After a completely fresh install, along with gapps, I got past the LG logo, but was stuck at the bootanimation for several hours. It kept animating, but no progress was made. I tried with and without gapps. I am running TWRP 2.7.1.0 (dr87's version), and have fallen back onto Mahdi for now. I h ave a d800 (LG G2, AT&T variant). I was using the link from the official thread (houston.hostingsharedbox.com/roms/g2/d800/), and my zip was not corrupted.
tsunamical said:
After a completely fresh install, along with gapps, I got past the LG logo, but was stuck at the bootanimation for several hours. It kept animating, but no progress was made. I tried with and without gapps. I am running TWRP 2.7.1.0 (dr87's version), and have fallen back onto Mahdi for now. I h ave a d800 (LG G2, AT&T variant). I was using the link from the official thread (houston.hostingsharedbox.com/roms/g2/d800/), and my zip was not corrupted.
Click to expand...
Click to collapse
hello!
I think you need to clean everything and factory reset... I have the same problem since PA 4.4 final.
It's shame to factory reset and install everything all over again...
Hi do u know if lg g2 d802 is supported? I can't find where is the links and the instructions for installation
Related
I have the LG G2 Verizon
Was on the 12B OTA when I rooted using ioroot 19 and flashed twrp 2.6.3.3 using freegee from playstore.
I went into twrp Flashed ROM Malladus 1.2.5 The LG apps and JB apps
After the 3 zip files were successfully installed. I rebooted system. The LG logo came on for a second and the screen turn black. I left the phone for 30 minutes hoping it was part of the ROM loading.
I can go back to twrp holding down power button + volume down and do a factory reset. Tried re installing ROM and apps. Same thing happens again.
I haven't tried to format data because then I won't have a ROM to install and reading other posts it just doesn't help.
I've read threads how to get back to stock rom but I don't know if that's my solution to my problem.
Can someone please help and give a step by step.
Thank you,
atticustcx said:
I have the LG G2 Verizon
Was on the 12B OTA when I rooted using ioroot 19 and flashed twrp 2.6.3.3 using freegee from playstore.
I went into twrp Flashed ROM Malladus 1.2.5 The LG apps and JB apps
After the 3 zip files were successfully installed. I rebooted system. The LG logo came on for a second and the screen turn black. I left the phone for 30 minutes hoping it was part of the ROM loading.
I can go back to twrp holding down power button + volume down and do a factory reset. Tried re installing ROM and apps. Same thing happens again.
I haven't tried to format data because then I won't have a ROM to install and reading other posts it just doesn't help.
I've read threads how to get back to stock rom but I don't know if that's my solution to my problem.
Can someone please help and give a step by step.
Thank you,
Click to expand...
Click to collapse
This is the reason you are unable to flash Malladus 1.2.5 and have it boot properly.
mademan420 said:
This is the reason you are unable to flash Malladus 1.2.5 and have it boot properly.
Click to expand...
Click to collapse
Oh I wow I had flashed the ROM the same time that guy posted. Well thank you for that link.:good: I'm just happy it wasn't something really bad like the point of no return to use my phone.
Do you think I can perform 2. Copy the boot.img installing section from updater-script (under META-INF) from 1.2.2 into 1.2.5 and then install
By sideload on twrp?
Hi i installed CWM Recovery and rooted the LG G2 (D802 Int') but after installing CM11 the phone won't start.
It stucks on LG Logo and every minute it restarts.
What can i do?
Hey
Try to reflash CM 11, i think than is your Problem solved
When not, try to go in Recovery and then do adb sideload
I hope that helps
...
I already tried to re-flash the CM11, same issue.
What do you mean about the sideload thing?
Hellsigh said:
Hi i installed CWM Recovery and rooted the LG G2 (D802 Int') but after installing CM11 the phone won't start.
It stucks on LG Logo and every minute it restarts.
What can i do?
Click to expand...
