hi guys.too day decide to root my s7 spriny .so i found this website
http://www.androidexplained.com/galaxy-s7-root-verizon-att-t-mobile-sprint/. i follow the steps
after flash the root boot(.tar) and i get passed from odin .after restart i got bootloop . i hop you guys help me.
Check out the thread for rooting the phone it goes over this. Basically have to do a factory reset.
Sent from my SM-G930P using Tapatalk
Related
Hey,
I decided after a couple of months to finally root my Nexus 4. I followed a manual guide, I didn't want to use a toolkit because I'd figure I'd learn it the proper way. Anyhow, If I go to the bootloader it clearly says it's unlocked. As the guide told me I then went into the clockwerk recovery and installed SuperSu 1.89.
I then proceed to restart my Nexus 4 to then be told that by SuperSu that there are no binaries installed and thus has no root access. It has been driving me nuts and I have spend 3 hours troubleshooting with google searches and experimentation because I hate to just make a thread without researching myself first. what am I missing?
Thanks, a lot.
Alibambam said:
Hey,
I decided after a couple of months to finally root my Nexus 4. I followed a manual guide, I didn't want to use a toolkit because I'd figure I'd learn it the proper way. Anyhow, If I go to the bootloader it clearly says it's unlocked. As the guide told me I then went into the clockwerk recovery and installed SuperSu 1.89.
I then proceed to restart my Nexus 4 to then be told that by SuperSu that there are no binaries installed and thus has no root access. It has been driving me nuts and I have spend 3 hours troubleshooting with google searches and experimentation because I hate to just make a thread without researching myself first. what am I missing?
Thanks, a lot.
Click to expand...
Click to collapse
If you flashed the correct Supersu zip, then it should have also installed binaries. Did you install the zip from Chainfire's site?
Try flashing it again. Sometimes it doesn't seem to stick.
Sent from my Nexus 7 using Tapatalk
Last night my battery got down to 5% or so and out of the blue my phone restarted and ended up in basically a boot loop (It would let me use it for about 1 minute before rebooting). I tried everything I could think of and eventually gave up and did a hard reset. Now I can't get it to go past the Verizon logo.
I guess the next step is to re-load the software via Odin, but wanted to double check before I broke something because I am on OE1 rooted via Munoz's thread.
Best I can tell I need to load the NCG complete and then use flashfire to upgrade to OG5. Correct?
Thanks for the help.
jonnio said:
Last night my battery got down to 5% or so and out of the blue my phone restarted and ended up in basically a boot loop (It would let me use it for about 1 minute before rebooting). I tried everything I could think of and eventually gave up and did a hard reset. Now I can't get it to go past the Verizon logo.
I guess the next step is to re-load the software via Odin, but wanted to double check before I broke something because I am on OE1 rooted via Munoz's thread.
Best I can tell I need to load the NCG complete and then use flashfire to upgrade to OG5. Correct?
Thanks for the help.
Click to expand...
Click to collapse
u can downgrade 4.4.4 NK2 stock firmware then install NCG kernel for root by towelroot offline version by geo hotz after root reflash NK2 kernel
or u can flash stock 5.0 OG5 directly if u want
make sure repartition is uncheck in odin
I went ahead and flashed the older Firmware, re-ran towel root and upgraded. Seems to have fixed the phone, thankfully.
So the first time I got the phone, I rooted it. I used this method http://forum.xda-developers.com/s7-edge/development/sm-g935-exynos-cf-auto-root-t3337354 with odin. Can anyone help me have twrp on my phone without doing a factory reset? I found the other ones too complicated because I'm a noob at the odin stuff (I owned a Nexus 4 before, it was easy as cake there).
