Hard Restart for MDA - 8125, K-JAM, P4300, MDA Vario General

I attempted a hard restart for my MDA using the comm and photo button technique, but all that comes up is 3 wide horizontal bands colored red, green, and blue with IPL 1.08 and SPL 1.08 printed at the top. Can anyone help?

You're stuck in bootloader mode. Possibly a corrupted extended ROM, but more likely just a bad flash, entirely. Connect it to the computer you usually flash from via USB. As long as you see "USB" in the lower right corner, you can flash and fix this.
IMPORTANT: Is your phone G3 or G4? If G3, was it CID unlocked?
If your phone was not CID unlocked, or if it's a G4 (and apparently doesn't have HardSPL installed), you're going to need to load the original T-Mobile ROM to the phone.
I'm not as well versed in the G3, but I THINK, if you are CERTAIN it was CID unlocked and is a G3, you can probably safely flash any of the cooked ROMs in the Wizard Mobile 6 boards.

Related

8125 stuck on RGB screen

My phone is stuck on the RGB phone screen.
IPL:1.01
SPL:2.25
USB
I'm pretty sure that meant it was a G3 phone (though before the IPL was 2.25 too) I am a complete noob with this and I don't know what to do, help!
Grimmore said:
My phone is stuck on the RGB phone screen.
IPL:1.01
SPL:2.25
USB
I'm pretty sure that meant it was a G3 phone (though before the IPL was 2.25 too) I am a complete noob with this and I don't know what to do, help!
Click to expand...
Click to collapse
There's nothing to worry,as long as it gets into bootloaders (RGB) its safe.After flashing Button's Rom 1.05,it usually happens that IPL gets down to 1.xx but SPL remains at 2.xx.just reflash the button's rom a few more times and SPL will also downgrade to 1.xx or try the xda_minis_launch rom.
CgeerS!

Bricked Herald

Hi there.
I am going to buy a very very cheap new Herald.. One bad thing. It's bricked. But bootloader (Tricolor) runs. My question is: How to flash official WWE ROM WM6.
(HTC_P4350_SPA_4.17.412.2_4.1.13.44_02.94.90_Ship.exe)
What IPL / SPL version does it have?
If its lower than 4, you may want to reconsider buying the phone since it may be permanently bricked, requiring being sent back to HTC which will only mean more $$$
TO check the IPL SPL version, you need to go into bootloader mode, which means hold down the camera button and soft reset the phone (sticking the stylus into the reset button the left side of the phone under the volume slider) while keeping the camera button pressed the whole time until you get a tri color screen with the version numbers. If they are less than 4something... you run the risk of permanently bricking the phone
ok..
Bootloader seems to be showing this:
IPL 1.11.0001
SPL 1.11.0001
USB
This is not good, or yes?
Ok, another way...
In attachment is picture of bricked Herald. Is any way to unbrick it - WM5/WM6?
Stock RUU ?
Are you guessing or you know what I have to do?
The problem with having an IPL/SPL thats less than 4x ... is that from my understanding, once its bricked ... there's no way to fix it without sending it to htc..
If you buy any chance have a stock ruu to try to run on it, but i don't know if that would work.
Try one of the htc roms from the herald wiki
HMmm.
To big risc for me. I don't know if that would be unbricked. I am go away from it. Sorry.

HELP: XDA Charmer Problem IPL.2.06.0001 - SPL 2.06.001

Right, I have a massive problem.....Been debranding HTC and all for ages now using this great site. But now it happened. I was trying to install WM06 on a charmer and well my comp froze partially in the process....Now I can get to the tri-color screen but cant flash there oddly enough. And when I normally start it, I get the splash with the info
IPL 2.06.0001
SPL 2.06.0001
GSM 02.69.21
OS 6.1.0.0
The major issue I have is when I use USB TTY, it says not the proper security level. I know many wrote bout this issue already but jst seconds before I unlocked the phone using Lokiwiz so I thought I am CID unlocked??
Any help??

