Hi guys, I have set up "my places" in order to use power saving and other settings when phone is connected with my car's bluetooth. The problem is that after I disconnect the phone from the car, the power saving mode and the other settings still remain activated. How come?
Sended from my Samsung Galaxy S7 Edge Gold Platinum
Related
My phone is fine on Edge but as soon as I connect it to Active Sync, it looses its Edge and uses WiFi. Once I remove the active sync, it never connects back to Edge unless I reboot the phone. It keeps saying it cannot dial wap.cingular. I thought the phone was supposed to auto connect on its own to the best connection and switch back. I checked with Cingular and all my settings are what they should be and the Cingular tech had no idea.
wydeload said:
My phone is fine on Edge but as soon as I connect it to Active Sync, it looses its Edge and uses WiFi. Once I remove the active sync, it never connects back to Edge unless I reboot the phone. It keeps saying it cannot dial wap.cingular. I thought the phone was supposed to auto connect on its own to the best connection and switch back. I checked with Cingular and all my settings are what they should be and the Cingular tech had no idea.
Click to expand...
Click to collapse
Mine does the same - it finds itself without the reset though. It just takes it a little bit.
I've disabled the notification on my phone that tells me when I am connected to a wifi network, and when there are open networks available. Unfortunately I still see them regularly on my Samsung Gear Live watch. Is there a way to disable them on the watch also? It's very annoying to be constantly reminded that I am connected to my home network, when I am at home. And to have the bottom third of the watchface covered by the card when I am out-and-about.
For some reason my S7 always starts the wifi connection after booting up. Can this be disabled ? I only want to connect to Wifi manually.
Also now Wifi is disabled with screen off, which is OK, but I don't want Wifi automatically reenabled after lockscreen is disabled.
PS. How come I can't post in the noob section ?
I am not sure what the problem could be or whether I have to change some settings but my phones wifi as well as the Bluetooth don't work as expected.
I connect to the wifi at home, then if I go out i switch it off, when later in the evening I turn it on again, it doesn't auto connect (despite me clicking the auto-connect checkbox when putting the password) and I have to go back to settings click on the desired wifi and put the password again; this happens also when I restart my phone( it keeps asking me for my password)
The same goes with the bluetooth, on my s6 it would connect automatically to my car Bluetooth once I went through the initial settings, now even after the initial pair, it doesn't connect unless I put my bluetooth device on discovery mode again.
It's a rooted s8 with MAGISK,twrp installed on it.
I have tried to reset network and other setting,clear cache but no success.
any advice?
bump
So I hit monitor mode and then go to smart view on my galaxy s7 it sees my lg v530 and a screen pops up on my v530 asking to accept the invite. I hit accept and a screen comes up in the blurred background then disappears and both screens close the connect screen on the v530 and the smart view screen on the galaxy s7.
Both are on the same wifi router with no internet connection at the moment. Its screen mirroring I'm after. It shouldnt need to go out to the internet from the galaxy s7 only to come back from the internet to display on the v530. That would be insanely inefficient and just plain stupid. It should just send data over the wifi lan from one device to another.
As far as I've read screen mirroring can and will work with no internet connection exatly how i explained it should work so.... why doesnt it work? What am I missing?