Thanks
Hi,
I purchased a locked Samsung S8 G950U in July from AT&T. I was disappointed to learn there wasn't a root out for it yet, but figured I could live with it until a root was released. I checked XDA yesterday and saw that a relatively simply root method had been posted. I tried following the PartCyborgRom method for rooting the phone. I was able to get into download mode and load into BL. I then followed the instructions and loaded in the AP file. The phone then asked if I would like to reboot. I was very happy as it appeared I had successfully gained root access. I rebooted the phone.
Now, the samsung logo pops up, but with lots of junk at the top. It then goes into a screen which shows "KERNEL PANIC" and several other errors. Seemingly ranomdly, I am able to get back into the download mode warning screen. I have tried the SamFAIL and SamPWNED methods to root since then, but none have worked.
What should I do? Can someone help me successfully root the phone? If someone is able to help me root the phone, I can offer a small bounty reward as loing as it is not against the rules.
edit: If someone would like to walk me through the root one on one, please PM me and we can go to discord or the client of your choice
You can unroot using official rom or using smartswitch. and for yor model cant help you much there is not much for the snapdragon models.
---------- Post added at 08:56 PM ---------- Previous post was at 08:50 PM ----------
But on the other hand i had a look in the guide of the rom for your device and is not as easy as you say there is several steps you had to do also did make sure you flashed the righ modem and bootloader for your device do you hace working costom recovery on you device ??
Also, if you don't need rooting that much, I think you can revert back to stock firmware using ODIN?
5dscr said:
Hi,
I purchased a locked Samsung S8 G950U in July from AT&T. I was disappointed to learn there wasn't a root out for it yet, but figured I could live with it until a root was released. I checked XDA yesterday and saw that a relatively simply root method had been posted. I tried following the PartCyborgRom method for rooting the phone. I was able to get into download mode and load into BL. I then followed the instructions and loaded in the AP file. The phone then asked if I would like to reboot. I was very happy as it appeared I had successfully gained root access. I rebooted the phone.
Now, the samsung logo pops up, but with lots of junk at the top. It then goes into a screen which shows "KERNEL PANIC" and several other errors. Seemingly ranomdly, I am able to get back into the download mode warning screen. I have tried the SamFAIL and SamPWNED methods to root since then, but none have worked.
What should I do? Can someone help me successfully root the phone? If someone is able to help me root the phone, I can offer a small bounty reward as loing as it is not against the rules.
edit: If someone would like to walk me through the root one on one, please PM me and we can go to discord or the client of your choice
Click to expand...
Click to collapse
If you followed the directions as clearly written in the OP of the thread then you did not do what you said above, as those are much certainly the directions. There is also discussion in the op and throughout the thread your exact problem is and what to do about.
They are all right though, easiest and most direct method is to just flash stock. Partcyborgrom uses the SamFail method (hint: i developed both) and sampwnd is v1 firmware only
Hello guys..
Firstable really sorry for creating new topic.!
Im very disapionted and frustrated and i will be gratefull for help.
Im trying to root my Huawei P Smart.
Last three days im trying but without solve!
Few weeks ago i rotted my older phone samsumsg galaxy Note 4 folowing the video tutorial and works great.
But with this phone i simply cant..
Im not that experienced but im trying to understand and find the way where should by myslatake.
I followed many videos on youtube .
Firstable i unlock the Bootloader and FDR.
after that i nstall new drivers to my PC. then i run CMD there problem starts..ADB - out of date killing..I fixed but when i copy TWPR in to the CMD that telling me the Failed problem with a partition.
I as well try king root ,kingo root from pc and from android phone too..
Always frozen by 1% king root. Kingo root 90% black screen and as well teling me there is virus.
Anyone can please spend some time and help me?
I will be very gratefull!
Thanks!
I finally manage to fastboot TWPR following the steps by :
https://forum.xda-developers.com/general/general/how-to-root-huawei-p-smart-fig-lx1-t3752705
but with some reason when i installing Magisk zip and rebooting system doesnt shows in a phone and root checker telling me the phone is not root.
Any advice what im doing wrong please?Thanks!