I am stuck with my l7 at emergency mode after i tried to flash v10k from CM10.When i want to flash v10k,kdz give me wParam:100 and Lparam 4010 error...what can i do ?
Related
when i tried to updated my phone ( LG E612 ) to 4.2 by KDZ (my own was 4.0.3) at the middle of work an error :
UPGRADE Error
Wparam = 500
Lparam = 100
so the upgrade crashed and my phone is ON and didnt turn OFF even i hold the power botton
in the screen just is a note : " Download is in progress Do Not disconnect Cable." whit LG logo
what should i do?
Are you sure that 4.2 kdz is for e612/e610 ?
Did you had a custom ROM before?
Anyway, download v10d_firmware (for e610, no matter, its the same for e612/e612g/f). Flash it and then try flash that KDZ again (after you confirm its for YOUR phone)
hi
i have a problem i have a lg optimus L5 e615, i think i sent it to hell :d, i tryed to root it and to install a custom recovery and it goes right, then i tried to install a custom rom but i didn't release that its for e610 it installed well, but i couldn't follow the configuration wizard because the screen wasn't enable, i release that it not the propriate rom, then i tryied to install the V20D_00.kdz with LG KDZ updater but after i couldn't use my phone anymore it's stuck in boot i can't access to emergency mode, i can't use recovery mode, i totally scrowed up !
is there any hope to get my lg optimus L5 e615f back to use ?
i really need your help
Hi guys, I was trying to root my LG P700 , but my phone just stucked in emergency mode.
I was using this tutorial: https ://www .youtube .com/watch?v=oYvToUFiEKI , but I forgot to set the debug mode ON...
How can I recover my phone?
Thanks in advance.
Stuck at the "Emergency Mode" screen. Tried updating using the KDZ updater but always gives some wparam 100 error.
PLEASE HELP !!!
guys can you help me plz in my g2 (f320k ) im stuck in 2% too no recovery and lg security error only in download mode and im using cloudy 3.3 before how to fix it plzzzz
:crying::crying::crying::crying::crying:theres an error
MODEL DLL Event : (100, 51)
08:12:04 : Step : TYPE_WPARAM_UPGRADE_ERROR
plz how to fix it anyone:crying::crying: