Database Users

[Q] SD card not recognized after a reset. Stuck on 7403

I had everything working fine up until zune reset my phone to update to 7712. Now everytime my phone reset, my SD card is unrecognizable.
I can get my phone to recognize the SD card following the steps below but whenever I reset the phone again, its gets messed up. Any suggestions?
-----------------
So if you have any problems with SDcard after first 7004 flash (boot in loop) or can't upgrade 7008 do this:
- Flash the rom without SDcard
Or if you have already flashed remove it and do a factory reset
- After system loaded, update to 7392 without SD card
- After booting succesfully 7392 go in settings/about and reset the phone
- When phone reboot insert your SDcard
- You will load system and the SDcard should works well now
- Continue to update to 7720 but this time with SDcard

Delete the card MBR (via bootloader)
Hard Reset the phone
Enable the Last24NAND in MAGDLR
reconfigure 7712
push the provision cab once more
update to 7720

I have the same issues.
I managed to update up to 7403 without the SD card.
I have adata 16GB Class 10.

hkan008 said:
I have the same issues.
I managed to update up to 7403 without the SD card.
I have adata 16GB Class 10.
Click to expand...
Click to collapse
I haven't seen any class 4 or higher working with WP7.
(Have 9 cards here at work, the only ones that work without any problems are the class 2 ones)

Can't deploy cab file into HD2.

Hi
I'm now stucking on Yuki's 7403 after trying flash 7004-7392(without SD card) and 7392-7720(within SD card, the progress stopped suddenly and rebooted after that) two shot. The problem is that I can't deploy an cab file into my HD2 even DEV_STORAGELOCK.cab(just 32KB). My SD card is still 6.9GB available.
Is there any ways to format my SD card? Is it possible to convert DEV_STORAGELOCK.cab into xap file?

It's very kind of you if someone make a xap file that it can unlock my sdcard

[Q] After installing WP7 Rom - My SD is dead (both phone and PC)

Good day
i had working Dual boot OS with WP7 and android for the last 2 weeks on my HTC HD2 with 32Gb SanDisk MicroSD.
yesterday i wanted to make a new installation with other versions on the OS. So...
i formatted the SD card to New FAT32 and the PC recognize it well.
I went to install WP7 from there :
http://forum.xda-developers.com/showthread.php?t=1236027
and after the installation the phone reboot and i did again hard reset for it to build up the partitions on the SD.
after the second boot the phone got stuck and i had to take the battery out in i wanted to start all over from the beginning.
when i went to format the SD again my Windows didn't find it nothing i did.
i i used all the partition application i know but nothing - no SD or dead sd.
i also installed Gparted and boot from the live cd but still no SD.
i installed original WM 6.5 - buy fuss what - still no SD installed.
i don't know what to do??????
i installed also android on hand and tried to format from the android but still - no SD installed.
is there some magic i can do?
or my SD is dead?
i hope i can fix it......
thanks

your SD card is locked.... BTTF lock card and that card not readable.... you must unlock card first... send unlock cab file to phone and after that you can format card (or use old Nokia phone http://forum.xda-developers.com/showthread.php?t=1242071)
if you want dual boot without worry about locking card, try use Pdaimatejam Rom or DFT UltraFruit
also you have video how to dual boot android and WP7 http://forum.xda-developers.com/showthread.php?t=1356833

Hi
you have to use "ultimate boot cd", boot on, find your sd card and format
hope this help

Thanks

cannot read sd card
dxdy said:
your SD card is locked.... BTTF lock card and that card not readable.... you must unlock card first... send unlock cab file to phone and after that you can format card (or use old Nokia phone http://forum.xda-developers.com/showthread.php?t=1242071)
if you want dual boot without worry about locking card, try use Pdaimatejam Rom or DFT UltraFruit
I installed pdaimatejam rom v7.1, cannot read sd card. Already send cab lock and unlocked cab both with hard reset.Easeus partition, pc and sdfomatter still cannot read. Phone and zune can read my card. What gone wrong any idea?
Click to expand...
Click to collapse

[Q] Is my SD card dead?

