This must be a hardware issue at this point... *228 opt 1, soft reset, hard reset, switch back to VZW ROM, completely disassembled phone and made sure all connections are secure. The speaker itself is soldered in but I had read other models have dry connections that can come loose after a drop. I think I did drop my phone before the speaker stopped working. Speakerphone speaker still works. LEDs still work.
Before I spend the $50 to get a replacement (please don't discuss what comes from insurance these days... plenty of other threads on it) I thought I'd ask if anyone had a similar issue and had fixed it. There are other threads with the same/similar issue but there was never a solution other than replacement. Before I send it in I will try to test whether the speaker failed or if the audio signal is not getting to the speaker. In case it is the speaker, does anyone know a source for a replacement? I see them for other phones but none for the 6800.
BTW... in case there is a trend, I was on R4R Beta 4 and had not done anything with the audiopara.csv.
~Scott
Reading 27.6 ohms on speaker. Anyone have a similar speaker (or spare 6800) that they can tell me what resistance they get on it? 27.6 ohms sounds high. Speakerphone speaker is at 7.0 ohm.
Very late reply, I know. I have started having the same issue. I am getting 28.9 Ohm reading on the earpiece speaker.
Hope I can fix this problem! I don't have insurance!
Related
My XDA Mini seems to think that the headphones are still plugged in when they are not. Therefore I can't hear any sound come out of it unless I plug the headphones back in. Has anyone else experienced this? Is there a way to fix it? I have done both soft resets and hard resets. I've had the phone for 4 months with no problem until now.
I'm sorry, I can't help you, but a have a very simular problem.
I used the antenna cable connector to get better reception, but when I took out the connector it seems that the MDAc didn't switch back to internal antenna. I've got nearly no reception (~10% as usual).
Maybe someone can help us both.
This may help;
http://forum.xda-developers.com/viewtopic.php?p=90321&highlight=#90321
I have the same problem, and I am currently just living with it (I just a headset most of the time), but I will send it in for service sooner or later.
WD40 didn't help in my case...
ej, I had the same problem, ie no sound coming out of the rear speaker. At first I thought it was a problem with the headphone jack plug. Then I realised it was the external speaker that was defective. When you have the headphones plugged in, you should still hear the ringtone from the external speaker when someone calls you. If you do hear a ringtone, then it's the headphone switch. If you don't, it must be the external speaker.
I sent mine back to Germany (mine is an MDA Compact). T-Mobile could not repair it and replaced it with a new one!
I also had the same problem with my XDA II, and no amount of hard resets would fix it.
Strangely, it fixed itself after a few days. It seems like there's a design flaw in the sound hardware across the whole range of PPC devices produced by HTC.
I wish they'd get it sorted out!
-no1
The speaker on my I-mate appears to have "blown". Sound still comes out of it but it is a bit distorted and the volume is low. When using a plug in heatset the sound is fine; so I do not feel there is an electronic or software problem.
So.... How can I get this fixed? Are there replacement parts available?
Thanks for any help.
btw, I am in the U.S.
How to fix it...
Hi,
I experimented sort of the same problem.
It turned out that it was the speaker connectors because they where not making solid contact with the motherboard. As you can see on the walthrough, the speaker is not soldered to the motherboard, instead HTC used a spring mechanism that conntects the speaker to the motherboard when assembled. Over time, some devices tend to loose this solid contact so the speaker starts to loose it's power and eventually fail. However, there is a way to fix it yourself if you already ran out of warranty and if you like to take things apart...
Here's my walkthrough: http://forum.xda-developers.com/viewtopic.php?t=8525&highlight=
Good luck!
Rayan
Re: How to fix speaker problem
This is great Rayan !! I _will_ try it and let you know.
My speaker stopped working full stop a week ago. At least the vibrating mode is fully operational but, of course, this has nothing to do with the speaker's functionality.
A colleague suggested getting a bluetooth headset for operating the phone through it, in case there is no solution to the speaker problem.
