I was using my phone today, and now all of a sudden, the power button is completely non functional, and every 10 seconds, I get a "Do you want to power off" prompt on my phone as if the power button was being continuously pressed, but it is not. What could have gone wrong?
Any Luck?
I currently have the exact same issue. I lost my phone, and the person who found it returned it. Eversince then the power button doesn't work and I get the same warning.
After lots of hard resets and a new ROM flash, I was good to go.
Related
Hi guys, I hope I can type this coherently.
I have a g3 wizard that I have flashed many times over the last year or so. Lately the power button has stopped working. I can get the phone to turn on by plugging it in, and then holding in the camera/voice buttons and THEN hitting the power button. It goes into the rainbow screen, and I just soft reset via the hole on the side. At that point it is on and running fine, but the power button does nothing.
The power button does nothing at all unless I plug the phone in, and then only if I go to bootloader. It seems to work just fine to do that-which is what is stumping me. I thought the button was just broken. The charge/battery lights do come on.
For now I have it set to never turn off, so I try to make sure it doesn't run too low. The battery life seems ok. Any tips? I want to be able to put the phone to sleep again...
thanks
I have problem with power button. when push pwr button dont,t off pda, but when hold pwr then lights off.
Power is never shut off in PDAs, thats the way PDAs have been designed.
I have the same problem, he is not talking about a full power down. If you hit the power button quickly the phone does nothing. However if you hold the power button down for about 2-3 seconds the lcd light turns off as it should.
Because of this I have to wait 1 minute for the unit to suspend before putting it back in the holster.
Does anybody have any idea as to why this might be happening. Im not new at this so hard reset, soft reset.. new rom... new radio...turning up side down while chanting. It does not change......
It will do it right one or twice in a week.
Maybe somebody that understands the signal that the unit receives upon pressing the power button might be able to shed some light on this.... Again the button does seem to operate just not suspend when pressed normally (1 second or less)
I have done some more research and this seems to be a common problem for some with BAs but nobody has found out why. There must be some kind of common hardware fault.. Does the power button send only one signal or is it a multi signal device.
afbcamaro said:
I have the same problem, he is not talking about a full power down. If you hit the power button quickly the phone does nothing. However if you hold the power button down for about 2-3 seconds the lcd light turns off as it should.
Because of this I have to wait 1 minute for the unit to suspend before putting it back in the holster.
Does anybody have any idea as to why this might be happening. Im not new at this so hard reset, soft reset.. new rom... new radio...turning up side down while chanting. It does not change......
It will do it right one or twice in a week.
Maybe somebody that understands the signal that the unit receives upon pressing the power button might be able to shed some light on this.... Again the button does seem to operate just not suspend when pressed normally (1 second or less)
I have done some more research and this seems to be a common problem for some with BAs but nobody has found out why. There must be some kind of common hardware fault.. Does the power button send only one signal or is it a multi signal device.
Click to expand...
Click to collapse
Do you have a problem with turning on? First, we need to know whether it is hardware issue or not...
What you can do in the mean time with the turning off problem is by installing a poweroff app like shutdownme, psshutxp, etc etc...
Absolutely no problem with turning on from standby... Right now i just lock the phone before placing it back in the holster.
To make it clearer if you HOLD the power button down the backlight will turn off only. It will still show the display image and keys will still function (it dims)
Well, I had the same issue with the latest WM5 ROM. I thought I was too stupid to press the button, then I thought the button was broke, then I thought, I'll have to live with it.
Now that I have flashed to WM6, no problems at all! Never even came to my mind that this problem once existed. So I guess that some ROMs just have this particular bug?
Stefan
I have tried all the roms as well as 2003 and have the same issue in all of them. And im not alone.
Power off Problem
I'm in same condition.
Had the same problem when using WM2003 second Ed.
Now I've installed WM6 but nothing changed:
I cannot power-off/suspend but can turn off backlight if press and hold power button.
When in standby the button works fine to turn on the device.
Also, sometimes volume turns up continously with "noisy" beep ...
Anybody solved this problems?
Thanks,
Ruben
(WM 6 - 5.60.00 build 18125.0.4.2
radio 1.12.00 )
Power button has two modes:
1. Click mode: Click it once for a short duration. This turns off backlight and can be resumed by pressing it again or by pressing OK button
2. Press and Hold mode: Press and hold for few seconds and release. This mode will dim the backlight and no other button will bring it back. This is some kind of deep sleep in battery mode. To resume the original setting, press and hold Power button again for few more seconds.
(p.s.: I am not sure if this behavior is true for all the BA models)
April 1,
I know these modes...
It seems that "mode 1" doesn't work at all...
I would activate "Button Lock" (settings-->button--> Lock(tab)--> "lock all buttons except power button") to turn-off backlight and "lock all buttons except power button" but I cannnot...
You solved this problem?
