yes I'm 100% sure that the speakers have some problem but i don't know how to fix it...
on my previous experience i find some from now i find sound really soft and low than before...
in room it can be heard but when im in classroom/big areas i find that it can't be heared....
how shall i fix this issue?
Goto settings then Apps and click on audio effects, click clean data and turn off your phone, leave for a minute and turn the phone back on :good:
Related
I notice that every now and then my tytn speakers make that typical noise you get when your mobile is close to a loudspeaker. Sounds rather cheap. My wizzard never did that.
Does anyone else have this?
Haventh had that problem. Speakers work fine, no interference.
Don't meet this problem yet
pvh said:
I notice that every now and then my tytn speakers make that typical noise you get when your mobile is close to a loudspeaker. Sounds rather cheap. My wizzard never did that.
Does anyone else have this?
Click to expand...
Click to collapse
Actually I suffer from something else:
While the volume of the loudspeaker in speaker phone mode is far too loud (and toggling it to minimum alsomost changes nothing), the volume in handset mode is far too low (increasing the volume also doesn't help here).
In speakerphone mode thus the sound is actually distorted because of the overwhelming volume.
As in both cases the loudspeaker is the same this can only be an issue of initial settings somewhere in the handset, worst case hardcoded in the ROM.
If anyone knows an appropriate reg tweak I'd appreciate that a lot.
Otherwise I hope that this be included as a substantial improvement in any future firmware update (mine is 1.18, German localized, but generic = no operator binding).
I wonder if anyone else with same firmware version experiences the same.
ghl10000 said:
pvh said:
I notice that every now and then my tytn speakers make that typical noise you get when your mobile is close to a loudspeaker. Sounds rather cheap. My wizzard never did that.
Does anyone else have this?
Click to expand...
Click to collapse
Actually I suffer from something else:
While the volume of the loudspeaker in speaker phone mode is far too loud (and toggling it to minimum alsomost changes nothing), the volume in handset mode is far too low (increasing the volume also doesn't help here).
In speakerphone mode thus the sound is actually distorted because of the overwhelming volume.
As in both cases the loudspeaker is the same this can only be an issue of initial settings somewhere in the handset, worst case hardcoded in the ROM.
If anyone knows an appropriate reg tweak I'd appreciate that a lot.
Otherwise I hope that this be included as a substantial improvement in any future firmware update (mine is 1.18, German localized, but generic = no operator binding).
I wonder if anyone else with same firmware version experiences the same.
Click to expand...
Click to collapse
Thats true, got the same problem. Voice is too loud in speaker mode and too silent the regular way. Haventh had time to explore this issue more. Had this problem in every rom I've tried. Hopefully they will fix it in future roms or something.
Yep have noticed the same problems also - sometimes the "mobile next to the speaker" issue occurs and the loud / soft thing too.
same **** here ... also my crt monitor @ work is flickering every 15-20 mins ... damn ...
Hi!
A couple of months after I bought zuk z1, the sound just disappeared for notifications and when music was played through speaker, the speaker would make buzzing noise and it would fluctuate. Also, the sound level would fluctuate without even me touching the volume buttons. Sometimes, when I decreased the volume and increased it, it wouldn't increase and if I decrease it to zero, then even when I would increase it to full I wouldn't hear anything.
Flashing nuclearom fixed everything except the buzzing sound. To get rid of buzzing, I installed Viper4Android but instead of fixing it has brought back all the problems that existed earlier.
Also, the problem is only with phone speaker. The headphones and everything work fine.
Please help me!! I don't think it is a hardware issue because all these problems turn up on their own and they get fixed on their own for a time being.
Crowbro said:
Hi!
A couple of months after I bought zuk z1, the sound just disappeared for notifications and when music was played through speaker, the speaker would make buzzing noise and it would fluctuate. Also, the sound level would fluctuate without even me touching the volume buttons. Sometimes, when I decreased the volume and increased it, it wouldn't increase and if I decrease it to zero, then even when I would increase it to full I wouldn't hear anything.
Flashing nuclearom fixed everything except the buzzing sound. To get rid of buzzing, I installed Viper4Android but instead of fixing it has brought back all the problems that existed earlier.
Also, the problem is only with phone speaker. The headphones and everything work fine.
Please help me!! I don't think it is a hardware issue because all these problems turn up on their own and they get fixed on their own for a time being.
Click to expand...