I do not know whether anyone tried this alternative but if they have, I would like to know if it worked (just to get a feeling of whether there is a workaround solution too).
Thank you Rayan.
K.
I did it ! Success
I lost the loudspeaker-sound in my Himalya. It works using headphones. I think it may have to do with another set of headphone I connected to it, which was not original. Perhaps it put the device on permanent headphone mode. But then again it might not have anything to do with that.
Is there a Himalaya expert in Berlin - Germany who might be able to help me with it? I dread having to send it to the official reapir center, as I expect it to cost a neck and a hand.
Happened to me when I received a call whilst listening to music. I pulled the headphones out before answering the call, and then answered it. I could here them but they cvouldn't hear me. If you plug the headphones in again and remove them it solves the problem. Well it did for me anyway
I tried that. I doesn't do it. It doesn't matter what kind of sound, if Media Player file is played of phone ringing, only the headphones work. I think I need a dotor.
I have read a lot about the problem in others threads. It seems the headphone-jack can get stuck, not making a contact, which normally is being made and which turns the XDA back to speaker mode, when the headphone-jack is pulled out. Hereto:
1- What does that mean exactely? Which part is that, in what part in the on-board jack? If it had been bent out of place, is it possible to bend the part pack (at best without having to disassemble)? (I tried the ramming in and out, no go).
2- I looked at the non-original jack I had used and it is about 2 mm longer than the original. Might perhaps that explain it? Is there a part in the back that could have been bent out of place?
3- If indeed this was the problem (if the jack had been bent out of place, one way or another), would the microphone work? I can record using the dictaphone and the micophone also works during a call.
When we had himalaya's it happened to both of our devices (my wife and I had one each).
It appears the spring in the speaker can come loose. I used to bang mine (pardon the pun) on my palm and sometimes it would start to work. Then we broke the speaker protection shield, and this made it easier sometimes and hard to fix in others.
When I sold it, my friend took it apart as it was out of warranty, and as he is electrically minded, he find the dodgy bit, and soldered it to the device, and now works perfectly.
Yes! Thanks Jasjar. It worked after a bit of beating.
I found a detailed instruction of how to fix it permanently in another thread. Sounds complicated and dangerous but eventually I must do it.
ran2far said:
I have read a lot about the problem in others threads. It seems the headphone-jack can get stuck, not making a contact, which normally is being made and which turns the XDA back to speaker mode, when the headphone-jack is pulled out.
Click to expand...
Click to collapse
Sorry for kicking the topic, but this was the solution for me. I just poked in the headphone-jack with a little stick and tataaaa... my sound is back!
Sound lost problem
Hi all,
same happen to me, the sound stoped working (on my side it had nothing to do with the phone jack).
After the modifaication which is described in this forum i had still the same problem so i solder the loud speaker directly - still same problem...
After some time i flashed the device again, now it works, so on my side it was a software problem...
The device was 3 month out of power, but i think remove the battery and if the sound appears on startup (on first boot) but later not, then flash the os and it will work ...
kr
chw
XDA 2 sound problem...
Hi!
Plese help me!
I have strange problem with my XDA 2.
I bough it 2 days ago. It was in O2 network.
Now when I unlocked it for my network (polish ERA-GSM) I saw that when I'm calling I cant hear anything. Person from the other sight can't hear me too..
XDA have sound becose I used media-player ando other sound stuff, thats why I think that speaker is ok. Microphone is ok too becose I can record animations with sound.
So what should I do now? ;/
Plese help...
Just for reference:
A friend of mine had this 2020, and both Speakerphone and mic were not working.
When somebody called, the ringtone DID sound.
Anyway, bluetooth handsfree worked fine.
All we did was play with the jack, using the stylus! Not even headphones...
And now it works fine!
He says he'll never put phones on it again... lol
cu around!
Looking for more Info
Hi, please help me find which points in the MDAII Motherboard can I solder to disable the headphones and get the audio and mic back to the MDA.
