Hello
I followed this guide to root
http://forum.xda-developers.com/showthread.php?p=17135571
I did everything as given but when i pressed the Up Volume + Power and then down volume, it is stuck in "Starting Fastboot protocol support"
i dont see any recovery. How can i do this?
hi,
After reboot (Vol and Power) you have to wait 3 sec. and you will see a text in the left corner. You can toggle whit vol- and confirm with vol+.
Try it again!
Thanks dude. Got it. But have another problem
When i am in recovery mode when i want to flash the zip file i get the following
Failed to mount /sdcrd (no such file or directory)
Any idea how i can make sure recovery mounts the SD Card?
do you have a SD Card in your xoom? If not then there's the problem, you need a SD Card.
I have a Micro SD Card new one. This is detected in File explorer
Got it working. It looks like the recovery image was not flashed correctly. Its done now and all working fine
thanks for your support
good afternoon my x5 this morning was with it's led blinking, therefore i try to unlock but with no answer. So i take off the battery and put it again. now when i try to boot it stays on huawei logo and after a couple of minutes it turns off.
It click on power button + volume up it enter in recovery but do the wypes doesn't help and if try to reflash the rom it doesn't find my sdcard, isntall zp form sdcard --> choose zip from sdcard ---> all it appears it's LOST.DIR, the same if i do that through 'choose zip from internal sdcard
it seems that the sdcard isn't recognized, i had tried with another memory card but without sucess,
running last aurora by dzo + extented partition by forumember2
what can i do?
Remove the SD card and see if you can use the internal card
Sent from my U8800-51
It is as follows:
I installed a rom where the mobile phone at the end of the installation not started already, was stuck on the logo of Huawei.
So I downloaded a stock rom (after extracting and so) put the dload folder on the SD card, as is done ....
So when I went to the pink screen to start the update, I connected to the pc normally and nothing ...! Just keep in pink screen!
I suspect it's a driver on the pc, but I can not see ....
The drivers 'android updater' do not install!
It was supposed (i3.ytimg.com/vi/Nu1TYdJdv18/maxresdefault.jpg) happen, but not!
Help please! :crying:
are you sure you have right files? you must have a dload folder on ROOT of sd card.
try redownloading from here: http://www.mediafire.com/download/c97gnolbh9759y7/dload.zip
this is where i download every time i flash stock rom
If you are using forumber's partition, you have to return to stock partition
Hello
I have a similar problem.
I was trying to install [ROM] [4.2.2] [Version 12] CyanogenMod 10.1 with this instruction:
Installation:
Use only Forumember partition.zip.
1. Copy package to SD card
2. Boot to recovery
3. Full wipe (data, cache, dalvik,)
4. Format /system, /data, /cache
5. Reboot recovery
6. Install pacakges
7. Reboot!
But installation was not completed.
Now I can't enter to RECOVERY (power on + vol not works).
What I should to do? Return to stock partition? Help please
digit4l_pl4yer said:
Hello
I have a similar problem.
I was trying to install [ROM] [4.2.2] [Version 12] CyanogenMod 10.1 with this instruction:
Installation:
Use only Forumember partition.zip.
1. Copy package to SD card
2. Boot to recovery
3. Full wipe (data, cache, dalvik,)
4. Format /system, /data, /cache
5. Reboot recovery
6. Install pacakges
7. Reboot!
But installation was not completed.
Now I can't enter to RECOVERY (power on + vol not works).
What I should to do? Return to stock partition? Help please
Click to expand...
Click to collapse
The instructions are not correct there. Please tell what happened when you were flashing the partition.zip?
after that I installed original HUAWEI U8800 Android 2.3 for beta.
Now I have only HUAWEII logo ;(
I have the correct dload, but the drivers on my pc are not well when connectin during pink screen...
There is the img of drivers and i can't find them anywere!
Was suppose to, during pink screen, plug the phone to pc and the update just start, but nothing! The pink screen stills there and no update
pl4t!n said:
If you are using forumber's partition, you have to return to stock partition
Click to expand...
