Loose screen panel - Nexus 6P Q&A, Help & Troubleshooting

Hi guys,
Received my 6P today and noticed that the screen is slightly loose on the bottom left corner. It moves slightly if i pay close attention and push down with a bit of force.
Here is a picture where you can see the black of the screen slightly higher on the left side compared to the right.
http://imgur.com/L0roScO
Anyone else have this on any corners of their device?

Get a replacement. That is defective. Over time that will become a problem

Related

Few questions about X2

As a fresh owner I have a few questions:
1 - The lower right corner of the front panel wobbles (?), moves slightly on touch, I can press it for about 1mm (see the attached screen). It is especially annoying when pressing OK or dial off (or whatever the button is called). Is it normal?
2 - The screen has a slight green tone (hue), can anything be done with it?
3 - LCD has noticeable light leaking near the bottom side, again, is it normal? (Well, the screen does not work now anyway, gotta flash the phone.)
Thanks
Biges said:
As a fresh owner I have a few questions (too lazy to search):
1 - The upper right corner of the front panel is flimsy (?), moves slightly on touch. It is normal?
2 - The screen has a slight green tone (hue), can anything be done with it?
3 - LCD has noticable ligh leaking near the bottom side, again, is it normal? (Well, the screen does not work now anyway, gotta flash the phone.)
Thanks
Click to expand...
Click to collapse
(1) I have no issues with this, seams fine on mine
(2) I cannot notice any hue, maybe you have a faulty unit given the blue colour and the movement of the panel.
(3) Yes LCD light is noticible, I also get leaks through the optical pad when I have the notification LED's on
1. I got some small loose on the front pannel upper area, it's especially felt when You hold the phone in one hand and work with Your thumb pressing the screen or just put the phone to You ear. You feel then the pannel moves a bit down. Maybe thats normal or just the build quality is not so good at all.
sounds like you have a faulty one. mine is solid as a rock. the loose screen and the green hue could be related. there shouldnt be any discolouration at all and i can only see it getting worse to be honest. where did you get it? if its somewhere reputable then id take it back and ask for a decent one while its still in warranty.
i do have tiny bit of light leakage near the buttons, that does seem common.
Mine is well made too, no hardware problems.
I have a silver one, solid as a rock, light leaks are present though...

Screen glass uneven, or bezel?

When I first got my Nexus 7, I checked to see if there was any noticeable screen lift, and I didn't notice any. I could use my tablet without issue, and can still use it without issue.
Yesterday I decided to actually inspect my tablet over carefully though (was bored at the moment). Turns out, either the glass screen itself or the silver bezel is uneven? The glass either goes above the bezel, or the bezel goes above the glass, at a few random spots.
The top of the tablet is fine. The middle of the left side is raised a bit, the bottom of the right side is raised a bit, and the entire bottom isn't as far down as the top.
I don't have any poping/cracking noises when I press on the screen, and afaik, all touches are registered without issue. Everything seems to be working just fine.
There is a saying about not fixing what isn't broken, but, is there perhaps a way to make the screen go down below the bezel more evenly?

slight ridge effect?

i wonder if anyone else seems to see what i am. with the screen off angle the screen to reflect white light. you get a kind of rainbow pattern. this afaik is fairly normal. but i notice on the top edge of the screen the rainbowing seems to compress. im assuming this is because the mesh within the screen is crimped within a frame. what im noticing on mine is on the top left hand corner theres a tiny oval blob of the rainbowing as if the layers are seperating underneath the glass
is anyone else seeing it in the same spot or just me
bumpiiddy?
anyone else

[Q] Bad T230 screen?

So my wife got me the SM-T230NU for my birthday (end of September.) The screen quality isn't as expected. Seems like when I'm trying to read basic black text on white the screen is very grainy looking and hard to read. I went into Accessibility, changed the contrast size to medium, and manually adjusted the contrast. This seemed to help a little. In addition I seem to have, what I would say, is a lot of screen bleeding towards the upper right hand corner. No biggie, most devices have some. Unfortunately though what I just saw really concerns me. While doing a software update, it was on the black recovery screen with the android. I saw a smudge on the screen so I went to wipe it off. When I did so, about a quarter of the way down dead center, the screen started to flicker in an area about half inch tall and quarter inch wide. So I kept touching areas all around it and basically anywhere I touch on the upper half of the screen causes this. Have any of you ever experienced this before? If so, do you think this means that the screen is bad? I was going to just call Samsung but I wanted to see if anyone else had this on theirs. I couldn't find anything on Google. Thanks in advance!!

S8+ screen shadow on edges

Hello,
After I received the latest update which enabled more options like gamma in display settings I've noticed while browsing that on a full screen white background the edges tends to drop somehow a gray shadow.
While I think this is kind of normal because of the edge curvature, looking straight in the center of the phone, the right shadow is somehow more pronounced than the left one.
If I move the phone a bit to the left or turn it few degrees to the left, the right shadow disappears while the left is starting to be pronounced.
Also when I look at the phone horizontal, with the usb connector on the right side, the bottom edge doesn't exhibit any pronounced shadow while the top can be seen. The top shadow is the previously right one.
If I turn it with the usb connector on the left, the bottom shadow is visible while is also the top one. Previously the bottom was not visible.
I was thinking maybe this is how the crystals are aligned like in a tn screen when looking from bellow the center screen the top starts to get darken, but from left to right not top to bottom on s8 plus.
I know it's not a tn screen but still, maybe this technology has a small drawback.
I went in 2 retail shops to check their displayed testing phones.
One of them had a smaller gray shadow on the right side than mine, but had a very faded red shadow on the left side. While the other seemed somehow equal on shadows, I couldn't figure it out better because of the blue neon lights in the store. The best can be seen at home during the night or in moderate day light. Anyway when I put my hands around the screen it seemed to have a bit more shadow on right side but less than mine, but no faded red on left side. Also I noticed that the white was different on all 3 of them, but this is not an issue.
Did someone else can also test this shadow behaviour if it is more pronounced on the right than on the left side and also if it's not visible at the bottom with the usb port at the right while is visible top and bottom with the usb connector on the left ?
Thanks

Categories

Resources