Could anyone provide the stock boot.img for the SMG530AZ on 5.1.1
I recently updated the phone to lollipop and I rooted with kingroot and replaced that with supersume and flashed what I thought was the original boot.img the problem I have now is that my phone starts works and is rooted but the wifi does not work and will not turn on.
Go to settings > About Phone and tell me the compilation number. @markocl17
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Sent from my SAMSUNG-SM-G530AZ using XDA-Developers mobile app
Ok, so here is what probably happen. You flashed the boot.img for the G530A (You can see that in the SE status). I will be trying to see if I managed to get the firmware for your phone. I can't assure I will but I will try!
However if you are willing to reset your phone you can try this.
@markocl17
fabiossilva21 said:
Ok, so here is what probably happen. You flashed the boot.img for the G530A (You can see that in the SE status). I will be trying to see if I managed to get the firmware for your phone. I can't assure I will but I will try!
However if you are willing to reset your phone you can try this.
@markocl17
Click to expand...
Click to collapse
Did you ever get the firmware?
Sent from my SAMSUNG-SM-G530AZ using XDA-Developers mobile app
Sorry, no I wasn't able to. Forgot to update you, had school and stuff. Do a factory reset from KIES (link in my last post) best o'luck!
@markocl17
Do you know how I would go about downgrading to kit kat?
Sent from my SAMSUNG-SM-G530AZ using XDA-Developers mobile app
I don't think, it would be possible to do so due to Samsung KNOX Bootloader. But if it is you need to find the firmware to flash on ODIN, you find someone willing to make a system.img from their phone (Must be a G530AZ). Using KIES it is only possible to recover the lastest firmware available.
Sorry @markocl17
http://www.mediafire.com/?2fk19cadccq0xd7
Boot img. ^
Related
During the firmware update process, I get this dialog (see below). I'm in the UK, on an unlocked SG-900F. Under About Device > Status > Device Status, it says Official.
Translation: If binaries are not registered, you can not proceed with the upgrade. Please check whether the binary file properties.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Fairly certain that my device is unlocked ... if anyone can explain how I can check, I will?
Download the rom you want and flash it via Odin.
vuittion said:
Download the rom you want and flash it via Odin.
Click to expand...
Click to collapse
Is that the only way? I'm on a Mac, and Odin never seems to work for me ...
Perhaps I just need to wait for the OTA
streetdaddy said:
Is that the only way? I'm on a Mac, and Odin never seems to work for me ...
Perhaps I just need to wait for the OTA
Click to expand...
Click to collapse
Still just having no luck getting JOdin to work on a mac... Java runtime messages, yada yada.
Is it possible to flash the firmware using the Heimdall front end, or command line? I've downloaded firmware G900FXXU1BOA3_G900FOXA1BOA4_BTU.zip
jOdin apparently doesnt work on some versions of OSX because you need a certain version of java. As for heimdall the github has a few pulls that people have reported work, so you can give that a shot, just check the issues section.
Sent from my SM-G900A using Tapatalk
Put the Rom Odin and USB drivers on a USB stick and go to a internet cafe or use a friends windows computer, problem solved.
Samsung galaxy tab 4 (8.0) SM-T337A 5.1.1 LOLLIPOP after flashing http://forum.xda-developers.com/tab-4/help/software-authorized-att-tablet-samsung-t3286582 my tablet is stuck on boot up PLEASE HELP! btw I tried factory resetting and clearing cache.
Download stock firmware and flash in odin. You cant downgrade latest, bootloader is locked
gonzo6962001 said:
Download stock firmware and flash in odin. You cant downgrade latest, bootloader is locked
Click to expand...
Click to collapse
i have a OTA file, but has a status 7 error,
I'm having same problem and my *Reboot to bootloader doesn't work either... [email protected] if u ever find a fix.. it wont let me past recovery screen then it wont open bootloader like wtf..
AllenPlaysGames said:
i have a OTA file, but has a status 7 error,
Click to expand...
Click to collapse
You have the OTA 5.1.1 update?!
Sent from my iPhone using Tapatalk
Did anything get figured out with this? I'm bricked too and can't do anything about it because the 5.1.1 firmware isn't out and I can't figure anything else out to fix it.