Click to collapse
Seems like you have nearly the same problem with the speaker:http://forum.xda-developers.com/zuk-z1/general/low-speaker-sound-t3500648
I think the sound problem could be an hardware issue
strongst said:
Seems like you have nearly the same problem with the speaker:http://forum.xda-developers.com/zuk-z1/general/low-speaker-sound-t3500648
I think the sound problem could be an hardware issue
Click to expand...
Click to collapse
I said it's not a hardware fault because sometimes when I would clear data and cache of Audio FX and force stop it, everything would come back to normal. However it worked most of the times but not always.
Crowbro said:
I said it's not a hardware fault because sometimes when I would clear data and cache of Audio FX and force stop it, everything would come back to normal. However it worked most of the times but not always.
Click to expand...
Click to collapse
And without audio fx? Did you wipe system, data every time you install other roms?
When I would force stop audio fx the sound would become normal. Yes. I follow the normal procedure before flashing roms which includes wiping everything.
I forgot to mention one more thing. The ringtones would work when there was no notification sound. And after I unlocked the bootloader, the notification sound problem was gone but the buzzing remained. I know it sounds freaky.
And if it's hardware or speaker problem the buzzing shouldn't be there at low volume. But in my phone, it's always there. In my experience, I feel like it's a software bug. When i listen to some song and it buzzes, I can notice that the volume increases and decreases on it's own as if the system is trying to create a balance.
Does anyone else find the sound through the phone speaker to be extremely loud and a lot of background noise?
I'm on Helios ROM with Apollo kernel.
In case anyone is interested... I fixed this lol.
You turned down the volume?
Gleetch said:
You turned down the volume?
Click to expand...
Click to collapse
Not far off. Developer setting in viper4android appeared to keep phone audio high and fizzy. Turning it off aspirated to stop it for some reason.
audio is now ok after a full factory reset , but still led notifikation light problem use this fix
https://forum.xda-developers.com/showpost.php?p=71422630&postcount=7
STILL NOT FIXED
I have rooted and unlocked my Axon 7 (A2017G) and edited the mixer_paths.xml file to make the audio output louder.
But there's a little problem (and I don't know if it's because of the mixer paths edit, I don't think so)
My top speaker sounds a lot more dull than my bottom speaker. My bottom speakers seem to be louder too.
How to check this? And are there more people experiencing this?
Thanks in advance.
Did not do anything to my A2017G, but I find that my top speaker is louder and "sparks" when near at full volume
nigelnkj said:
Did not do anything to my A2017G, but I find that my top speaker is louder and "sparks" when near at full volume
Click to expand...
Click to collapse
Some say it's dust, but I don't know how. I haven't called with this phone much.
Bump. It's everywhere. Even on LineageOS, bottom speaker is almost twice as loud :/ It can't be dust.
BUMP
This problem is getting on my nerves. The bottom speaker is twice as loud and crispy as the top speaker, which sounds dull.
Anyone else had this and possibly fixed it?
Two questions
Did you try to reset your phone and test the speakers again?
Is there the same problem on YouTube and mp3 music files?
SilentEYE said:
Two questions
Did you try to reset your phone and test the speakers again?
Is there the same problem on YouTube and mp3 music files?
Click to expand...
Click to collapse
1. Yes I switched between roms to test modems and other stuff for ZTE.
2. Ofcourse. It's obviously the same on every output.
I guess it's just a hardware fault, but I thought maybe someone would have fix (clean it or something?)
Then I would say that this is an hardware problem indeed.
Having the same issue here, thought that other ROM will provide the fix but still zilch. Rooting the phone only meant the void of guarantee so not really good move there either.
I read somewhere online that usually bottom speaker is the one to go out first and that global version has the speakers a lot different then American and Chinese version). Any other possible fixes before replacing it? And where to find the replacement too?
Update: it should be software related since the sound in earphones has the same problem - only inverted. Which means there should be a tweak in binary or something?
I'm willing to pay to whoever makes this problem disappear. I'm beyond the point of helplessness here...
Fixed!
Fixed the issue finally! ??
Go to:
- settings
- advanced settings
- accessibility
- mono speaker output.
For the last trick to work, just try to disable it, then enable it and restart the device. Disable it again when device rebooted. Worked as a charm for me! So I'll be saving me some money ???
oFFgotoFF said:
Fixed the issue finally!