Click to collapse
But i can't go to the CWM, just pink screen and Huawei's logo stuck
Miguel510 said:
But i can't go to the CWM, just pink screen and Huawei's logo stuck
Click to expand...
Click to collapse
OK. Get a clean sdcard, or format your current one (backup your data first), and put the dload folder onto your sdcard. Now, remove the battery from the phone and insert the sdcard with the dload folder into your phone. Connect your phone's cable to your phone, and the USB end into a computer. It should start installing the firmware in your dload folder. Report your results please.
rqmok said:
OK. Get a clean sdcard, or format your current one (backup your data first), and put the dload folder onto your sdcard. Now, remove the battery from the phone and insert the sdcard with the dload folder into your phone. Connect your phone's cable to your phone, and the USB end into a computer. It should start installing the firmware in your dload folder. Report your results please.
Click to expand...
Click to collapse
When i try it just can't...
When going to pink screen and plugin the USB, the PC just can't install the drivers it says that are with errors and the drivers are missing as you can see in picture the i uploaded.
Just can go to pink screen, when going to CWM the phone stucks in Huawei's logo.
When in pink screen, the update just didn't start, even when plug the device to the PC and even doing what you said...
I think my problems are drivers!
I have Windows 7 - 64bits
And see the pics i uploaded....
rqmok said:
OK. Get a clean sdcard, or format your current one (backup your data first), and put the dload folder onto your sdcard. Now, remove the battery from the phone and insert the sdcard with the dload folder into your phone. Connect your phone's cable to your phone, and the USB end into a computer. It should start installing the firmware in your dload folder. Report your results please.
Click to expand...
Click to collapse
I use this solution, and now I have:
Phone starts in recovery <3e>
What I should do? Help please.
digit4l_pl4yer said:
I use this solution, and now I have:
Phone starts in recovery <3e>
What I should do? Help please.
Click to expand...
Click to collapse
Change the recovery image...
Root and change recovery image.
Didn't work with me!!!!
*see, gmationL
Thx for info. Where I can find this solution?(step by step)
Miguel510 said:
When i try it just can't...
When going to pink screen and plugin the USB, the PC just can't install the drivers it says that are with errors and the drivers are missing as you can see in picture the i uploaded.
Just can go to pink screen, when going to CWM the phone stucks in Huawei's logo.
When in pink screen, the update just didn't start, even when plug the device to the PC and even doing what you said...
I think my problems are drivers!
Click to expand...
Click to collapse
It should have started updating automatically. Please check that on the root of your sdcard you have dload folder, and inside the dload folder you have UPDATE.APP. If that's already there, it could be that the sdcard is not able to mount.
---------- Post added at 02:27 AM ---------- Previous post was at 02:21 AM ----------
digit4l_pl4yer said:
Thx for info. Where I can find this solution?(step by step)
Click to expand...
Click to collapse
If you are able to go to pink screen then try installing official android 2.3
Thanks for answer.
After installing and rebooting on screen was info:
(logo recovery) formatting cache/ formatting data
Now I have only HUAWEI logo
Maybe problem is in forumber's partition?
How can I back to stock partition?
digit4l_pl4yer said:
Thanks for answer.
After installing and rebooting on screen was info:
(logo recovery) formatting cache/ formatting data
Now I have only HUAWEI logo
Maybe problem is in forumber's partition?
How can I back to stock partition?
Click to expand...
Click to collapse
You can only flash the stock-partition.zip with a custom recovery. I think you need to try to mount the pink screen on your computer and install the custom recovery from there.
When I connect phone (in pink mode) to the computer I have:
I install Huawei_U8800_ICS_ADB_Driver_(MTP) but still not works
digit4l_pl4yer said:
When I connect phone (in pink mode) to the computer I have:
I install Huawei_U8800_ICS_ADB_Driver_(MTP) but still not works
Click to expand...
Click to collapse
Did you try updating the drivers through windows update or something?