Click to collapse
If you flashed the latest 21/3 CM11 - it is borked. This fact is obvious if you look at the CM11 thread...
Ok i was able to boot up.
But i have a new problem now. No sound coming from the device :\
I have looked at a lot of posts here over the past few days and have not found an answer to my problem. I figure more info is better that not enough, so I'm sorry if this gets a little long.
I have 2 LG G2 VS980s and have recently moved from Verizon to T-Mobile. I have the phones rooted and decided to try some custom roms. I have tried (I think) a lot of different ways to do this, with limited results. I am using TWRP as the bootloader and have tried bumped and standard (I think). They both act the same way. I initially installed TWRP with AutoRec that installed 2.7.0.0 and then flashed to 2.8.6.0. I then tried the following roms: ParanoidAndroid (latest on website), cm11, and AOPK. All three of these resulted with the phone going into boot looping. I was then able to flash the stock rom back on using lg-toolkit and the phone boot fine. I have tried VS980 stock 4.4.2 24A and 4.4.2 27A, and the phone boots fine with each.
Using the same method above I loaded on the CloudyG2 2.2 and CloudyStock roms and they both booted fine.
So to my actual question. How exactly can I get all these other roms to boot so that I can try them out? I'm sure that I have missed something since some roms work and others on this forum has gotten the other roms working.
Your help is greatly appreciated.
VegasIdaho said:
I have looked at a lot of posts here over the past few days and have not found an answer to my problem. I figure more info is better that not enough, so I'm sorry if this gets a little long.
I have 2 LG G2 VS980s and have recently moved from Verizon to T-Mobile. I have the phones rooted and decided to try some custom roms. I have tried (I think) a lot of different ways to do this, with limited results. I am using TWRP as the bootloader and have tried bumped and standard (I think). They both act the same way. I initially installed TWRP with AutoRec that installed 2.7.0.0 and then flashed to 2.8.6.0. I then tried the following roms: ParanoidAndroid (latest on website), cm11, and AOPK. All three of these resulted with the phone going into boot looping. I was then able to flash the stock rom back on using lg-toolkit and the phone boot fine. I have tried VS980 stock 4.4.2 24A and 4.4.2 27A, and the phone boots fine with each.
Using the same method above I loaded on the CloudyG2 2.2 and CloudyStock roms and they both booted fine.
So to my actual question. How exactly can I get all these other roms to boot so that I can try them out? I'm sure that I have missed something since some roms work and others on this forum has gotten the other roms working.
Your help is greatly appreciated.
Click to expand...
Click to collapse
Most of the latest cm and aosp roms use caf sources now. So u should flash lp bootstack for ur variant
v.konvict said:
Most of the latest cm and aosp roms use caf sources now. So u should flash lp bootstack for ur variant
Click to expand...
Click to collapse
I flashed the following file: bootstack-vs980-LP_39a-loki-signed.zip and then tried to load CM12 file: cm-12-20150619-NIGHTLY-vs980. After this the phone goes into bootloop. When I get back into TWRP (version 2.8.6.3) I try and restore the TWRP back up, but the sdcard had been wiped and only the following folders are left: 0, obb and TWRP (with no sub-folders, so no backups). Luckily, I have the backup on a thumb drive, restored it and it boots and runs fine.
I tried loading the bootstack file through TWRP (Install) with the above results. I tried to loading it through the app "Flashify". When I rebooted the phone went into TWRP, ran a script that I didn't catch and then rebooted just fine. However, when I installed CM12 in TWRP I still got the same results above. I have restored the backups (from the drive) and am now ready to try something again.
Just to be clear, I started with TWRP 2.8.6.3 and as far as I can tell, it never changed.
I still appreciate your help and I know there is a way to get this to work. I'm sure I am missing something simple.
