I have a problem with my SPV C500. When the battery runs down to 50% I'm not able to charge it by wall charger. It starts to charge but after a while the led goes green and battery indicator says the phone is full charged. When I plug the charger out, the battery indicator will tell the thruth - it's not been charged. Even letting the phone with wall charger plugged in for several hours doesn't help. The only way is to use USB connector and connect it to PC. In this case the "point of no return" is around 20% (I did a test with spare battery). Did you experience such a problem?
I've also had second SPV C500 which stopped to charge at all. Even USB charging didn't help. I had to sell it as faulty :-(
BTW 6.1 ROM seems to save battery life. With WM 2003 SE it took one day to drop to 50%, now it takes more than two days. .-)
Related
Yesterday my cingular 8125 phone decided not to charge the battery anymore,
I wanted to make a call and it was srangely turned off ( it was at 50% ten min. before)
so I turned my phone on and the battery meter jumped from 48% to 0% and now it wont charge at all!
plugged in it works fine with PC and charger.
Plus the battery info screen olny shows the battery meter for the main battery (0%) and not the backup battery, as if it didn´t exist! (2.17 ROM)
I wish someone could tell me if I will solve the problem with just buying a new battery or If I should sent it for repairs.
Already did a hard reset, no drops, moisture, dents, extreme temp. etc. -- and I have a Delta Electronics charger, dunno if it is the original one, it is not cingular branded. :?:
all thoughts welcome.
thanks!
Errol
You need to try the standard charger because it has an output of 1Amps and any less does not seem to kick start the battery into charging. Check your charger and see if it has an output of 1A or not (usb charger has lower output only 400mA) and if not get one or borrow one and try. Most microsoft smartphone chargers use 1A too.
Hello,
I bought a second hand Qtek 2020. The seller didn't have a cradle, but he gave me a USB sync/charge cable and a AC plug with USB slot. So I insert the one end of the cable to the PDA, one end to the plug and I recharge.
The device came with 90% charge and I could easily charge it to 100%. Today, I ran it down to 0% and now I can't recharge it!! Every time I turn the device off and plug everything in, it starts to recharge. The led on top shows red. It charges for about a minute and the device wakes up. The red light turns yellow. It says on the screen that the device is still charging but the meter is stuck at 0%!!!
I've been trying for hours but I can't even get to 1%. Maybe it would be better if I had a cradle but that's not an option now. Besides, it recharged beatifully yesterday.
I have a feeling that if I can stop the device from waking up automatically when charging, I can recharge fully, but I don't know how.
Any help will be very appreciated.
Update
Here's a quick update. It's gone from bad to worse. Now I only have a blinking red light and the device doesn't come on at all!!
Any advice please?
Have you made sure that the plug is connected tightly to the PPC? If the charge isn't being held, then the battery might be the culprit.
li-ion batts have a limited number of times it can be recharged before it's lifespan is over
maybe your batt's time is up ?
Follow-up
OK. I bought a new battery and everything works fine now. So if you're having a similar situation, a new battery may solve your problem too.
same problem
I had the same problem as you. When the battery was on 30% to 90% it could be easily charged via USB from PC or via usb adapter. Once the battery fall under appr. 20% I was unable to charge it. I wanted to throw to the garbage. I have done many upgrades many resets. While the qtek was without any software (nothing was installed on it) tha battery successfully charged. So used the qtek as ussual and tried to charge it before 20%. BUt now it fall again under 20% and it's happening the same, I can't charge it. The other strange think is, that I have tried 5 computers with USB.1 and USB.2 but is didn't help. Only one computer can charget from 0% to 100% and this one is in my work.. very strange and don't know what couse this... Normaly the battery holds power for two and half days, so don't wan't to buy new one now. If anyone has any explanation why it can be charge only with "one computer" or what can that couse, I really appreciate it.
Thank you
the first battery charge on the HD is supposed to be a 8 or 10 or 12 hour charge? or on its not necesary
also the time used to charge it to the pc via usb cable is same as if ud plug it in the electric socket?
how long dose it take for u to charge ur phone.....
mine had 4 lines out of 10 and after 3 hours of it beeing conected to my pc and not in use its still got 4 lines....
opinions seem to vary on how long for 1st charge - personally I left mine on (mains) overnight, but that's just because I've had mobiles since year dot, and you used to have to!
But charging via PC doesn't seem to work as well as from the mains charger - depends a lot on the PC and how much juice it kicks out, some are a lot better than others.