The windows auto-update sucks,can't install the drivers oe update them, just says ''you already have the best drivers''...
Maybe the SD Card is unable to mount as you say, if so, can i use a different card or no solution?
Hello there , i was on my way to install a new rom , after i reboot into cwm 5.0.2.8 from my mistake into advanced category i formated "boot" so phone boot into blue screen and pink only , after some search i did , i format sd card and put dload , at first try i put B528 and then B526 and connect my phone with usb without battery , phone in both situations enter in update state > install > reboot and then it stuck loading on huawei logo for some secs and then it auto reboot . Is there any way to fix it or my phone is dead .I need answer from experienced users as i install roms for this phone about 2 years but i miss look while formating and did wrong . Thank you for your time
SOLVED :
For those who have such problems i just did following steps , i formatted sd card and put "dload" from B518(Overseas Normal)(Gingerbread)
because it has unlocked bootloader , after that connect to pc without battery and let it update or if update doesnt start press power + (volum up-down) when update finish , remove usb , remove "dload" from sdcard and then enter in pink screen (power + volum up-down) , connect to pc, it will mount cust_backup , replace recovery with any of the CWM ( i used 5.0.2.8) , reconnect phone to pc and enter recovery (power + volum up) from there u can do everything (install original partition , rom etc...) Note:Battery must be out
I think this way can solve every situation cheers !!
Do you have a repartition data?
Yes
I solved it http://forum.xda-developers.com/showpost.php?p=47255870&postcount=41 And then install B526 or B528.
scux said:
I solved it http://forum.xda-developers.com/showpost.php?p=47255870&postcount=41 And then install B526 or B528.
Click to expand...
Click to collapse
Yeah i just did a similar way but without going to froyo anyway thanks..
i stuck on huawei logo and i cant do nothing and my usb debugging is off so i cant do nothing i got twrp can i make usb debugging on from just twrp terminal or from pc? rememberi cant do nothing my phone is stucked on logo
AnimeFunBoy said:
i stuck on huawei logo and i cant do nothing and my usb debugging is off so i cant do nothing i got twrp can i make usb debugging on from just twrp terminal or from pc? rememberi cant do nothing my phone is stucked on logo
Click to expand...
Click to collapse
First of all unlock the bootloader (Search in google)
Go to twrp wipe all system and data (ALL)
Download this:
https://mega.nz/#!LQNimCgQ!oq2C_Gwvwv7zoigo8GR2kstPdHDO5ESJ9Qglv_2UERs
Turn on u cellphone in fastboot mode.
In pc go to the folder "Flash ROM B052" and click in "Instalar Rom B052" follow the few steps.
When y flash the rom copy the folder "dload" in the external sd in settings go to local update and select "update.app"
And this is all.
EDIT: U can update via OTA.
AnimeFunBoy said:
i stuck on huawei logo and i cant do nothing and my usb debugging is off so i cant do nothing i got twrp can i make usb debugging on from just twrp terminal or from pc? rememberi cant do nothing my phone is stucked on logo
Click to expand...
Click to collapse
Im gonna post you a fix , but this will install a original system(firmware) and delete everything on your internal memory. If thats a problem dont do this!
Go to http://consumer.huawei.com/nl-en/support/downloads/detail/index.htm?id=82749
Change region (if needed) find your phone and download that.
Once you downloaded it:
1. put it on your sd card
1.1 Since when you download the file, its gonna be in .zip or .rar format, you are gonna need to extract that and what you get out of that file (its gonna be a folder called dload) put that whole thing "dload" on to your sdcard. ( put in in a main folder of your sd card its called root folder, its where your main folders are like pictures, DCIM etc.)
2. turn off your phone leave it for a sec
3. then hold all 3 buttons ( power ,volume up , volume down) and it should start installing the thing.
Hope this helps.
if your phone doesn't start (if it stucks at boot logo), turn off your device... connect your device to pc, just hold the volume - key while connecting... it will boot up in fastboot mode.. then just flash the boot.img of your current build (build which was when it got bricked)..