Go to:
- settings
- advanced settings
- accessibility
- mono speaker output.
For the last trick to work, just try to disable it, then enable it and restart the device. Disable it again when device rebooted. Worked as a charm for me! So I'll be saving me some money
Click to expand...
Click to collapse
Omg! This problem was bugging me since day 1, but could not find any solution to this... But I've tried what you said and it works wonders! Can't believe I can now finally listen to music the way it was intented, since having a speaker with lower volume on a stereo setup is very annoying. Thank you very much for sharing the solution with us!
Andrew-X said:
Omg! This problem was bugging me since day 1, but could not find any solution to this... But I've tried what you said and it works wonders! Can't believe I can now finally listen to music the way it was intented, since having a speaker with lower volume on a stereo setup is very annoying. Thank you very much for sharing the solution with us!
Click to expand...
Click to collapse
You're welcome buddy, I can imagine your happiness and that smile is thanks enough. Cheers.
Ever since I upgraded to 8.1 OPM1 last month, my car no longer plays it's default generic ringtone when a call comes in. I have basically done everything I can to fix this but nothing is working. Anyone else having this issue? The only thing that remotely works now that didn't before is if my phone volume is ON, it will play my phone's actual ringtone through the speakers on the car but that defeats the purpose. I have my phone on vibrate nearly 100% of the time and when I get in the car, I don't want to have to turn on the volume to hear the phone ring. I have completely reflashed the image multiple times, reset my settings in my car, pair/delete/re-pair multiple times, turned off media streaming on phone, but nothing is working. The only thing I haven't tried is completely factory resetting my car's MMI system. There have been no updates to my car either. I contacted google support/nexus forums but they didn't think it was a bug in 8.1 even though the issue started with 8.1 and was find on 8.0 and below. I still think this is an OS bug. For reference, I have a 2014 Audi S4 with the MMI 3G+. I am thinking about pairing my phone with my wife's car to see if it works with hers. I have not gotten the January OTA yet but will probably manually flash it if I don't get it tonight or tomorrow. Any ideas?
@jrg67 Enable developer options and I believe theres option in there to fix your issue.
My Bluetooth crashes on my phone now when I connect to my stereo ever since the 8.1 update. No problems on other Bluetooth devices like speakers and headphones. My Clarion CX505 has the latest updates. The January security update didn't help the problem for me.
Exodusche said:
@jrg67 Enable developer options and I believe theres option in there to fix your issue.
Click to expand...
Click to collapse
Exo, I had Dev options enabled already and from what I can see in your screenshot, my settings are the same except for disable absolute volume which I have on (my jbl speaker doesn't like to play nice sometimes and when I connect, it's max volume for no reason). So do you have any specific settings in there that you have played with? The only thing I can think of would be the streaming codec. As stated in my original post, I do not recall my phone ever playing the phones ringtone over the car speakers no matter what. Even if I had the volume on, my car would always play the generic tone which I prefer. Now, it'll play my phones ringtone over the speakers only when the volume is on and the phone's volume setting effects the volume that's coming out of the car speakers too. It's super annoying and I honestly just want it back to the way it was. Now, I'll get a call while driving and my entire system goes silent and the only indication of a call I get is a faint vibrate buzz sound from my phone sitting in the cup holder and my MMI screen which I have to take my eyes off the road to verify wtf just happened.
Very strange and sorry I guess I didn't read through enough of your post. The only issue I have is when I first get into the car must turn the Bluetooth on my phone off and then on again after first connect in order to play music. Hope you can figure that out sounds super annoying.
Well for anyone who may have this issue, I finally figured out a work around. Go in to Dev options and turn off "Enable in-band ringing". I then turned BT off/on, tested and now working as it used to. Never noticed that option in there before today but honestly haven't spent much time on it. Cheers.
MT63 said:
My Bluetooth crashes on my phone now when I connect to my stereo ever since the 8.1 update. No problems on other Bluetooth devices like speakers and headphones. My Clarion CX505 has the latest updates. The January security update didn't help the problem for me.
Click to expand...
Click to collapse
Did you ever find a fix for this? I have the same issue.
microbius said:
Did you ever find a fix for this? I have the same issue.
Click to expand...
Click to collapse
Nope, I got a Pixel 2 XL that has 8.1 with the Feb patch and it does the same thing. I may try reapplying the Bluetooth update to the radio and see if that helps.