Hi,
Today i found my O2 screen hung completely.My Stylus is not able to click on any icons.The Screen does not respond at all.
I tried soft and hard reset,battery removal etc but nothing works.
I observed that in my screen there is a large moisture blob inside.When i touch it spreads.
mY PHONE HAS NOT BEEN EXPOSED TO WATER EXCEPT MY Sweat.
Any suggestions freinds.
praveen
my htc hermes (herm100) does the occasional white screen here and there, but i dropped it (like a foot away from the floor) and it almost always white screens, the phone will come on, the ATT logo (like the bios thing) will load up and everything, but as soon as its about to play the 3g animation, the screen fades to white, but everything works, the 3g sound plays, the screen responds to touch, etc. the screen also displays perfectly when i start to do a hard reset, the screen comes up to press r and all that, then space to boot, then the screen goes white again. i've taken the phone apart, checked everything out, made sure the ribbon cables and such were set properly, everything. If this helps, my camera had stopped working the night before...when i would click the camera button or started it from programs, it would say somethin along the lines of "the camera could not be started. initialization of camera failed" and i was actually gunna be asking about that right now til it uber white screened. Any help is appreciated.
White screen
Hi i'm also having the same problem with my hermes 300, Dropped off the back of the bed onto skirting board, about 1 1/2 feet. Started to white screen soon after this. Like you say when you format it the screen is fine until it gets past the first boot screen then slowly fades to white. Have heard stories about the ribbon cable to the navigation on the front. any help apreciated
Update: Took Hermes apart nad reseated the d-pad ribbon, everything seems ok. Thanks to Mike channon for the Disassembly manuals. Hope this helps other people.
I got the glass (or digitizer) replaced by a online shop. The touch screen works now, but I got white screen while booting.
At first the screen pulsed for a while and then changed to white from the center. Now the whole screen is white when I press power button, and the corners changed to black after boot (as the image).
Is this because of the flat cable, or my original LCD got replaced/broken when they repairing it?
Back story dropped phone last week onto carpet, no cracks or shattered glass phone had a tempered glass screen protector and case, screen stops displaying images phone is working however.
Get screen replaced upon initial boot the phone hangs on LOS boot animation, enter recovery perform factory reset all is well for the rest of the night. The following morning I turn the screen on with the home button after a few seconds the screen goes black, back light is visible along with the buttons at the bottom of the phone, the phone is working I can hear emails coming in.
Is there a chance LOS is not playing nice with the new screen or could another piece of hardware have been damage?
Hi. I had done a successful repair of the screen on my Nokia 6, not to long ago. However my screen was being lifted away from the phone by the case. So the screen was pushed back down back into the phone, and it was lifting again. However I got this weird effect on the screen (attached photo). It seems to fade in white... I can still use and see Android. Any suggestions?
Here is the photo
The screen is broken.