Is there a way to do a hard reset when the screen freezes upon start up? The rom installed fine but when I went to change the theme it froze. I tried to do a soft reset but that is when began to freeze.
waltzag said:
Is there a way to do a hard reset when the screen freezes upon start up? The rom installed fine but when I went to change the theme it froze. I tried to do a soft reset but that is when began to freeze.
Click to expand...
Click to collapse
You need to either hard reset or reflash DCD. How many programs did you install before this theme. Could be a bad file or another program you installed. Your phone isn't bricked, it's just stuck.
These are bricks.
Can you tell me how to do a hard reset? The only hard resets I've done are through the settings but I cannot get there. I have heard before that you can push a bush of hard bottuns all at once to do a hard reset. Is this right? Also, how do you do a reflash?
waltzag said:
Can you tell me how to do a hard reset? The only hard resets I've done are through the settings but I cannot get there. I have heard before that you can push a bush of hard bottuns all at once to do a hard reset. Is this right? Also, how do you do a reflash?
Click to expand...
Click to collapse
Hold both softkeys (next to red and green phone buttons, not windows or ok buttons) while pressing the reset button with your stylus. You will lose all your data and the phone will be reset to original default settings.
I won't explain flashing, read the Titan wiki in my signature.
Related
My XDA cannot be power on after i pressed the wrong switch (soft reset Switch) after updating the ROM with SDcard method.
I cannot enter the wallaby mode, do the soft reset and hard reset.
But it still can be charge.
Can anyone help please please please please.???????
If it will make you feel any better, you didn't press the wrong button.
So something else must have went wrong!
BTW what ROM did you upgrade to?
Oh yea!
You did remove the SD card after you did the upgrade, Right!
Re: Help, I pressed the soft reset button after updating the
KENDU said:
My XDA cannot be power on
Click to expand...
Click to collapse
Got it in this state just once. Have you tried removing the SIM, then hard-reset - then Wallaby. I think there is a major boot delay without the SIM present - it was a while ago that I had this problem - but I did get back from it!
Thanks for the replies Guys.
But I tried to make s hard reset with or without then SIM Card it also doesn't help.
It still can be charge but it won't switch on or go to bootloader mode.
Is there any key combination to get into bootloader mode or to do hard reset?
What is cold boot?
Cold Boot and Hard reset are the same thing.
I want to selectively install the extended rom, but I cannot seem to hard reset the device using power and reset hole. I can see the extended rom using total commander, but when I click to install one the program just installs forever. Any ideas?
Hard reset is the two soft keys while pressing the reset hole.
I used the "Stop" sign
It said it would return the device to faxtory settings. and did.thanks
Hi,
I am puzzled by the fact that I cannot hard reset my device at all via the hardware buttons. I can hard reset via clear storage, but cannot hard reset by holding explorer and gps button + soft reset button. This just doesn't work for me. The device does nothing. Any suggestions?
Thanks for your help.
fried_potatoes said:
Hi,
I am puzzled by the fact that I cannot hard reset my device at all via the hardware buttons. I can hard reset via clear storage, but cannot hard reset by holding explorer and gps button + soft reset button. This just doesn't work for me. The device does nothing. Any suggestions?
Thanks for your help.
Click to expand...
Click to collapse
Strange, with my device it´s the other way around. Can HR via buttons but not via clear storage. If someone has an solution for one or even better the both of us....don´t hesitate.
Hold the stylus pressed in that hole.
Press the two magic buttons.
Remove the stylus but keep the buttons pressed until you see the "welcome screen".
OK now?
Figured it out
Bloody HTC...trinity can HR with device off. Was use to that. With Polaris, it is required to have device on!
So Thanks Dimitri,
You order is correct. Just that the device must be turned on and booted into WM6 OS.
With regards to Clear Storage. Not sure how I can help. Could it be your ROM? I've only Clear Storaged with two ROMS. Bepe and the original manufacturer's ROM (Taiwainese Version). Had to reflash to Bepe to get English. Maybe try a different ROM?
I had some problems with my Touch Dual which forced me to reset it by means of the reset button. Now finally it seems that I've destroyed the button
Since I need Hard Reset (system is locked and I cannot enter the requested "a1b2c3" sequence) just removing the battery is not sufficient.
I there an alternative way to force a Hard Reset?
I think...
Start > Settings > System > Clear Storage
...is the same as a hard reset, other alternative is to reinstall a rom...
Reflash a ROM if you have one.
I also wouldn't be surprised to find there is an mtty command that does it too - check the wiki.
Is there an SSPL for the Niki that would allow people to run mtty commands? not sure but worth checking into...
Found out that with SKTool one can perform a hard rest, too. Works perfect and finally solves my reset button problem
BTW: HTC rejected to fix the button problem, very very very poor service ...
do they have a reset button, cos mine doesn't. i usually have to take the battery out.
which reset button, if you mean the little one in the back you can hard reset by holding red and green buttons when you switch on
I am a noob for appdayting roms and this stufs, I yust instald new xtrom grid evo 19c rom on my hd, and iz says that i need to hard reset device afther flashing rom, how can I do that? I only know for soft reset....
I hope this is not wery stupid question
axxo69 said:
I am a noob for appdayting roms and this stufs, I yust instald new xtrom grid evo 19c rom on my hd, and iz says that i need to hard reset device afther flashing rom, how can I do that? I only know for soft reset....
I hope this is not wery stupid question
Click to expand...
Click to collapse
Go ahead and soft reset your device however this time when doing so hold the volume up and down together and then following instructions.
Hope this helped...
Couple methods of hard resetting:
Turn off device
Hold the volume down & volume up button while you press the power on button.
You should be presented with white screen and text. Press vol up to restore factory settings (i.e. hard reset)
Alternatively,
Go to Start > settings > system > clear storage (may be called 'wipe device' on some roms)
Generally once I flash a rom, before it automatically configures device I remove battery and do a hard reset