I was able to acquire the following files...
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Flashing these finally brought this hopeless nightmare to an end.
I had the Kingsroot + SuperSUME = FAIL brick condition and this saved the device (it wasn't even my device, I was fixing it for a friend). Let me know if anyone is interested.
Hey guys. Alright I somewhat know my way around Samsung devices. Its been a while. My last Samsung device was a Mesmerize. Anyway I purchased and rooted my AT&T S7 Edge yesterday. This morning I attempted to install Xposed. I know in the OP its states it would take a long while for the device to boot. Well I gave it almost an hour. So then I went into stock recovery and wiped cache and factory reset assuming after that I would be good. Its been about a half hour now and I'm still sitting at the AT&T boot screen.
I've searched, and I'm not sure if I should continue to wait this out, or do I use Odin and flash stock firmware. If I will need to use Odin to flash stock firmware, could someone link me to the latest? While searching I believe I'd seen their is a certain Odin I need to use for this. If this is the case, which version would that be?
Thanks in advance
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
This is the FW I'm currently downloading
Flashed the files thru Odin and it wouldn't go thru. The Odin I'm seeing I need and have downloaded is a rar file and I can't open it on my laptop
Sent from my XT1575 using XDA-Developers mobile app
This is my error message
Sent from my XT1575 using XDA-Developers mobile app
Sent from my XT1575 using XDA-Developers mobile app
NVM I got it. I'm booting up now. Wrong version of Odin
Sent from my XT1575 using XDA-Developers mobile app
Hi all phone keeps booting into factory mode, even if flash new rom any ideaw/solutions this is screen shot, I've flashed bobcat, alliance and darklord with same outcome this is screen shot
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Google ?
Or search XDA .
Or search XDA while you search in google
lol
Search how to flash firmware with Odin, simple stuff and it should get you out of your pickle
Fully aware how 2 use odin but not sure how that's going to help I've installed 2/3 firmwares to no success m8No m8
Do you not upgrade firmware through Kies.
Sent from my SM-N930F using XDA-Developers Legacy app
No m8 I don't really upgrade just either bang a rom on it or download firmware and odin it
Fully aware how 2 use odin but not sure how that's going to help I've installed 2/3 firmwares to no success m8No m8
Kies as in to fix factory mode .
You can download stock firmware from sammobile
These are odin compatible.
I had a similar situation when i flashed custom rom with latest twrp. (I used twrp 3.0) So i got stuck on download mode. After many searches i found how to use odin and flashed stock firmware. Then rooted it, changed recovery to custom and then flashed custom rom with twrp 2.8.7
Also provide your model no. and what you flashed so that more experienced guys can help you to come out from download/factory/odin mode.
Will do I've flashed a few bobcat and darklord to name 2 of them with same outcome I'll take screenshot on boot up
Just went ahead and googled for the heck of it... would "This" be a solution to your problem?
I've been looking for the firmware for this device for a long time and I can't find it, I need your help please. What I can do? Or do you know any custom rom? The stock rom would help me a lot, thanks... :C
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
//G930A\\ Oreo 8.0 Latest Stock ATT Odin files G930AUCUBCTB1
Full ODIN stock ATT files. Download one file, unzip to 4 files, put in ODIN and flash. I take no responsibility if anything goes wrong. You don't need to be on certain baseband to flash this, you can flash this directly from any baseband version...
forum.xda-developers.com
Sebas310 said:
//G930A\\ Oreo 8.0 Latest Stock ATT Odin files G930AUCUBCTB1
Full ODIN stock ATT files. Download one file, unzip to 4 files, put in ODIN and flash. I take no responsibility if anything goes wrong. You don't need to be on certain baseband to flash this, you can flash this directly from any baseband version...
forum.xda-developers.com
Click to expand...
Click to collapse
Would you know what would cause the recovery/boot program to update system - show Erasing after flashing ? Thx in advance!
I have a Samsung Galaxy S7 G930AUCUBCTB1 purchased in Colombia, I need help! I've upgrade it to 8.0 and the phone has signal, detects the sim but Emergency calls only. I want to downgrade to 6.0 but I cannot find the proper firmware that works. Any help?