Modern phones/batteries do not need "overnight" charging. My Touch HD even came with a little note saying you don't need to charge for 16hrs/overnight. Just charge until it's full...
Better to charge with wall socket because not all USB ports provide enough current. Some can't charge through the USB port while some can.
I can charge through my notebook but it takes a lot longer than the wall socket.
thanks bouth of u for the fast anwsers....
When I set WiFi settings to max performance, my HTC HD will not charge at all, actually it will loose charge during night, display is off, just WiFi, GSM and GPS is active, connected to provided wall charger. Back side of phone is really hot, I measured over 54°C
Problems charging.
guys(and lady's) Just got my HD. been running it for some time to drain the battery, while on my laptop the battery starts charging. I wanted to drain the battery to give it a good charge afterwords so I turnd off the option of charging while unit is active( in batt. menu) but When I got to 5% batt.cap. an tried to charge the unit (batt. option enabled again) it doesn't charge. now my batt. is empty and can't get in the phone. while on power my battery charging led gives a couple of seconds of charge indication then it turns off.
Any suggestions or is my battery dead. (charging unit is oke, and when on power the HD does give sufficient power to the battery (measured with mulitmeter) thx guys edit - Als when on power green and amber lights blink.
Could that be that your battery is too hot ? There is some safety protection that prevent the batyery to charge when it is over a temperature level.
battery not charging properly
My touch hd not charge the battery more then 50% i change the battery but same as before.
any suggestion
Regards
funstuffalex said:
also the time used to charge it to the pc via usb cable is same as if id plug it in the electric socket?
Click to expand...
Click to collapse
Power socket gives about 1amp - USB 500mA (.5 amp)
Touch HD Battery Charging Problem
The rom i am using is Energy 3 Rom
and try to use both sources wall socket and pc usb both are same.
if i charge the battery on usb cradle and put the phone it shoes 100% but after some use of the phone the charging start again and never show's full even left it over night.
Best regards
Not sure what's going on there,but try draining the battery to almost empty each time and then turn your phone off before charging it. Do this a few times and see if it helps. Mine took about a month beforeit came good.
Dear samlives
Thanks for helping
I will try it
Best Regards
HTC Touch Battery Charging Problem
I got a solution its not 100% but for time being its working for me.
Long press the power button and put the device in sleep mode.
All Done now charging 80 to 90% quite better then before.
Thanks a lot
Hi everyone!
I have just recently acquired an old imate k-jam that was not working
I managed to resurrect it for a wile by connecting 5v to the battery for a minute and then it was working for bout half a day and ten it just stopped working.
Now i need to use a 9v batter to get it to start and after 2mins it will just stop and the battery will be at 0v again.
Now do you guys think this is my battery being stuffed or is it the phone?
Stupid Question:
Is this the only way you're charging the battery? =-O
The connection wires to the battery is an "emergency jump start only" procedure. It's only used because the Wizard won't charge unless it can first boot.
You should connect your Wizard to a charging source as soon as (or before) it boots.
The AC wall charger is the best. Lacking that, use a USB cable that fits or a car charger, if you have one. The USB / car charger methods will take many hours longer. Also, avoid using the Wizard while it's charging. Just let it charge until the LED goes from orange to green. THEN if you get just a couple of minutes, it's new battery time.
If the Wizard boots, it's very unlikely that it's the Wizard/k-jam.
My Brother-in-law gave me his "old" Cingular 8125 when he "upgraded his phone", he said it was "too heavy and clunky and hard to use". Battery was deader than the proverbial doornail. After the "jump start", it took a full 8 hours of charging via the car charger and computer USB cable to get it to green. (He left the wall charger in South America somewhere.) The battery has been working fine for the last 8 months.
Hi! I have a HTC P4350 with a big problem. He don't want to charge the battery. Actually when i plug in the charger he say that it's charging until the green light apears. Let's say that i've plug in the charger at 51%; the phone it's charging until 100% but when i'll disconnect it the battery will decrease again percent by percent and in five minutes or something the level will be again 51%. I have an external charger which it's charging corectly my battery but it's annoying to change the battery to the charger, and when it's full back to the phone over and over again.
So, the battery it's fine, i can connect the phone to the PC and i can sync it so the USB it's fine...
One more thing: the phone was started to do that 2 years ago. I bought that external charger and i used it for 6 months after I've don't use it(the phone) until 2 days ago. So, i've put it in charger and it worked at the first push of the button. I've left it in charger by the night but in the morning i've got an RLOD. So i've use the old external charger and the phone works, only with this problem... he won't charge.
Any ideas? Thanks and sorry for my English