Hello.
So I just downloaded the TWRP, and flashed it into my phone using Odin.
What's the problem is, odin flashed twrp successfully into my phone with PASS message. and my phone restarted. Then when i tried to launch it into the recovery mode, using vol up+power+home, there's no changes in the recovery mode. No TWRP recovery, my phone still using the stock recovery.
Tried to flash philz recovery with "Set warranty bit: recovery" error, neither flashed the mohan root and still got the same error.
Any help with the problem? Thank You for any further helps.
Currently using Android 5.0.2 with G530HXCU1BPE4 Firmware (https://samsung-firmware.org/downlo...al Sim)/27O0/SER/G530HXCU1BPE4/G530HSER1BPB1/)
*here's the mohan root method http://www.phonehorn.com/2014/11/root-samsung-galaxy-grand-prime/ (worked before with my past firmware with Android 4.4.4)
Philztouch and that root file may be only for Kitkat.
You can try Kingroot+SuperSume
Related
I upgraded my Note 3 (N9005 LTE) to ofiicial kitkat 4.4.2 with Odin. I'm also rooted and everything working flawlessly, except I can't install neither TWRP, or CMW recovery, i tried both but geting bootloop with following messages:
Kernel is not seandroid enforcing
set warranty bit: kernel
And it just getting bootloop over and over. I can force download mode, and restart phone, and everything works great, except recovery.
I flashed recovery trough Odin, it's note first time I'm doing it, I followed instructions carefully, so doubt it was my error.
NOTE: After flashing CMW, after couple of bootlops,ODIN actually said PASS, still can't acess recovery, though...
Hope someone have a solution for this?
Thanks in forward
Make sure you are using the most recent recovery version:
[CWM] Kitkat compatible version by Chenglu
[TWRP] Kitkat compatible test version by the twrp maintainer
[TWRP] My (unofficial) kitkat compatible version
I am not getting bootloop but..
I do not have bootloop, but when I try to enter recovery mode the phone it says: Secure Fail Recovery. Then below the yellow triangle it says, System software not authorized by Verizon Wireless has not been found on your phone. Please turn off your phone and go to the nearest store for help. I was installing CWM for the Note 3. Anyone know how to fix this and install a custom recovery? I cannot enter recovery at all.
Hello guys,
I need help My Samsung note 3 n9005 was rooted before and i flashed the stock rom on it and try to root it again. i was able to finish flashing CWM by using odin no problems encountered, but when i tried to install supersu by booting my phone to recovery mode it shows . recovery booting.. seandroid enforcing and after the phone reboots and boots to normal mode.
I already tried different version of Odin and CWM, also tried TWRP and Philztouch but still no luck.
I know i can access superuser by using CF auto root by cf auto root comes with default recovery and wasn't able to install custom roms via zip file.
i hope you all guys can help me out here.
TIA.
I have a Note 4 - 910G (India) currently running 5.0.1
I have managed to root the device. I can confirm that I have root access with an app like root checker. And yes, I've managed to trip Knox. At the custom boot screen, it shows Knox status as 0x1 (4).
My problem is that I can't install TWRP or any other custom recovery. I have followed the usual steps to install a custom recovery with flashify, TWRP installer and adb commands. Each time I try, the device reboots into odin mode (high speed) mode only. I then have to flash a custom recovery with Odin and the device reboots. However, even then.. if I try to boot to a bootloader, it still goes into the odin mode.
Is my device completely borked? Can I still install TWRP and then CM12.x on the device?
Any help/pointers would be appreciated.
I too have a note 4 sm-n910G. I think ur TWRP file is corrupted or you got the wrong file. It should be easy to get custom recovery. I rooted my Note 4 using CF auto root and it had CWM recovery which i tried to flash in Odin but it wasnt working. So i changed to TWRP 2.8.1.0 and it worked perfectly. Maybe try changing the TWRP file, or use a different one like CWM or philz recovery. Good luck...
Hi, just got me a klte device to play around with..ive managed to root device using odin and chainfires auto root file..now ive succesfully flashed latest twrp using odin..but device wont boot into twrp recovery..what am i doing wrong?
Medyredy said:
Hi, just got me a klte device to play around with..ive managed to root device using odin and chainfires auto root file..now ive succesfully flashed latest twrp using odin..but device wont boot into twrp recovery..what am i doing wrong?
Click to expand...
Click to collapse
I vaguely remember having that same problem with my note3 long back..i had issues booting into custom recovery..i must be doing something wrong then..
Medyredy said:
Hi, just got me a klte device to play around with..ive managed to root device using odin and chainfires auto root file..now ive succesfully flashed latest twrp using odin..but device wont boot into twrp recovery..what am i doing wrong?
Click to expand...
Click to collapse
Try flashing philz recovery and see if you can boot in to recovery. If so, then flash TWRP once again and check.
Are you holding power and volume up and home while the phone is off? If not try a different version. I'm using TWRP 3.0.2.2 klte and it works ok
I have Note 4 model N910H firmware 5.1.1 and I rooted it using chainfire method. I checked using root checker and it says my phone was rooted properly. So I install TWRP latest recovery using flashify. The phone rebooted to recovery mode fine but it says that my phone not rooted so I'm confused and I let TWRP rooted it again. After that I reboot to system and I can't enter it instead it was stuck looping samsung and android logo.
So, what can I do? I can enter TWRP recovery and download mode. I know I can flash it to stock 5.1.1 but I dont know what version to use from SamMobile (XID/XSE, I'm from Indonesia) and there's different PDA/CSC version. So if I just pick one of them and flash it to my phone will it be okay? I want to avoid flashing to be honest because the rom size is so big so is there's a way to fix it without flashing?
Any help would be appreciated. Thank you.