Does anyone know of this problem. I seemed to have what can best be described as dead pixels near the start menu (wm6.1, dutch hd rom), which ONLY appear when I rotate the screen. When I rotate back, these 'dead pixels' stay where they are, until I soft reset the device.
This becomes quite annoying at some time!
Please help !
Related
AS the topic. today i woke up and was supposed to turn the alarm of, but it didnt, the align was wrong, and the whole screen flickers (brighter)
then it went back to normal, and then started flicker again, its the whole screen that flickers, and its like a bad reception on the TV. horisont lines walking up and down brighter than the setting.
anyone ?
Eric,
Seems like a hardware prob to me.
Try soft and hard reseting.
When you press the screen does it change anything ?
Prob you'll have to send it back for replacement...
Hey guys... I'm having a lot of troubles with the lcd screen on my 8525 and this start about a month ago.. I've had this phone for almost one year... bought it as a refurb.
1. when i'm using the phone portrait mode the screen alignment would be perfect... however when i slide the keyboard open the screen goes to landscape and my alignment would be completely off. Heres the interesting part... say if it is still in landscape and i align it then.. it would work perfectly in landscape but then when i close the keyboard and go back to portrait the alignment would be extremely off again.
2. now when i'm in portrait mode and i go to start -> settings -> system -> screen and switch the screen to landscape (w.o sliding the keyboard open) the screen would be perfectly aligned... but when i slide the keyboard open... the alignment would be completely off again... now if i align it while it is in landscape (keyboard open) and go to start..settings..system..screen and change it to portrait the alignment would be perfect... but when i close the keyboard.... it would be off again...
is there anyway i can fix this? I've done a hard reset and flashed the firmware all over again... btw i'm using WM6 from the htc website. if anyone can help...lemme know what i have to do....
thankz
p.s my phones starts with s/n ht649.
Can't say I've seen that reported before. Sounds software based. You could try backing up and hard resetting.
Mike
I already tried that.. it didn't work.
Sorry, my bad - you clearly said you had done that already.
I can't fathom what hardware problem there could be. The magnet orientation switch is clearly fine it seems the X Y co-ords are not swapping over - but that seems a software matter, yet your hard reset suggests hardware - Im stumped.
Mike
If the whole screen is moving, including the start menu etc,
I have seen this before, when building my phone, if the lcd ribbon cable is not alligned perfectly this can occur... but resetting the device did not resolve the issue in this instance.
Cheers
Steve
So I guess I'll have to take it to a cellphone repair shop and have it looked at. I just hope it won't cost too much... the phone was a refurb and i got it for $100. Do you guys have any other suggestions?
hi guys,
hopefully someone here will be able to shed some light on this problem.
A couple of weeks ago, i noticed that when i had my jasjam in landscape mode, there was a small space on the left hand side that was no longer being used (about 5% of the screen size). I thought this small portion was just blank screen but upon further investigation it turns out that the bottom 5% of the display eg. contacts and calendar hotkey display, is being displayed at the top of the screen.
When in landscape mode you can see the scroll bar which should be at the left hand side of the screen partially showing on the right hand side..
Its a bit of a trippy issue, just a bit annoying is all.
Any suggestions for a fix?
Cheers,
Caiden
ROM: CRC's Normal 13.4
Perform a hard reset, hope it'll solve ur problem.
tried numerous times, no go unfortunately.
thanks for the suggestion though..
I am sorry to disturb you all but i have a problem and i searched and read a lot of posts in vain.
the problem i am facing with my HD2 is that when i edit the screen alignment option in settings, i get the alignment option for stylus and not for finger touch.
Now i performed hard reset 4 times and i still get the same thing (the cross mark i should tap with the stylus)
Would you or could you please check what is the problem?
I am running a default 1.66.405.2 (76641) WWE rom
Thank you
Thats all your ever going to get......
its the default winmo screen alignment utility....
If youve hard reset your screen should be aligned, why do you need to alter it?
what i really want is the finger touch alignment screen you know the blinking circle cause the one i have is for stylus
Im not sure which one you mean.
Ive only ever seen the stylus based one.
Sorry.
Hi ppl my E7 start giving a few toutch screen problems a few days ago. At fist it start unlocking the screen and opening apps and doing calls on its own when on my pocket what it never did before since i bought him months ago. The when i was playing heartstone the toutch screen become totaly crazy no leting me do any grab and drag options e clicking screen at randow :S After a few turn screen on/off it become ok again.. But after a few minutes it hapend again :S when form tha moment it was never the same.. sometimes stops from responding other can do the drag up action to unlock screen others cant drag items others it just starts clicking like crazy on screen on its own.. Had a few power on/off.. Problems continues.. Had a factory reset problem seem a little better but not much.. juxt stop clicking on its own now but cant do drag actions across full screen. Now i installed a toutch screen test app. Found that a part of the screen is not responding (or is responding really really bad like a dozen pixels only in a finger from top to buttom size area) in a paint test... the lenght of a finger.. from top to bottoum near the middle screen (Landscape mode). Cold it be a software issue on the rom ? i did installed some suspecius software (im rooted) a few times could it have damage the rom or the touch drivers or controls in a way the reseting it wont fix? could installing other rom fix it ? Could it be that the screen got out of calibration or something like that ? or its really an hardware issue ?
if its hardware is it cheaper just to exchance the touch screen since the screen doesnt have a single scrach? Or replacing the touch panel is the expansive part when screen breaks? Please any idea is welcome even if little help. Thx for any answer in advance and sorry for my bad english :S im Portuguese