Hi, when I try to charge my phone I'm getting this error "charge paused, battery temperature too low", I replaced the charging port but still getting the same issue. CPU temperature is -20 same as the battery
wireless charger have the same error
Any help on how fix this issue
thanks,
Related
After taking a bath in a water bucket they brought me this Galaxy S4. I cleaned it using ultrasound box and the device works but it won't charge.
It gives an error "Charging Paused. Battery temperature too low". I have tried different battery and charger (all original) but still have the same problem. I suspect i need to change the battery charger IC but i don't have schematics for GT-i9505.
Can anyone share a picture and part-number of the charger IC ?
Thanks
i have the same issue...
i9500 if i conect to charge or in a PC it says...
"Charging Paused. Battery temperature too low"
I had the same issue with my i337 S4. Could not charge or connect to computer. Always got the message "charging paused due to battery temperature too low". Now my does not turn on. If I connect it to USB then I still get the same message but it does not turn on. Can anyone help?
I plugged in charger. Battery charges for few minutes and then it gets stuck at particular percentage even though it has charging icon . I need to remove charger and plug it again to make sure the percentage increases. Anyone else having this problem
Guys I have charging problem my battery did not charge above 8%.but when I have battery below 8% it charge up to 8% then stuck.
And when I remove charger battery icon still show battery charging icon.i also try offline charging but same result using stock charger which is able to charger my other phone so problem is not in charger.
Also when I power off my phone it stuck on power off dialog box it only happen when battery icon show charging icon and charger not connected.
Plz guys help me my sis using this phone.
Hello,
i had resently installed a Nexus 7 Tilapia in my Car.
I had removed the Battery from his own Circuit Board and conntected it to a DC-DC Step Down Converter (10A) with a Output Voltage of 4.25 Volt.
After some time of Useage the percent of the Battery slowly decreases, but the Voltage stays Stable.
Does someone know how to fix that?
I want to Keep that board because of the Battery Display (100%) and the Clock.
Thanks.
Hello there .were you able to fix this issue?i am facing the same thing right now in grouper.it was drawing battery,so I connected the tablet directly to my car battery with dc dc hoping to solve the problem but instead the percentage keeps dropping and I have to disconnect the pcb board (battery board) and restart the tablet.i see 100% and then it starts dropping ?
hello, no i dont. that peace of shi* broke down, so i trashed the whole project. sry
When I start charging the phone it initially do fast charging but after 5-10 min the phone stops fast charging.. I have check the charging voltage by AccuBattery the voltage falls down after some time of charging. Have also tried different charges but issue is still there. Any help is appreciated. Thanks..