change msl without using dfs or cdma-ws - Sprint Samsung Galaxy S 4 Q&A, Help & Troubleshoot

i've tried this on a couple of l720's running on mdc, mf9, and mja (had to downgrade modem to mdc for mf9 and mdc: check autoprime's thread about international unlocking for the file and thank the guy who did it)
granted why would you want to this if you could use getmymsl or terminal emulator.
i'm pretty sure we've all had that one phone that doesn't want to comply for some reason so
with this method you can change your msl to 000083, go to qpst 4.0.2 and change the msl to 000000 by modifying nv item 85
(the msl for some reason only changes to 000083 haven't figured out why yet)
when using the phone on mja or mf9, downgrade the modem to mdc, if your on mdc your set
dial *#0011#
press menu
press back
menu again
key input: 0 enter
.....give it a bit and a new menu should appear titled "MAIN MENU"
select [2]CDMA
then [4]CONTROL
followed by [6]MSL EDIT
now it should say something like CURRENT MSL = -5333029 (or something similar) with USE 'Key input' of MENU for set
menu
key input: 000000 enter
menu should display now Current MSL = 0 reset the phone normally!! and after you reboot your phone you should have an msl that is now 000083
now your able to zero out your msl with qpst or keep it at 000083
hope this helps anybody

Related

I9505 unlocking

I've attempted to sim unlock my galaxy s4, however using the *#0011# method it will not enter service mode after the "key input 1" step. Is there any reason why I cannot access the main menu of the service mode, or is there any alternative? Thanks.
aidanski said:
I've attempted to sim unlock my galaxy s4, however using the *#0011# method it will not enter service mode after the "key input 1" step. Is there any reason why I cannot access the main menu of the service mode, or is there any alternative? Thanks.
Click to expand...
Click to collapse
Bump for me also ?

[Q]Flash modem

Hello, As far as I cant unlock my Phone [PIN Network] because i need to allow it in the *#0011# but when I put 1 It just does
"MENU NOT EXIST
PRESS BACK KEY
Current Command is 111"
I read in the forums that i need to flash the MDL modem back, the codes dont work with the MF3 modem AFAIK.
But when I try to flash the modem It just fails..
Any clue what to do?

[Q] Can't access RNDIS + DM + MODEM. Codes don't work.

I am an owner of an unlocked I337M with Koodo. I have a custom rom, GPE 4.4.4 which is also rooted. In order to use Wind or Mobilicity (AWS , 1700), I must enable this function through various guides I've followed; however, I can not access this "Hidden Menu" for the USB Settings.
The only code which works is *#06# which shows my IME.
I have also turned ON the "Hidden Menu" script within the system using FX browser.
*#7284# - *#0808# - *#9090# and every other ones I have entered do not work. There are no menus popping up.
Is this because of my custom firmware? Are there newer codes for Android 4.4.4?

[Q] Damaged EFS, no backup - how to repair S5 with NULL IMEI?

