Related
I'm new to flashing custom roms and what not. I used odin and flashed everything to the point, csc, modem,pda,pit the rom works awesome but i cannot for the life of me connect to the internet. the 3g icon or h icon wont' show up. in the status it says my network type is gprs and i'm roaming and my mobile network state is disconnected.
I'm with fido, the phone is unlocked i have never had trouble with data or anything until i flashed to a custom rom.
Anyone have the same problem or suggest how to fix?
Data Conn. Issue
Hey mate,
Have you gone into 'Settings', 'Wireless and Networks', 'Mobile Networks' and then 'APN settings' and entered your appropriate settings?
That should fix it if you define the correct access point.
Alex
hey man, yeah i did all that stuff, went in there, found my carrier, put in all the apn settings i can find and still nothing. when i put data roaming on then i get data and the edge icon comes up.
Hey dude,
That sounds strange, flashing custom (or even release) roms is never a guarantee especially with weaknesses in the way that ODIN communicates with your phone, What I would do is Re-Flash your stock rom through ODIN then use the "quick" install method from Darkyy.
I am running 5.6 like you, and I had issues doing it through odin (I kept getting random FC's), additionally, the rom; if installed from CWM will keep your apns and apps e.t.c. along with many settings and configs from the base rom you're using before the flash.
That is the best advice I can give you.
Alex
My config is a follows:
I9000 International
16gb SDHC
500HZ Hardcore Kernel
Darkyy 5.6
Whats the process for reverting back to stock 2.1 eclair rom?
Did you keep a record of your firmware version before reflashing?
If not, you may have to ask someone on here what your base firmware was.
Are you familiar with using ODIN? (The software used for reflashing)
Alex
I am having same issue to...I used 5.4 from Darky and it works well...same with DocRom 4.0 works and the next 5.1/6.0 don't work.
Both Darkys and DocRom are based some JPX....which seem to be root cause..
I've have the same problem. Tried eveything but still didn't work. So went to Samsung Service Centre to have my SGS firmware refresh. I notice after the refreshed same issue of data com missing. Told them and they when into the SGS to select the telco operator setting selection. Now data com. working well. Anyone know the SGS handset setting code? I want to reload to Darky's v5.6 again.
hi folks
i have the same problem... my provider is a virtual provider in the network of our biggest provider here in austria. i was using doc's rom based on xwjpa firmeware and everything worked fine without enabled roaming options.
since doc's rom is based on the newer releases (xxjpx, xxjpy) i' only able to use data connection if i turn on roaming. it also shows me that i'm in a roaming network. i guess the cause are the xx firmwares. xw and xx are european firmwares but i do not know the differences between them. maybe someone has more information about the differences? currently i'm using xwjpa firmware because i don't want to use my phone with enabled roaming options.
hey um i'm having the same problem and thought replying here would be better than starting a new thread.
well i installed the rom without having any idea of what i was doing *stupid idea* so i didn't take note of my original firmware.
i didn't use odin to install the rom just clockwork recovery and the rom and everything installed fine except my data network. i can get signal, call, receive the only problem is i get no data transfer. any help much appreciated. if anything can someone help me step by step to reboot my phone to original?
just for future travellers
Sadly this isn't my own gem, but yeah. hold the power button down, wait for the shutdown menu, above the airplane mode there is a data network button, and it'll most likely say "de-activated" if nothing else has worked. Its ok to feel like a chump, I did after rehashing the hell out of this phone for a few days ( the wifes phone, my phone does exactly what its told. )
Anyway, yeah, this will probably be the reason for the lack of the icon "G", "3G" or "H" where it should be.
Dave.
I just flashed to the lastest LeeDroid ROM. I love it! However, there is no mobile data. I cannot make or receive calls. The mobile data setting is greyed out, I cannot change anything there.
I've tried searching for similar problems with leeDroid, but I have not found much. Does anyone know how I can fix this??
HTC Inspire 4G on AT&T network.
Full wipe and re-flash, and see if that works.
If not it's possible you have an incompatible radio/ril/rom combination; make sure you use the recommended radio for your rom.
I try to avoid flashing radios as much as possible because if something goes wrong, it will permanently brick - so read all the instructions *very* carefully and only do it if you have to!
I installed that ROM too and lost my data connection. But there is a patch, V5.1.1 that'll correct this problem. Just download and flash it in cwm.
Sent from my HTC Desire HD A9191 using Tapatalk
Open the dialpad,
key in : *#*#4636#*#*, as soon as you key in last *, Setting Menu will pops up.
>> Click "Phone Information'
Scroll down.... until you see "Set preferred network type", probably set to "WCDMA preferred".
If you are on GSM network, change to "GSM auto (PRL).
Out from the menu... then see whether mobile signal on...
to make sure, re-boot.
Some rom, even set "WCDMA preferred" as a default, still can connect to GSM network some doesn't.... So manually set as above will be the best way, I think.
Hope can be solved, buddy.
sounds like the radio needs a re-flash, flash the recommended or latest one.
Install Latest update on your Rom
zunaedsaki is cooking
im having the same problem. For whatever reason clockworkmob wont let me flash any ROMS at all. i dont understand what the deal is.
Guys, i had this problem on my I9001 but the solution is very simple...
1. Get an android phone (your dads, sister's or brothers or whoever's) and insert your sim in it then browse to APN settings.
2. Copy down the information.
3. Insert your sim back into your phone.
4. Go to APN settings and manually type all the information
you will get your mobile data working...
