen. You flashed the boot.img for the G530A (You can see that in the SE status). I will be trying to see if I managed to get the firmware for your phone. I can't assure I will but I will try!
However if you are willing to reset your phone you can try this.
@markocl17
fabiossilva21 said:
Ok, so here is what probably happen. You flashed the boot.img for the G530A (You can see that in the SE status). I will be trying to see if I managed to get the firmware for your phone. I can't assure I will but I will try!
However if you are willing to reset your phone you can try this.
@markocl17
Click to expand...
Click to collapse
Did you ever get the firmware?
Sent from my SAMSUNG-SM-G530AZ using XDA-Developers mobile app
Sorry, no I wasn't able to. Forgot to update you, had school and stuff. Do a factory reset from KIES (link in my last post) best o'luck!
@markocl17
Do you know how I would go about downgrading to kit kat?
Sent from my SAMSUNG-SM-G530AZ using XDA-Developers mobile app
I don't think, it would be possible to do so due to Samsung KNOX Bootloader. But if it is you need to find the firmware to flash on ODIN, you find someone willing to make a system.img from their phone (Must be a G530AZ). Using KIES it is only possible to recover the lastest firmware available.
Sorry @markocl17
http://www.mediafire.com/?2fk19cadccq0xd7
Boot img. ^

Is it possible to unbrick the Note 4 SM-N910F variant?

I have with my a Note 4 variant (SM-N910F) which got bricked after trying to flash a custom rom. Is it possible to return to stock rom or do I have with me just an expensive rock?
Here's a screenshot of what is displayed when the device is powered on:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Thanks in advance
garzie2000 said:
I have with my a Note 4 variant (SM-N910F) which got bricked after trying to flash a custom rom. Is it possible to return to stock rom or do I have with me just an expensive rock?
Here's a screenshot of what is displayed when the device is powered on:
View attachment 3723862
Thanks in advance
Click to expand...
Click to collapse
Yes. Use Odin to flah a stock rom, or better, to flash a recovery. From the recovery you do what yiu want
pr1jker said:
Yes. Use Odin to flah a stock rom, or better, to flash a recovery. From the recovery you do what yiu want
Click to expand...
Click to collapse
Thanks for the prompt response. Never used Odin or a flashed a Samsung phone before
If flashing the single stock tar doesnt work, try using "samfirm" to download the latest rom in binary format so that you can repartition the phone with odin.
Just download the file and extract it to get 3-4 seperate tar files.
Select the files according to the tabs in odin (compare the prefixes of the files with the file selection tabs of odin).
This must do the job.

Stuck at AT&T boot screen

Hey guys. Alright I somewhat know my way around Samsung devices. Its been a while. My last Samsung device was a Mesmerize. Anyway I purchased and rooted my AT&T S7 Edge yesterday. This morning I attempted to install Xposed. I know in the OP its states it would take a long while for the device to boot. Well I gave it almost an hour. So then I went into stock recovery and wiped cache and factory reset assuming after that I would be good. Its been about a half hour now and I'm still sitting at the AT&T boot screen.
I've searched, and I'm not sure if I should continue to wait this out, or do I use Odin and flash stock firmware. If I will need to use Odin to flash stock firmware, could someone link me to the latest? While searching I believe I'd seen their is a certain Odin I need to use for this. If this is the case, which version would that be?
Thanks in advance
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
This is the FW I'm currently downloading
Flashed the files thru Odin and it wouldn't go thru. The Odin I'm seeing I need and have downloaded is a rar file and I can't open it on my laptop
Sent from my XT1575 using XDA-Developers mobile app
This is my error message
Sent from my XT1575 using XDA-Developers mobile app
Sent from my XT1575 using XDA-Developers mobile app
NVM I got it. I'm booting up now. Wrong version of Odin
Sent from my XT1575 using XDA-Developers mobile app

Samsung Note-3 N9000q stuck at initializing while flashing with odin

My n9000q started to stuck at black screen after samsung logo when booted. I tried to flash twrp recovery from odin to recover my files via backup. But after i tried to flash with odin it stuck at initializing. I tried different versions of odin but non of them work. Now i can't enter stock recovery either. How can i get past that initializing problem ?
Please tell what you did and what firmware etc .
as i say i tried to flash twrp3.2.1-0-ha3g with odin 3.09 with auto reboot and f.reset time checked re-partition unchecked. I don't know about firmware model and i don't how to check now while device is softbricked.
Try an older 2.8 TWRP.
The model number will be shown on the screen with the phone in download mode.
Post a screen shot or Odin log. These items are very helpful when helping other XDA members.
Model number is sm-n9000q never updated firmware before. As suggested i tried older twrp (2.7.1.0 and 2.8.5.0) it didn't work either.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
What TWRP was on the phone before problem.
before problem it had stock recovery no twrp. The phone is full stock before.
Sorry I read OP recover files through backup and assumed backup =TWRP.
I tried but didn't succeed :/
All I can suggest is try different USB cables and USB ports.
Did you have a look through this thread: https://forum.xda-developers.com/ga...elopment/recovery-official-twrp-ha3g-t3406899 ?
I look through that post and tried other ports and cables but none of them worked.

Firmware for SM-G930A

I've been looking for the firmware for this device for a long time and I can't find it, I need your help please. What I can do? Or do you know any custom rom? The stock rom would help me a lot, thanks... :C
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
//G930A\\ Oreo 8.0 Latest Stock ATT Odin files G930AUCUBCTB1
Full ODIN stock ATT files. Download one file, unzip to 4 files, put in ODIN and flash. I take no responsibility if anything goes wrong. You don't need to be on certain baseband to flash this, you can flash this directly from any baseband version...
forum.xda-developers.com
Sebas310 said:
//G930A\\ Oreo 8.0 Latest Stock ATT Odin files G930AUCUBCTB1
Full ODIN stock ATT files. Download one file, unzip to 4 files, put in ODIN and flash. I take no responsibility if anything goes wrong. You don't need to be on certain baseband to flash this, you can flash this directly from any baseband version...
forum.xda-developers.com
Click to expand...
Click to collapse
Would you know what would cause the recovery/boot program to update system - show Erasing after flashing ? Thx in advance!
I have a Samsung Galaxy S7 G930AUCUBCTB1 purchased in Colombia, I need help! I've upgrade it to 8.0 and the phone has signal, detects the sim but Emergency calls only. I want to downgrade to 6.0 but I cannot find the proper firmware that works. Any help?

Categories

Resources