Hi,
I have a problem with my S5. After flashing a custom ROM I found out that my IMEI is null, and so the EFS is corrupted. I tried to restore it from backup only to find out that I have deleted the backup
What can I do now? I anything? Would restoring EFS from another S5 (with damaged mainboard) could be a solution?
Generally everything works except of phone modem, I have got IMEI written - is there maybe a method to set the IMEI without EFS or a method to create EFS? I already tried sam IMEI changers, but I found out that they only do this on the application level - apps will be able to read different IMEI for licensing, but phone still sees NULL IMEI.
You can't restore EFS from another S5 coz it'll brick your device.
Bruce666 said:
You can't restore EFS from another S5 coz it'll brick your device.
Click to expand...
Click to collapse
Thanks for answer
So what can I do?
Found sth like this:
Never tried coz never lost IMEI
In the dialer, type- *#197328640# or *#*#197328640#*#*
>You will be prompted into the Command mode, provided On the screen, Select on Common, normally option 6
> Now Select (FTM) Option 1
>FTM is for debugging and testing., (Field Test Mode)
>If (FTM) is on, you will have to turn this OFF
>As soon as you turned this off your NULL or altered IMEI number will be restored
>(Important) Without leaving the Command screen, press the Menu key, the button that’s found left of the Home button.
> Select Key input and enter option 2. In this case, you want to turn it off
>Wait for a minute. This will turn your FTM OFF
> Remove your battery and SIM card for two minutes
>Place your battery in your phone, (important) do not place your SIM card in.
> When the phone is booted, enter the command mode again dial – *#197328640#
>Select the Debug Screen, normally option 1
>After that, choice phone control, option eight
>Click on nas control, option 3
>Afterwards, click “RRC (HSDPA), option 5
>To Fix not registered on network or Null IMEI #, click RRC revision, option 2.
>Choose the released of your phone, here we will choose option 5 (HSDPA only)
>Final step to fix Null IMEI not registered on a network for Samsung Galaxy is to turn off your phone and insert your Sim card
or
>Insert your Sim card, afterwards reboot your phone
Thanks - are you sure about this bricking device?
I already tried this numbers but it always says "No Network", The only instruction that I found was to use *#0011# and it goes into the Service Menu, but it doesn't look like that described. There is something called NVM restore, but it doesn't do anything with IMEI
I am gonnna post screenshots at evening.
Bruce666 said:
Found sth like this:
Never tried coz never lost IMEI
In the dialer, type- *#197328640# or *#*#197328640#*#*
>You will be prompted into the Command mode, provided On the screen, Select on Common, normally option 6
> Now Select (FTM) Option 1
>FTM is for debugging and testing., (Field Test Mode)
>If (FTM) is on, you will have to turn this OFF
>As soon as you turned this off your NULL or altered IMEI number will be restored
>(Important) Without leaving the Command screen, press the Menu key, the button that’s found left of the Home button.
> Select Key input and enter option 2. In this case, you want to turn it off
>Wait for a minute. This will turn your FTM OFF
> Remove your battery and SIM card for two minutes
>Place your battery in your phone, (important) do not place your SIM card in.
> When the phone is booted, enter the command mode again dial – *#197328640#
>Select the Debug Screen, normally option 1
>After that, choice phone control, option eight
>Click on nas control, option 3
>Afterwards, click “RRC (HSDPA), option 5
>To Fix not registered on network or Null IMEI #, click RRC revision, option 2.
>Choose the released of your phone, here we will choose option 5 (HSDPA only)
>Final step to fix Null IMEI not registered on a network for Samsung Galaxy is to turn off your phone and insert your Sim card
or
>Insert your Sim card, afterwards reboot your phone
Click to expand...
Click to collapse
evilsnailofdestruction said:
Thanks - are you sure about this bricking device?
I already tried this numbers but it always says "No Network", The only instruction that I found was to use *#0011# and it goes into the Service Menu, but it doesn't look like that described. There is something called NVM restore, but it doesn't do anything with IMEI
I am gonnna post screenshots at evening.
Click to expand...
Click to collapse
Yes I'm sure about bricking. EFS partition on your phone is made for ONLY YOUR PHONE. This is sth like restoring TA Partition on xperia devices. When you flash ta from another xperia, you brick device
Tapatalked from SM-G900F
I read someone saying they had successfully restored a backed up EFS partition from an identical model S5 to another, and it worked