First off I'm using an unlocked S5 on straight talk's LTE network, have been for about 9 months with no problems. I've talked to support twice and they reactivated networks and all that good stuff, and when none of that worked sent me a new sim, which I have just activated and it still didn't fix my problem - so I'm finally bringing my issue here.
Last week I decided to update from phoenix rom oc4 (I think it was oc4) to optimal rom og5 (15-5). Anyway I was hasty in flashing and messed up, so just went back to stock ncg > root > full wipe > flash firmware, rom, kernel, firmware again just to be safe. The rom works fine except I seem to have lost my data connection. The 4G icon still shows, but it's not filled in - as you can see in the screenshots. To make it even more strange, when I check the network and sim card in apps like Advance Signal Status and Sim Manager, I still seem to be getting a connection to 4G but there is just no data flowing. The only error I can see is in phone info, when I run a ping test, I get PingIpAddr: Fail: IP addr not reachable which you can also see in the screenshots. It would appear this is my problem but I don't know where to go from here. I'm going to start flashing different versions of modems, starting with oc4 to see if that helps. Then I'll probably try different roms, but I've flashed other roms trying to fix this and even restored the backup to when it worked and it still didn't fix my problem. Did I wipe my IP address or something maybe? I am in CDMA/LTE mode, and the vzwinternet apn is selected.
For starters try to put the apn settings for your carrier and if not sure call them and ask them to email you the setting
I fixed it, went back to stock ncg instead of ni2 and that worked. Weird.
Hi, I'm having a very perplexing issue. For the last few months I have been running cm13 on my phone but recently it decided to not revive/send texts or calls but still got 4g and signal. I hadn't updated the rom or anything so that wasn't the fault. Looking at the sim card info in the setting it says it's in service and everything, but says the "cellular network state: Disconnected". I've reflashed to a touchwiz rom and everything worked fine. So far I've tried different cm roms clean and dirty flashing, flashing just the modem on to the cm roms, restoring from old backup before all this, replacing the sim card. For awhile I though it was the APN settings weren't right, but the cm apn settings matched the TouchWiz ones. I've also tried different unbootlocking methods, didn't help. Worked with an unlocked bootloader running touchwiz. My brother has been running the same phone and rom I was and hasn't had any issues. I'm out of ideas on what's causing this right now, hoping some can help.
Had something similar happen. Try changing the APNS till you get a single
Changing preferred networks might help too
So I have been using MetroPCS on my Moto G5 Plus since I got it. Well today I went and activated my device with the Sprint network... It wasn't working when I left the store, and I told the rep how it was modified (using RessurectionRemix 5.8.4 Final), that I would work on setting it up.
Well, so far no success in activating it... Have tried changing network mode to CDMA/LTE and messing around with dialer codes, still can't get anything besides "emergency calls only."
Anyone have experienced getting this phone activated with Sprint?
Note: they did tell me they didn't have the exact, or "recommended," SIM card for my device, and that it was a secondary option they used in the system(?).
laserswift said:
You need to get the Sim card part # that ends in 446c. I got mine at best buy for 10 bucks and it's currently working well with Sprint.
Click to expand...
Click to collapse
I am using that SIM, got it working when I reflashed stock. Did not work again when I restored RR, at least fully, as I was able to get data to work minus SMS/calls.
I'm on Sprint. No issues with any Roms.
You need to be on a stock build for the initial setup, because the custom roms remove all of the PRL stuff. Once it is setup once, flash whatever you want.
Karlinski said:
You need to be on a stock build for the initial setup, because the custom roms remove all of the PRL stuff. Once it is setup once, flash whatever you want.
Click to expand...
Click to collapse
It doesn't stick after I flash a custom ROM
That's really odd. I don't have that problem...
Make sure you have APNs on the custom rom. I saw a problem a while back that the custom rom didn't keep the APN for some reason, and I had to put it in manually. Different device, but same problem.
Karlinski said:
That's really odd. I don't have that problem...
Make sure you have APNs on the custom rom. I saw a problem a while back that the custom rom didn't keep the APN for some reason, and I had to put it in manually. Different device, but same problem.
Click to expand...
Click to collapse
Can you tell me what your APN info is? I have data and calling working now, but no LTE option (see screenshot)
I have mine set to global.
I had this same issue with my s6, and I ended up having to factory reset the phone, and redoing the PRL update, and the option finally came back.
Just to follow up, I was able to get full LTE and calls to work by flashing stock ROM, updating PRL, and by then it was provisioned on the Sprint network.
As it stands now, if I reinsert my MetroPCS sim card, it is provisioned for MetroPCS no problem, but I do have to reflash stock again each time I want to provision for Sprint.
So thats how I am going to run things for now, by making backups and getting it provisioned using stock before restoring.
this worked for me
sharpsan said:
Just to follow up, I was able to get full LTE and calls to work by flashing stock ROM, updating PRL, and by then it was provisioned on the Sprint network.
As it stands now, if I reinsert my MetroPCS sim card, it is provisioned for MetroPCS no problem, but I do have to reflash stock again each time I want to provision for Sprint.
So thats how I am going to run things for now, by making backups and getting it provisioned using stock before restoring.
Click to expand...
Click to collapse
theres an ap on the play store called apn backup and restore. install it on stock rom . b4 using it u need to go in system/apps and move the apk to system/priv/apps once moved changed permissions to r-w-r-r. after that a quick reboot and open app change setting to disable ics check and do a backup . once finished do the same thing on new rom and mine works flawlessly. im on boost which is also on sprint network. good luck hope this helps