I have had this issue of not being able to power off. One way I always got out of it was by clearing the registry hive. Unfortunately this brings the PDA back to the basic ROM. At this point the power button worked without any issues. Upon reloading the software the problem may come back. I believe the issue is related to some programs. I can't recall which program it was that seemed to cause the issue. One other thing I think that also worked was just entering the registry and getting back out and doing a hard reset.
I had the same problem with my 6600. the message button also didn't work. Believe it or not, to fix it. I banged the lower half (4-way area) on my desk a few times. Not hard enough to break the screen. But prolly hard enough to free what was prolly a sticky key. And now everything is working.
i am too
the same ...
when i press the power quickly , nothing happen
when i press the power for 2 sec. the backlight turns off
i tried every thing .... including formatting my BA
any one solve it ???
I have this same problem, my power button does`t work. i tried installing different roms but without any chance to fix it. maybe its an mechanic issue. i will change pwr button, i hope this work.
Look at one of my previous posts. I fixed it, twice, and other users have used the same metod to fix it. I think the problem is "hung bit" hardware related because you can also send it in for service, and they will change a chip, but i never had to.
Power button does not respond at any point.
*EDIT:except after battery out for a long time, then power button WILL turn the phone on, but then continues to not function as per usual.
However, the phone automatically turns on as soon as the battery is placed in, so it's not dead at least.
Also can not get the phone to be recognised on either of two computers (one running Win 7 and the other Vista) always get "device has malfunctioned etc"
Have re-flashed a ROM from SD but same problem. If holding down the Vol Down on start up (putting the battery in) I can get to bootloader, hence the re-flash. But holding down both gets to the hard reset 'warning' screen, but it won't let me press Vol Up to actually do the hard reset.
All in all a frustrating problem which means I have to remove my battery to turn my phone off and have to use the option from Windows Menu to lock the device.
Any help with any of the problems is greatly appreciated.
Also Power Button mechanical function is still normal.
Many thanks.
Sounds like your end key has become faulty as well as your volume up button. Both of witch are common issues, especially the end button, but most peoples volume down button wears out first. This is do to the fact that the end/power key is in constant use from turning on and off the HD2 or from getting MAGLDR to pulled up a bootup for those running NAND Android. Also the volume keys take a lot of wear and tear from constant volume adjustment especially if you listen to alot of music on your HD2. Plus the volume ..down key takes extra wear and tear from being used to enter bootloader.
hello
hello vsem
Yes it does seem that way, however I have had teh battery out over night, when I put it back in this morning it DID NOT automatically initiate the boot sequence. But it did after I pressed the power button, so it must have read it to some extent?
Also when the phone is on I can change the volume up and down as per usual, its all a bit strange.
Any other way to initiate a hard reset other than that menu?
Thanks very much!
It seems you are having a hardware issue, try sending your device to the service centre.
So I was using the camera today and accidentally hit the power button. The screen turned off and the camera appeared to stop, but I can not power the device back on. holding the power button did nothing, nor did just pressing it. Normally I'd remove the battery at this point, but as you folks know, this is impossible unless I want to break my device. Anyone know how I can hard reset this thing or will I just have to wait until the battery dies? (Which will take a very very long time.)
I've had some very weird power problems with my Tab to the point where I'm thinking of sending it in for RMA. It sounds similar to your problem.
After leaving it for a period of time "sleeping", I come back and press the power button, and the display does not turn on.
Over a 5-minute period of fiddling with holding different combinations of the 3 buttons at the top, I got it to hard power off. It does take quite a while to hold them, longer than I would have expected!
My went to RMA. I asked for a refund.
Cyvillian said:
I've had some very weird power problems with my Tab to the point where I'm thinking of sending it in for RMA. It sounds similar to your problem.
After leaving it for a period of time "sleeping", I come back and press the power button, and the display does not turn on.
Over a 5-minute period of fiddling with holding different combinations of the 3 buttons at the top, I got it to hard power off. It does take quite a while to hold them, longer than I would have expected!
Click to expand...
Click to collapse
I think all you have to do is hold the power button for a very long time, like 10 seconds. My friend and I both had the problem where it wouldn't turn on after a while asleep and this is how we forced it to reboot.
THANK YOU!!!!...looked everywhere for this. So, holding the power button for 10 sec works.
If you're here at XDA, it means you flashed a ROM or two (or 10... 20... 1434240 )
If you've flashed any ROM, you probably encountered SOD's before.
You probably took out your battery and put it back in, in order to restart the phone.
But, recently I found out that you could just press and hold
Power Button + Volume Up Button
to restart the phone! (hard coded reset )
So as the title said, it won't prevent any SOD, but will sure make them feel less painful!!
hi,
i usally just press my power button for a few seconds and it reboots as well - i dont know if there is any difference if you press volume up as well.
best regards, dv
Correct procedure is: Home button + power button.
No, dervaganund is right. You can just hold your power button for a couple of seconds to shut down your phone, or hold it longer for about 8 seconds to reboot your phone. No need for volume or home buttons