The problem I can see, is if the original gets blocked by the carrier, chances are so will the clone
Not sure about network issues having two identical devices on the same network at the same time, both making calls, might end up like an IP conflict
Pretty sure that transferring IMEI from one device to another is against the law too......
Sent from my rooted, debloated stocKK kn0x0 SM-G900F
Yes, I also know that is it against the law, but I have a complete phone with broker mainboard (so even the IMEI is written on the back), and I would like to use this opportunity to copy the IMEI from old (broken) mainboard to the new one. It even looks better than the situation when I have got and old case with written IMEI that doesn't correspond to the IMEI on the new mainboard.
The mainboard is broken that way, that there is short-circuit somewhere and the CPU is constantly using power and it get's really hot, so it use useless.
I am trying to flash EFS, let's see what is gonna to happen
keithross39 said:
Pretty sure that transferring IMEI from one device to another is against the law too......
Sent from my rooted, debloated stocKK kn0x0 SM-G900F
Click to expand...
Click to collapse
1. Tried flashing EFS = nothing happened
2. Tried flashing EFS + Modem + ModemST1 + ModemST2 = nothing happened
3. Restored android to STOCK
I can't get into the service menu.
The only Service menu that I can get into is this one, but there isn't any fixing IMEI/NVRAM option
Code:
*#0011#
Menu > Back
Menu > keyInput "Q"
Menu > keyInput "0000"
Wait for few seconds
evilsnailofdestruction said:
Yes, I also know that is it against the law, but I have a complete phone with broker mainboard (so even the IMEI is written on the back), and I would like to use this opportunity to copy the IMEI from old (broken) mainboard to the new one. It even looks better than the situation when I have got and old case with written IMEI that doesn't correspond to the IMEI on the new mainboard.
The mainboard is broken that way, that there is short-circuit somewhere and the CPU is constantly using power and it get's really hot, so it use useless.
I am trying to flash EFS, let's see what is gonna to happen
Click to expand...
Click to collapse
Hi,
you have 2 options
1. Use Samsung Kies which will repair you efs
2. Flash with Odin the official rom 5.0
If you install another efs, the data installed may be not work, even if it is same model. In S5, nothing to do with the IMEI
You can also root the phone and with adb commands, erase all the efs
you can also use Z3X tools
Hi,
Thanks - some new ideas
So if I understand you correctly, I have 3 options:
1. Use Samsung Kies which will repair you efs - how to repair EFS with Samsung Kies?
2. Flash with Odin the official rom 5.0 -> I tried flashing oryginal 4.4 and it didn't helped. Should flashing 5.0 help?
3. You can also root the phone and with adb commands, erase all the efs - What will erasing EFS will give me? Shouldn't I have EFS partition with some data?
you can also use Z3X tools -> ok... I am gonna figure this out, 'cause I don't know it yet
FrenchSnake said:
Hi,
you have 2 options
1. Use Samsung Kies which will repair you efs
2. Flash with Odin the official rom 5.0
If you install another efs, the data installed may be not work, even if it is same model. In S5, nothing to do with the IMEI
You can also root the phone and with adb commands, erase all the efs
you can also use Z3X tools
Click to expand...
Click to collapse
I have the same issue. Anybody may help me ? (galaxy S5 SM-G900H made in Vietinam)
thanks in advance
Bruce666 said:
Found sth like this:
In the dialer, type- *#197328640# or *#*#197328640#*#*
>Insert your Sim card, afterwards reboot your phone
Click to expand...
Click to collapse
This does nothing on Galaxy A5!
attached 0011 code screen
Has anybody found the solution? Efs professional gives me error " device connection lost" while using Qualcomm nv tools on s5.

Suitable downgrade firmware with "Hidden meny" options available?

Hello
Wondering if anyone could give me a hint of which stock firmware I would need in order to get options in the hidden menu available and thats compatible with Samsung GT-I8730.
Currently running Android-version 4.1.2 original stock firmware.
Trying to unlock SIM, using Chimera but gets stuck at 19%, when a popup-window tells me to enable Diagnostic Mode (DM) by using *#0808# or *#9090# or *#7284# in dial window
The two first options nothing happens at all and dialing *#7284# brings me to PhoneUtil with options UART, Modem or PDA, where PDA was default but there is no USB section available.
Also I would need the *#9090# to set Diag config to USB-value.
Am new at this and would be grateful for any help I can get
Riondorx

Categories

Resources