I had followed all key combinations I found in every forum but I couldn't hard reset my HTC until I tried to find my own combinations and succeded. What I did is hold the green and the main buttons while pressing the soft reset button and the screen went blue for a second and immediately the system restarted whitout asking for any confirmation. Hope it helps someone else.
Related
Hey guys, obviously f**kd up my K-Jam and it's crashing on boot.
I am trying to hard reset by holding the communication manager and voice dial buttons and then pressing the soft reset.
The screen comes up asking me to press the SEND button to restore to factory default or any other button to cancel. when i press the SEND button, nothinggg happens.
I am stuck, unable to boot, unable to hard reset, unable to soft reset. Need some real help on this one guys.
Thanks in advance.
Aahh, ok, its done . Dunno where i was going wrong but finally managed . Thanks anyways . This place rocks.
Hello
I took my friends xperia to install some applications when it happens this:
After i installed AEK software Keyboard Mapper the system asked me to soft reset the device to apply some settings.(The device during this procedure was connected via usb with the pc)
I press "yes" and as usual at the start up appears the sony ericsson logo then the experia logo and finally the device is active.But in my case the phone when it comes to the experia logo freezes..The screen remains illuminated but blank and when iam touching the screen(which is blank) i can hear the sounds of clicking.In this state if i want to shut down the device the only method is to take off the battery.I tried to hard reset the device(when its closed) but unfortunately it wont allow me to do so(i tried with all the possible ways to hard reset the device).At first i thought that the device had hasnt too much battery.I fully charged it and i tried again getting the same results.Please, can anyone tell me what to do?
Edit: After several tries it came up this message "The device is unable to boot because either you have turned off the device incorrectly or tries to install an application from untrusted source.Press volume up to reset or press any other button to cancel etc" Iam pressing the volume up button but nothing happens.Please can you tell me how to hard reset the device?
Here is a link to soft/hard reset tutorial
Hi
I assume you have removed and reinserted the battery?, try this first, if that doesn't work go here.
http://www.xperiax1.net/forum/xperia-x1/546-tutorial-soft-hard-resets.html
P.S This took me 10 seconds to find on google
Ian
Might have to hard reset, if you didn't install a safe mode boot program.
Ianmrr said:
Hi
I assume you have removed and reinserted the battery?, try this first, if that doesn't work go here.
http://www.xperiax1.net/forum/xperia-x1/546-tutorial-soft-hard-resets.html
P.S This took me 10 seconds to find on google
Ian
Click to expand...
Click to collapse
Thanks Ian but apparently you didnt read all the lines i wrote.I said "i tried to hard reset the device with all the possible ways but didnt work" including this way you send me.Thanks anyway
Problem solved
Doing this:
without using the stylus is to switch off the phone,
hold down right and left button (under the screen)
while holding down switch on the phone
release the switch button while holding the two others
then a grey screen must appear saying to push "r" to hard reset or "x" to cancel
push "r" on the keyboard and you're done
Hi Guys
I've done searches to find a solution, but I can't find any.
I flashed my gene (have done many times before). Somehow got things mixed up. And now it doesn't even want to go into bootloader.
Try rebooting, power button does nothing. When I hold "camera" button and reset the green & red buttons flash then nothing.
I have tried soft & hard reset, nothing works. Screen just stays blank.
Please help, I'm really in trouble.
Regards
Celliers
Sometimes this problem happens with me. You have to remove battery and press the power button sometimes (without battery), then put back battery and power on your gene. After this, try to go into bootloader mode and flash another rom.
i installed the Ezinput from http://forum.xda-developers.com/showthread.php?t=536215 for wvga... i installed it, then it said a reset is required to finish intallation. after the reset, it went to the touch diamond 2 boot up screen, after that was over, then screen displayed nothing. its black, and usb does not respond when i connect it to the computer. any ideas? i already tried the reset using teh red button. took out the memory card, where i install the .cab, still doesnt work. any help would be greatly appreciated.
If it's totally unresponsive from boot, hard reset it. Hold Volume Down and press the "red button" to reset it. It'll go back to factory settings.
same problem here, help needed!!
i tried to restore it to the factory setting using volume down and red button but when the phone flashes it shows me this three color screen with the message "serial" on the bottom side of the screen, any ideas on what should i do???
thanks in advance...
To perform a Diamond 2 hard reset
1. With the device turned off, press and hold the VOLUME UP and VOLUME DOWN buttons, then briefly press the POWER button.
2. Continue pressing the VOLUME UP and VOLUME DOWN buttons until you see a message on the screen.
alwaysrun said:
i tried to restore it to the factory setting using volume down and red button but when the phone flashes it shows me this three color screen with the message "serial" on the bottom side of the screen, any ideas on what should i do???
thanks in advance...
Click to expand...
Click to collapse
What you did is boot in "bootloader mode"; in that mode you can try to flash again the original ROM.
thanks
thanks a lot guys, your help is well appreciated, i finally managed to flash the phone bios and now trying to install the original rom, thank you again
I installed this HTC Touch Keyboard + Keypad.cab on my mega and it won't boot anymore. It shows the carrier splash screen, but it won't boot up.
Did you try a hard reset?
i did
Am incercat . At that moment i managed to solve the problem. The device is unable to boot screen popped up in the end. and i just pressed vol -. Now i have the problem again. Worse. It won't get passed the carrier logo. What can I do?
Are you sure you performed a HARD reset? Hold the volume keys down when you turn it on then press volume up to reformat the phone, it should boot.
To do a hard reset follow the steps above:
1. Turn off the phone.
2. Press both the Volume Up and Volume Down
3. While keeping pressed volume Up/Down keys, press power button
4. You should see a RGB screen and then a message asking you to press volume up to do a hard reset. Do it.
5. Wait for the process to complete and you will have a clean phone.
If that won't work, you can try to flash the phone with the rom here:
http://htcpedia.com/ruu_mega_htc_europe/soft/mega-touch2-rom?page=2?page=2
Please do not forget to hard reset after flashing.
If even this will not work, you have a hardware problem and you should have your phone checked by a service.
Hope this helps.
Good luck!
it worked with hard reset
thanks. it worked with a hard reset.