Hello,
I was trying to replace broken USB connector.
I was using hot air and at the end connector is replaced but I blown away some 0201 SMD parts.
Any chance to get form someone what it was (R/C) and which value?
Thanks
Related
OK, I'm a ****.
Just came to remove my audio daughter board off my M500 to solder up the dodgy joints on it, and the whole bloody connector came off. I've removed the connector from the daughter board, but when attempting to resolder it, I managed to break the connector
So, I need a source of the little rectangular PCB connector (14 way, DIL) that attaches the ADB to the main board, so I can have another go Anyone know a source in the UK preferably?
Cheers
Hellraiser.............>
Hi All,
My S200 has served me very well. Unfortunately the mini-usb jack is jacked. My son dropped it in his baby food recently and when I was cleaning it out the little gray plastic cover for the USB wires came off....so when I look inside i see 5 wires coming out...unfortunately one of them is bent and so the USB cable is not working at all...
Is there any way to replace the USB jack? I'm pretty familiar with the insides as i have replaced the speaker and cleaned it out many times...where can i buy a jack if it's even possible? Thanks in advance!
Gujjuman
Just buy one and solder it?
http://www.phonesandmore.nl/Mini-usb-connector-MDA-Vario/
Replacement guide
http://www.modaco.com/content/htc-prophet-prophet-modaco-com/240109/changing-you-prophet-case/
Hi Guys,
Has anyone come across or compiled anything on the wizard 200 mainboard layout for voltage paths between the USB charge port and the battery clip?
I have broken the USB port and the traces where the solder joints were on 3 and 4 have come off.
Is there fairly simple way to build the traces back up? if not is there a workaround through the circuit further up?
Cheers
Friends the socket was removed and points also ... now the service is bad , i try to solder it but the hole small socket get broken and also the some points get removed , i try to put small metal inside big connector and connect the flex cable to that one and i solder cable from side the connector to the out side of flex cable but the signal is very bad any why to fix it without plug and flex cable as they get damaged ??? like soldering wires between area's ???
So either the motherboard or the USB board lost the antenna connector. Hopefully it's the USB board as you're going to have to replace the board based upon your description.
Hello everyone,
Currently i have a problem with my samsung tab A 8.0. Days ago i accidentally dropped my tab while it was being charged, resulting in red Cross with lightning icon while i tried to plug it on anything, and suddenly all of my usb otg were not detected and it was not detected on my pc...even usb debugging was not detected too...i had opened its case and checked the continuity of its micro usb port and it still seemed ok...now i have no idea about how to solve this, do you know what to do if something like this happens?? I suspect its pcb track is broken so maybe i will need a new motherboard again...
Hello, anyone?
How are you checking continuity? You would need to check it between the end of the USB cable and the solder points behind the micro USB pins. No point in testing to the actual pins.
The pins that solder to the board are extremely small and difficult to resolder, some sort of magnification is really required.
The way I do it is by using a solid conductor wire wrapped around the end of a decent soldering iron. Even then it's a difficult task and requires a steady hand.