After a while my headphone-jack is broken from the motherboard and now I only have the pin outs in it.
The device is working perfect, and I can use bluetooth headphones. I just don't have audio in the speaker and no mic without bluetooth.
I hope someone can tell me which of the red points en the picture can I solder to disable the headphones.
I just want to do this temporally until I get a replacement spare part for it.
Thanks
EDIT: 12-12-2007
I got it. Just joining 1 and 3 and you will get audio back to the PDA disabling the headphones jack.
Thanks anyways for reading this..
Did you find out what all the mboard pins are for the jack?
I have a dodgy jack and would like to take flying leads of the mboard jack to an external (easily changed) inline jack. Does any know what the 1 to 6 pins correlate to. I would like to still switch the audio via the external jack. Not bothered about the mic.
TIA.
I have a bit of curios problem with my TD2. During a phone call i get a sound distortion / vibration from the earpiece. It makes no difference if i change the volume level. Playing music or using the speaker phone does not cause the problem. So i'm not sure if it's a software or hardware problem? Has anyone else found this problem? or have any clues for me.
Thanks in advance
Smog
It isn't related to the "vibrate on connect" feature is it?
No i have that disabled. It sounds like when a music speaker has a damaged cone and vibrates / distorts or there is too much bass?
The distortion in my earpice goes away at 80% volume. Is very annoying. It distortes on bass (low frequency) very much on 100% volume. The D2 speaker is very crappy. I wonder if there is a solution to this (software bass reduction of the incoming calls).
I agree the earpiece is utterly crap, the distortion goes at 50% on my TD2! Have spent sometime looking if there is anysoftware solution but to no avail!! I'm debating weather to return it under waranty as a faulty phone and see where i get.
any solves on this issue?
Mine too have the same problem, but i was told by others owners that this situation is not normal.
They say it´s a faulty device.
Result!! My touch screen went faulty so had to send the phone back in for warranty repair. I mentioned that the ear piece may also be faulty and requested them to take a look. Phone returned with new screen, new housing & i must assume a new ear piece. All distortion has disappeared even at 100% volume!!!
Maybe it's not the thread to mention it in (apologies to all those with problems) but when it works properly the TD2 has the best sounding earpiece of any phone I've had, including two other HTC ones. It actually has bass!
The distortion described sounds like the moving part is partially rubbing against the fixed part. In a proper speaker this can be caused by dirt or dust trapped between magnet and coil, or distortion of the coil through overload or temperature changes. I would send the phone for service 'cos it sadly won't get better of its own accord.
I replaced the housing on my old BB Pearl, and my G1 (which was way, way more complicated).
I've got a Magic now, and the ear speaker is acting up. When I make a call, sometimes the ear speaker is just dead - I can switch to the speakerphone no problem, and then when I switch back I usually have sound in the ear speaker, but I suspect physical speaker damage because sometimes it'll cut out and I can squeeze the top of the headset just right and it'll come back. Crossing my fingers that it's not something else electronic in the board.
I want to replace it - and while I've got it apart, may as well give it a new body since they are only $10-$15. (wish I could upgrade it to the Fender body with the 3.5mm headphone jack lol)
Problem is, although I can find new housings all over the place (including eBay), I can't find the replacement speaker anywhere but some GlobalPartsDirect website, and they have a 5-unit minimum wholesale order quantity.
Any suggestions on where to look? Thanks in advance!!
Bump on this-
I had PM'd a seller on Ebay who said they had one - just waited over 3 weeks for it to arrive, only to discover they sent me a replacement speakerphone speaker.
I could not have been clearer with them that it was the ear speaker that was not working.
Any help is appreciated - I now need to resolve this urgently, as I can't use my phone as a phone, and I'm postponing all sorts of things that I need to resolve - of course the timing is such that I need to liquidate some things and I can't set up Craigslist ads because I can't talk on my phone. Please help!