HTC P3300 stuck in boot screen

hi.
i got this p3300 and it doesnt fully turn on.After i press power in remains stuck on the boot screen : the one with the HTC logo and info about the rom:
IPL 1.12.0001
SPL 1.12.0000
GSM 02.67.90
OS 1.12.0.0
I tried to flash rom but it fails at 2 or 3% saying image file corruputed which i think its right because i dont think it was unlocked so you can write any rom you want.
I also tried USPL but that i get "NO devive connected" so i cant unlocked my device to write a proper rom into it.
I did all the above with the device in boot mode (record button+reset).
Any ideea?Pls help.
Thank you!
?
tried flashing with HTC_1.12.405.01_026790_WWE_SHIP says invalid model...
T-Mobile dead loop ?
I have similar problem with my artemis. I have a HTC P3300 from T-Mobile. It started with switching itself out, then it didn't want to boot, then it began to hang on bootscreen and at the moment i cannot start it at all (even the battery is fully charged and it is pluggen in my PC).
I suspect that T-mobile build in a dead loop somewhere in the software or hardware. It looks very suspicious to me that both mdas i had from T-Mobile start to make problems exactly a month or or two after the warranty is expired. and the problems develop in the same way in deteriorating manner.
It could be that the hardware cannot take it anymore and it starts to deteriorate exactly after the second year (handy for two years contracts).
Does anyone similar experiences or anyone solved that problem.
Sorry mates I cannot provide you with any info about my PPC (radio, rom version etc.) because I simply cannot get so far to be able to see that information.
Looking forward hearing from you
Cheerz
Hi, my problem is similar, but I need the ROM in ITAlian.
Information about my cellphone:
IPL 1.12.0001
SPL 1.12.0000
GSM 02.67.90
OS 1.12.0.0
Any ideea how to download this ROM? Pls help.
Thanks, Fernando.
Here the same...any one help?
kappp13 said:
hi.
i got this p3300 and it doesnt fully turn on.After i press power in remains stuck on the boot screen : the one with the HTC logo and info about the rom:
IPL 1.12.0001
SPL 1.12.0000
GSM 02.67.90
OS 1.12.0.0
I tried to flash rom but it fails at 2 or 3% saying image file corruputed which i think its right because i dont think it was unlocked so you can write any rom you want.
I also tried USPL but that i get "NO devive connected" so i cant unlocked my device to write a proper rom into it.
I did all the above with the device in boot mode (record button+reset).
Any ideea?Pls help.
Thank you!
Click to expand...
Click to collapse
Have you tried the CMON USPL? It's on Shady's ROM (the lite one) run this first! Be in Bootloader. Hold the Record Key (left key) and by holding that press Power key to switch on! Then try to Update your ROM

Trouble with flashing HD2

I have HTC HD2 from T-mobile.
Decided to flash it.
Hard SPL 2.08 is installed.
Started with a radio. Enterd the bootloader, connected it with the PC, everything was fine, but in the end a messadge came up that it could not update the software. The device whent dark, and now an all attemps to enter the bootloader it shortly vibrates and that all, the screen remains black.
Please, tell me how to reanimate it.
DarkPaLadin said:
I have HTC HD2 from T-mobile.
Decided to flash it.
Hard SPL 2.08 is installed.
Started with a radio. Enterd the bootloader, connected it with the PC, everything was fine, but in the end a messadge came up that it could not update the software. The device whent dark, and now an all attemps to enter the bootloader it shortly vibrates and that all, the screen remains black.
Please, tell me how to reanimate it.
Click to expand...
Click to collapse
can you give more info please,
what radio did you flash and what rom?
thanks
Like I said it's HTC HD2 from T-mobile.
I've recieved it unlocked with ROM "Moon light 1.23" and Hard SPL 2.08 is installed.
Moon light had some bugs and I've decided to flash the device with "HTC_Leo_WWE-djet". Install went fine but the device refused to load futher then the screen with "Stick Together". I was told that it is becouse of old version of radio, so I've dowloaded "Leo_RADIO_15.28.50.07U_2.05.51.05_2.nbh" and tried to install it.
And faild. Please advise.
DarkPaLadin said:
Like I said it's HTC HD2 from T-mobile.
I've recieved it unlocked with ROM "Moon light 1.23" and Hard SPL 2.08 is installed.
Moon light had some bugs and I've decided to flash the device with "HTC_Leo_WWE-djet". Install went fine but the device refused to load futher then the screen with "Stick Together". I was told that it is becouse of old version of radio, so I've dowloaded "Leo_RADIO_15.28.50.07U_2.05.51.05_2.nbh" and tried to install it.
And faild. Please advise.
Click to expand...
Click to collapse
Hi. did you actually try downloading directly from your local HTC website the last original ROM inserting the serial number from your HD2?
if you took off the battery and put it back, when starting your device pressing down volume key and power on at the same time.. does it enters to bootloader?
if it enters to bootloader, consider trying a task29 cleaning and only then flash the ROM.
DarkPaLadin said:
I have HTC HD2 from T-mobile.
Click to expand...
Click to collapse
If you have a USA tmobile, (tmous) then radio 2.05.51.05 has killed it and it is dead.
DOes it say tmobile on the case? does it have green send key and red end key? (all other hd2 have all white keys)

Categories

Resources