Just noticed that after every soft Reset the SuperFine goes back to Fine in the camera Settings,I am using the 8MP tweak.I never had this happen before.
Anyone experianced the same issue?.
Edit: Never mind solved it.
My camera sometimes takes photos that has faded horizontal stripes, what's the problem??
most probably low RAM issue.Close the browser and other apps.As for me uninstalling BsB Tweaks solved all of my problems.
Related
I do not know how this happened, if it was due to TOMTOM5 what, but the screen resoluton has become completely blurred and even a hard reset won't bring it back? attached is a photo that shows the problem. This is not a camera issue as the same distortion is visible everywhere including cnn.com? any ideas?
Explain....
So, your display is blurred or the camera? If it's the screen at fault, posting apicture from the camera doen't help us as it isn't displayed on your screen.
the screen is at fault
it is the screen, not the camera that is gone. that is why I mentioned that this happens on cnn.com too. I don't know how to do a screen shot, so I had to use a photo.
This but is similar to what one might see on an overly mpeged photo, or if I take the colors on my PC screen down to 64 or 128 from128000 etc. so I think is a setting issue, maybe tomtom reset the scree somehow? who knows, but the fix lies somewhere in the registry, I hope
Again, it won't matter if you do a screen shot as the grab is handled internally.
Get a camera and take a picture of the screen when it's displaying the problems.
a bit of confusion here...
I don't have a pc here, so I could only see the photo through this screen, not realizing the camera and hence data/ photo uploaded were absolutely fine.
Lacking a means of showing the problem, all I can do is describe it, so here goes.
The photo and images look very square, some large areas that, for example used to a clear blue, with detailed tones and variations in brightness/ contrast, becomes solid blue. this happens everywhere, all contrast and detail flatening out and becoming solid/opaq.
It may be a screen resolution or color setting that has been altered and that cannot be changed back after a hard reset. Thanks for offering to help here,
M
I recognized yesterday when I shot some photos - flash was set at "auto" - that I got only had black pictures...
Anybody knows a solution for this issue?
move your finger off the lense?
sorry, I just had to...
have no idea. I'd say it could cause some software fail which could be fixed by SoftReset? maybe
JLowe said:
I recognized yesterday when I shot some photos - flash was set at "auto" - that I got only had black pictures...
Anybody knows a solution for this issue?
Click to expand...
Click to collapse
What was your battery level like, I know when my battery level is low (sub 20ish percent) the quality of the camera and flash (and the final result) is reduced.
really weird, didn't put my finger on the lense and battery is full. if I make a picture with enabled auto flash, the first photo is always black. if I switch off auto flash and enable flash then I have a normal photo.
if opera is running I get memory error of the camera application, also if I have around 133mb of free ram.
I've been having this problem when every few photos, just a plain green picture is taken. And sometimes there are distorted colors. I decided to play around with the settings to check if it changes anything.
I found out that the problem is keeping the focus mode in Continuous Auto focus. Keeping it in this mode apparently has problems which are the green photos, distorted colors, and around 2 seconds of lag between the shutter and the photo being taken.
Keeping it on Auto took off 2 of the problems which were the green photos and distorted colors. But it was still kind of laggy, I think it's supposed to be this way though to have time for it to focus
Putting it on Infinity fixed all of it, I took over 20 photos without any problem or lag.
I don't know why that problem occurred, but it's probably just the camera firmware and not a hardware problem.
Hope I got to help
So, I've been having some issues with the focus on the rear facing camera for the V20
This is a pic with the Wide Angle Lens:
imgur.com/EBu8tdN
It's crisp and clear (ish)
This is a pic with the normal lens:
imgur.com/fYDOhNd
It's blurry as hell, unless I'm like two inches away:
imgur.com/qJstB0X
I've tried in both Auto and Manual mode, and have tried the focus in both Auto and Manual.
Any ideas?
Many thanks.
P.S. sorry for the imgur links, I haven't posted enough to be allowed links in side my post.
Nope. Just issues with longer focus in darker scenes but that is every phone. Lens clean?
Did you find any solution, I've the same issue.
#4
i have same issues
any solutions?
Tap to focus
I find just pointing it and clicking doesn't set focus properly with some scenes
It's a bit odd as the G4 would have zero issues with this and the V20 also has IR AF
Any Solution yet?
I am also having the same issue, the focus doesn't work, neither manually nor in auto mode. Sometimes, just sometimes, it luckily does work, but most of the time it doesn't.. i dont understand what the problem is..
Recently, the camera was acting way weird, like showing dark picture with green lines, and sometimes it wouldnt even open, it showed just a black screen, i cleared data of gallery and camera, which resolved the issue, but still void of ability to focus.
In certain video modes (normal, short, timelapse) my Mi9T tilts and flickers the picture to the left on the screen. It's really weird because after installing any 3rd party camera software it works normally.
Any thoughts?
Update: meanwhile it turned out that the image stabilization is the culprit - with IS off it is ok but once I switch it back it happens again...