My Diamond is about to go in the bin!!!
If anyone knows how to edit the registry to "switch off" the volume keys on the Diamond then please, please, please help me.
The volume screen is permanently flashing on my screen, and seems to be stuck on the up button which means I can't use the phone. it's not a hardware issue as the buttons aren't stuck or won't work, it's from a bad flash (according to HTC!) - i've tried stock roms/MTTY etc but the problem still persists from one rom to another.
Any registry experts willing to help
Related
Hi,
For two days i have some screen problems. My touchscreen does not react on touch. If i use the buttons it works but on the screen it doesn't. Sometimes it does work for a few minutes.
The buttons always work (but ther are just a few buttons )
Anyone knows what to do?
Have the same problem. The touch screen goes dead but the buttons below works.
Anyone knows how to rectify this problem?
I had a HTC Touch earlier also and had to give that for repair for the same problem.
I have the same problem with mine, hopefully someone have a solution for this would be very appreciated.
MrQ
Anyone found a solution to this?
My new HTC also now is facing the same issue. The touch screen has gone totally invalid. The bottom buttons work but the touch screen does not. The other big problem now i have is that the phone is locked and i am unable to unlock it.
GOD, if there is a GOD, save my HTC.
I presume you've done soft resets to the phone and it doesn't fix the problem.
Have you flashed any ROM to your Touch? What ROM did you flash if you have? See if it's a common problem with flashed ROM's.
If not, and you're on generic ROM, try to do a hard-reset and see if it fixes the problem. (Hold down both green and red button and poke the reset button while still holding down the 2 buttons). You will lose all the data on your Touch.
If doing a hard-reset on a generic ROM still doesn't fix the problem, then I'm afraid you have a HW problem. Send it in for repair if it's still under warranty.
well u can also try this, it may be because of pressure setting for the screen
"install a reg editing software like PHM and go to HKEY_LOCAL_MACHINE and then DRIVERS and then TOUCH PANEL; now change the value of PRESSURE THRESHOLD. Remember to increase the valur only, try doubling the value acc to ur need"
If you don't have any warranty and a hard reset didn't work (note if you hard reset and it doesn't work you will be stuck at the screen alignment) then you may be facing a defective digitizer. If you are brave you can take a look at this link (complete dissasembly of Elf)
http://forum.xda-developers.com/showthread.php?t=407323
to study how to take your device apart to replace the digitizer yourself.
I seem to have lost the vibration feature on my buttons. All tabs are checked. Not recovered even after a hard reset. Probably a pre-hard reset app I'd loaded affected this.
Does anyone know of a reg tweak or another fix?
Thanks for the help
Simon
Does your phone vibrates when called?
Hi - thanks for taking an interest. The problem seems to have corrected itself.
I had to re-load .net CF 3.5. Don't know if that had an effect but after the hard reset and a couple of soft resets the buttons vibrate again.
Thanks again
Simon
3rd Occurane
Sky740, did you experience this problem again? I have not installed any other ROMs but noticed it after I installed some other software, including hd tweak, advanced config, mobilmagic button stuff and .net framework 3.5. Did you use any of these items/think they anything to do with it? I hope my problem goes away with my first Upgraded ROM. I saw another thread with the same problem, he was about to send back for warranty, but maybe I talked him out of it. Any information helps,
Thanks!
HI Guys,
Did you manage to figure out what is causing this? I have just got my HD and have the same problem...the 'haptic' vibration from the buttons doesn't seem to work. it has been like this from out of the box and i have not added any additional progs (only got it unlocked from Orange!!). the vibration works for incoming calls so it doesn't seem to be an issue with the hardware.
Any advice would be appreciated!!
Regards
~Cinner70
well
well, haptic feedback you mean, any button you press, on touchscreen and all? The only buttons that are suppose to have feedback without touch response application installed is the home, back, phone answer and hangup buttons at the bottom. There is a setting for those vibrate items. Try settings, personal, buttons, virtual button, see the vibration check mark? Does the Teeter game have vibration feedback on yours? If these things make a difference for you, you probably don't have a hardware issue, but if your getting any vibrate, should just be settings. Some of us on here are having major vibration hardware dysfunctions, just awful
Thanks for the response!!
Sorry to hear 'bout the major vib issues
I have tried all the 'virtual buttons' settings and the touch flo settings but i dont get any response from any buttons. i tried TEETER but there's no response from that either, but again i get vibration when I'm called.
Just thought someone may have noticed a 'glitch' somewhere, cause i initially noticed that if you apply a phonelock pin on set-up, it disables the use of the end-key to lock the phone..and i thought it may have been a software glitch or something....
New to the phone and win mob so soz if these are noob q's
Cinner70
My Diamond is about to go in the bin!!!
