I have been trying to reset the aboot counter on my phone in an attempt to flash firmware onto my phone, is there any way to do this?
Related
i managed to unbrick my device with the sd card method .. but in download mode it says device binary custom or somthing .. i wanna flash with odin to restore the phone to completely being stock .. will i brick the device again if i flash it with odin
@moe said:
i managed to unbrick my device with the sd card method .. but in download mode it says device binary custom or somthing .. i wanna flash with odin to restore the phone to completely being stock .. will i brick the device again if i flash it with odin
Click to expand...
Click to collapse
If you flash the stock firmware via odin then factory reset and wipe cache via stock recovery (vol up + home key + power key) every thing will be back to original. Just make sure you flash the correct firmware (i. e. if on NC4 you cannot go backwards).
I was installing via odin 4.4.2 nordic, when suddenly it failed and the phone was disconnected from pc.
Now I can't enter recovery, and I can't flash nothing.
When I try to flash a recovery, when it attempts to write in NAND, it fails...
KNOX is 0x1, do I have to buy a new phone?
Hey, today by mistake i checked in odin Nand Erase All, and my phone get bootloop, its possible to fix it or my phone is dead forever ?
How does one check it by mistake?
You tried flashing firmware with Odin to fix it?
Help i soft bricked my Phone and it said Custom binary blocked by frp so I tried using Odin but that didn't work for some reason so now it says ''An error as occurred while updating the device software. Use the emergency recovery function in the Smart Switch PC software'' I dont know what to do now its my only phone and i need to get it back to normal plz help:crying::crying:
Download the original firmware and flash it on ODIN. If it stops at sboot.bin just remove any LOKI files and the sboot.bin itself
I bricked my phone by disabling OEM unlock after flashing it, because I didn't have the knowledge that it would brick the phone after flashing it. The firmware was blocked by FRP lock and then I had to reflash to original firmware using Odin. However, after flashing, it would boot loop, and nothing solves this problem. I'd like to know if someone knows what should be done in this case.
Thanks in advance!