VegasIdaho said:
I flashed the following file: bootstack-vs980-LP_39a-loki-signed.zip and then tried to load CM12 file: cm-12-20150619-NIGHTLY-vs980. After this the phone goes into bootloop. When I get back into TWRP (version 2.8.6.3) I try and restore the TWRP back up, but the sdcard had been wiped and only the following folders are left: 0, obb and TWRP (with no sub-folders, so no backups). Luckily, I have the backup on a thumb drive, restored it and it boots and runs fine.
I tried loading the bootstack file through TWRP (Install) with the above results. I tried to loading it through the app "Flashify". When I rebooted the phone went into TWRP, ran a script that I didn't catch and then rebooted just fine. However, when I installed CM12 in TWRP I still got the same results above. I have restored the backups (from the drive) and am now ready to try something again.
Just to be clear, I started with TWRP 2.8.6.3 and as far as I can tell, it never changed.
I still appreciate your help and I know there is a way to get this to work. I'm sure I am missing something simple.
Click to expand...
Click to collapse
It goes into bootloop because you flashed the lp bootstack with a non-caf rom.
Choristav said:
It goes into bootloop because you flashed the lp bootstack with a non-caf rom.
Click to expand...
Click to collapse
Thanks for your reply. After reading the response from v.konvict above, I thought that CM12 would be caf, but it isn't. I've got several more ROMs working now by using different bootstacks, but it is trial and error with some of the ROMs.
Hello, I had some issues with my LG G2 while attemping to flash a new rom, here's my problem:
I checked for the latest crDroid 6.x rom and the gapps, everything went fine, I flashed the rom with no problems at all and then continued with the gapps. But here's the problem, when I tried to boot it, nothing popped out from the display, just the LG logo, then it was completely black. After trying to install another custom rom (cm 13 nightly), nothing happened. Then, I tried to go back to my AICP rom. I had to use ADB installer since I didn't have any zips avaiable, but when I tried to install tk gapps (downloaded from the AICP forum), Error code: 20 came out. I did a research, and this looks weird, because that error only pops when the gapps are not compatible with the current rom, but clearly they were. Any ideas on how to fix this up?
Avrammm said:
Hello, I had some issues with my LG G2 while attemping to flash a new rom, here's my problem:
I checked for the latest crDroid 6.x rom and the gapps, everything went fine, I flashed the rom with no problems at all and then continued with the gapps. But here's the problem, when I tried to boot it, nothing popped out from the display, just the LG logo, then it was completely black. After trying to install another custom rom (cm 13 nightly), nothing happened. Then, I tried to go back to my AICP rom. I had to use ADB installer since I didn't have any zips avaiable, but when I tried to install tk gapps (downloaded from the AICP forum), Error code: 20 came out. I did a research, and this looks weird, because that error only pops when the gapps are not compatible with the current rom, but clearly they were. Any ideas on how to fix this up?
Click to expand...
Click to collapse
for your rom to boot you need hybrid bootstacks
wipe all/flash hybrid/ go to main menu/ then reboot into recovery from recovery/ once in recovery again proceed to flash rom and gapps.
use the one for your variant
http://forum.xda-developers.com/lg-g2/development/boot-g2-hybrid-bootstacks-t3183219
Hay,
I already read the thread for CM13 on the LG G2 (d802). But actually I am kinda confused and I just want to go sure that I don't do anything wrong again. Currently I am using CM 12.1-20151114-NIGHTLY-d802 with Gapps. Today I wanted to update to the CM13 Release. I did what on the cyanogen site was written and flashed the CM13.zip and the gapps.zip, then wiped Dalvik and rebooted. Unfortunately i got a blackscreen and nothing happened. I rebooted into recovery and restored the CM12.1 backup I did before.
So if I understood the CM13 thread correctly, I do have to go back to LG G2 Stock ROM and update to Lollipop and then root and flash CM13. Or I do have to install another Bootstack(?), which is not recommended.
So what is this Bootstack and why isn't it recommended?
Thanks for your help!