If anyone knows how to edit the registry to "switch off" the volume keys on the Diamond then please, please, please help me.
The volume screen is permanently flashing on my screen, and seems to be stuck on the up button which means I can't use the phone. it's not a hardware issue as the buttons aren't stuck or won't work, it's from a bad flash (according to HTC!) - i've tried stock roms/MTTY etc but the problem still persists from one rom to another.
Any registry experts willing to help
Not sure how you can achieve this if the volume is always on top but if you install AEbutton you can unmap the volume buttons
thanks for the reply i'll give it a try
What happens if you leave out volume control? I guess MS volume control would prolly pop up then ?
skilty said:
My Diamond is about to go in the bin!!!
If anyone knows how to edit the registry to "switch off" the volume keys on the Diamond then please, please, please help me.
The volume screen is permanently flashing on my screen, and seems to be stuck on the up button which means I can't use the phone. it's not a hardware issue as the buttons aren't stuck or won't work, it's from a bad flash (according to HTC!) - i've tried stock roms/MTTY etc but the problem still persists from one rom to another.
Any registry experts willing to help
Click to expand...
Click to collapse
I can almost 100% sure tell you that it's hardware there is a sensor underneath the button that is probable stuck. because if it wasn't then a rom flash would have fixed it. there is a spray don't know what it's called in
English but something like contact cleaner it cleans electric parts for dust
gullum said:
I can almost 100% sure tell you that it's hardware there is a sensor underneath the button that is probable stuck. because if it wasn't then a rom flash would have fixed it. there is a spray don't know what it's called in
English but something like contact cleaner it cleans electric parts for dust
Click to expand...
Click to collapse
Thanks for the replies everyone, AE button seems to have fixed it, although i'm not 100% sure that it's gone yet, as it could stop for a while and start again.
HTC did say it was a hardware fault caused by installing hard spl/custom rom (although I only left Hard spl when I sent it back..by mistake ) and wanted to charge me £230.
i'll try the spray cleaner anyway I don't think it will do any harm.
Thanks again for all the replies, at least it's semi-useable again...
Hello,
These last days I had a lot of problems to align the screen of my Samsung Omni Addict player I900. The problem is that the touch screen is not centered anymore and it does not react when I press something on the screen.
To solve the problem I wanted to make a hard reset by using the following key combination "*2767*3855#".
My biggest problem is that, by mistake, I did lock the screen and keys of the phone and then when I press any key, my phone ask me to press the "Unlock" option on the screen, but I cannot do it as the touch screen does not react correctly.
I'm wondering if there is any possibility to edit the register to be able to unlock it.
Any other ideas are welcome. I'm blocked on this problem for two days now
Thanks in advance for your help,
Alain
Maybe I'm missing something but... can't you just soft reset it? I don't think it will boot up screen-locked....
Soft reset didn't help but after multiple tries I managed to do an hard reset which did solve the problem.
The problem I'm facing to now is that I cannot align the screen. As recommanded in different posts in this forum I have changed the CalibrationData value in the registery but still, after following the "align screen" procedure the screen does not react correctly. To be able to move forward I would like to be able to activate the mouse cursor. Do you know how could I activate it by changing a value in the registery?
If not I will create a new post with this question.
Thanks in advance.
Alain.
I'm sorry, haven't had an i900 in my hands for a while now, I don't remember which reg key you need
Hello. I would really appreciate help on this one.
I recently got an HTC HD mini T5555, OS version: 5.2.23103.
After performing hard reset everything on the cell works perfectly.
However, after a software installation, the volume buttons won´t make any change to volume when pressed.
The volume controll dosn´t even show up in the display. Now, If I perform yet another hard reset,
(the software installed will be removed) volume will be changable again.
The software itself has a built-in function for listening to music, making cals etc.
From within the software you can change the volume using its own controls (not HTC volume control).
That works fine.
The software is called "Handi".
"Handi is a program tailored for people with cognitive disabilities.
The most fundamental difference between the Handi and "normal" hand computer program
is that Handi-programs have far less information and less choice per view".
I have no experiences from other hand computer programs but assume they all work the same way.
I´m sure there is a way to fix this in the registry. Anyone got ideas or useful advice?
Need more info? I´ll try to give you as much as I know about it.
Thanks in advance!
Regards /Anders
First things that came up my mind:
1. The volume buttons are disabled by the software
2. The Volume software is overwritten (reg keys, or other files)
Maybe here is a solution by installing a cab with volume control:
http://htcpedia.com/forum/touch-hd-rom-development/1161-[request]-htc-volume-control.html
More custom volume controls:
http://forum.xda-developers.com/showthread.php?t=598997
But be careful, modifications can make you do a hard reset .
I installed the CAB but still the same...
Gonna search the registry instead. Thanks anyway!