I think I just about destroyed my hearing this morning starting up some tunes on TCPMP. With volume level at 1, it was so loud that my ears are in pain right now. I can never seem to get the volume to work properly with the headphones that came with the device.. either the music is too loud, phone too soft, system noises too loud, etc.. Has anyone had this issue? Also, what's up with only 6 volume level settings? Is there some kind of a 3rd party volume control around that might fix some of my problems?
normalise them with any wav/mp3 editors 1st...
have you tried adjusting your headphone volume? Probably it's set to too loud thats why even at volume 1 it's blasting.
1)Use the volume slider on the headphone cable
2)Set TCPMP not to use the system volume. That way I always have the system sound at max setting, and then set between TCPMP's setting and the headphones' one.
TCPMP volume etc.
I have the system volume disabled and use the pre-amp's volume on TCPMP, which, incidentally, you can set at 0%, 25%, 75% and 100%. 25% is MORE than adequate when watching movies etc. I only use MORTPLAYER for music and I also don't use the system volume.
I leave system volume at 100%.
When out and about, the speaker isn't loud enough to be able to hear videos on YouTube...
so I was wondering if there was a way to increase the volume either in YouTube, or a way of increasing the phone's volume beyond the original maximum limit?
Thanks.
Increasing the volume beyond the limitation is not recommended (even if you could), because that will damage your speaker.
Does anyone know how to add more volume levels?
The system volume is too loud at level 1 for me but 0 is obviously off so I dont want that. There are only 15 levels of volume.
Can this be changed or is there an app for it?
Cheers!
Basically, volume is WAY too low when it is low and WAY too loud to the point speaker can't handle it and starts to have broken sound.
It sounds perfectly loud on roughly 80 90% but around 70 60 it's already too quiet unless I'm in a very quiet room.
Is there anything I can do to normalize the sudden increase in volume in there last few bumps?
So, I'm trying to make a custom notification to use for a particular SMS source. It's a two second "Ding" sound and I've been using Audacity to set the output volume level very low. I want this to be a faint whisper of a sound.
No matter how much I lower the output level in Audacity, once saved and copied into the Notification folder on the phone, the volume come out as loud as can be.
It seems like the system is taking the file and ramping up the volume to a pre-determined level.
Is what I'm trying to accomplish not possible? I've seen several posts from users concerned with low volume levels, but not this.
THanks!