Hi,
I have installed "Back to the Future [XBmod-Yuki][Updatable]Build 8107" everything was ok, after that i rebooted my phone in MAGLDR and cleared the SD with ClearSD MBR and after this I installed "06.FEB HD2 Pdaimatejam Rom Wp7.5 mango 7.10.8107.79 v7.3" and now when I try to boot in wp I get the "Storage card not working" message .So i tried to format it in windows and I saw that is no SD card recognized(i don't see the 200mb partition), I tried with a camera to, but no succes...is my SD card dead??
The memory card is a 8 gb SanDisk class 2.
Thank you

your card is locked.... unlock card with old nokia phone or flash Yuki ROM again and use cab file to unlock card....
http://forum.xda-developers.com/showthread.php?t=1242071

And if I want to go back to HD2 Pdaimatejam Rom Wp7.5 mango 7.10.8107.79 v7.3 how should i proceed to avoid locking it again?

Pdaimatejam Rom not lock card
when you unlock card, you must format it to FAT32.... then install Pdaimatejam Rom...

I have flashed the Yuki Rom-unlocked the card-reboot-flashed Pdaimatejam rom with succes.Thank you very much

Did i brick my SD card with WP7 ??

Hi together,
i was very happy with my HD2 and WP7 Mango using a 32GB class 6 SD card.
Then i flashed my HD2 back to WM6.5 and send it back to Vodafone for a Hardware support issue.
then i tried the 32GB card with a cardreader in Windows. Nothing happened. I Neither see the normal 200MB partition in Windows.
I used severel Partion Software (Partition Manager, Partition Magic, SD Card formatter, magldr SD clear etc). But i can't see my SD Card plugged in.
Today i installed again WP7 on my HD2 with another SD card and it works. I put it in Windows, and i see the 200MB partition an i can format this to its whole space.
So what happened with my 32GB card, and how can i format it back, that it will work
edit:
i also followed these steps: http://forum.xda-developers.com/showthread.php?t=913144
but my sd card is not getting recognized

I had the same thing; where the card isn't recognised by anything so therefore can't be formatted to a blank state.
The solution for me was hard resetting the phone (Volume buttons while WPH is booting from MaGLDR) with the sdcard inserted which makes the system recapture it.
That should render the card usable again, but FMI which ROM where you running initially? My problem (and solution) came from Xboxmod's BBTF Rom.
HyT

Try this: http://forum.xda-developers.com/showpost.php?p=17306984&postcount=3

yes my first mango rom was the xbmod yuki rom.
so i need to delete my tango and install xbmod mango again....
i will give it a try and reply later.
thank you
edit:
@HypoTurtle
now i'm using the HD2O© v2.00b5 Tango Rom. This seems good. If i will have issues i will try the Pdaimatejam Rom Wp7.5 Tango rom. yout method did not work, but thx anyway
@gregory90
the cab method worked fine
i got my 32gb card back *jibbieh*

Use the disk utility in mac osx, and restore the card to 1 partition, and FAT format.

win98 said:
yes my first mango rom was the xbmod yuki rom.
so i need to delete my tango and install xbmod mango again....
i will give it a try and reply later.
thank you
edit:
@HypoTurtle
now i'm using the HD2O© v2.00b5 Tango Rom. This seems good. If i will have issues i will try the Pdaimatejam Rom Wp7.5 Tango rom. yout method did not work, but thx anyway
@gregory90
the cab method worked fine
i got my 32gb card back *jibbieh*
Click to expand...
Click to collapse
What you need to do is to flash Yuki/XBmod v2.1. Don't need to update any further...can use base 7004. Install StorageLock.cab from XBmod's thread. Unlock the SD card. Turn off phone...don't reboot...remove SD card. The SD card is now accessible to repartition