Related
For some reason my device has suddenly started switching to the minimum backlight setting whenever it's switched on. If I go to the backlight settings and then adjust the slider it will stay at the selected brightness until it switches off. When it switches back on again it's at minimum brightness and I can hardly see the screen!
This started happening after I installed and then removed PocketZenPhone.
I don't really want to hard-reset the device unless I absolutely have to - does anyone know what registry key sets the default switch-on brightness?
Thanks,
I dont have the solution but I have had the same problem intermittently. Can be really aggravating in the dark because it can be hard to get to the proper screen to increase the backlight. Hasnt happened in a while. Have not been able to figure out what triggers it. Have not installed PocketZenPHone. Curious if anyone has an explanation.
yah, i've noticed this to, sometimes i'll hit the power button to take it off standby and the backlight would be off. first couple of times it scared the hell out of me cuz i thought the screen had broke or burnt out.
also i noticed the version of spb pocket plus i'm using (3.04 build 4195) doesnt adjust the backlight brightness.
Now that you mention it. the SPB Pocket plus backlight does not work for me either. Strange...
Well I think I've managed to "fix" this by setting the following;
Backlight Settings:
On battery power, turn off backlight if device is not used for [5 min]
Turn on backlight when a button is pressed or the screen is tapped
Power Settings
On battery power: Turn off device if not used for [3 minutes]
I think the key thing here is to have the device auto-switch-off BEFORE the backlight timer kicks in. Since setting the above three settings I have not had the same problem again.
Ill give it a try as well.
Hmm...maybe someone can help me. One day, my backlight timer settings when the PDA's not plugged in reset to 10 seconds (in the registry it has it as 7 seconds). I'll go in and change it to 2 minutes (the original setting I had it at), but the minute I turn it off, it resets back again to the 10 seconds setting. I even tried going into the registry and changing it, and it resets it back to 10 seconds. I suspect it may have something to do with an entry in the "scheduled tasks" but it looks like a complete mess. Is there some kind of scheduled tasks cleanup utility?
Thanks,
Q
hello i have the same problem using phothet with WM6
Thanks
Nicolas
I had the same problem often about 15 months ago - it happened often each day.
I posted herw but had no joy with a solution - but then found one on Modoco (i was looking about March/April 2006).
Even with that - it has still done if perhaps five or six times since - and basically makes the phone unusuable if it happens somewhere or time with poor light.
My KJam backlight keeps changing by itself to dark
Suddenly my KJam backlight always turns to low without me doing so, then I have to change it to high, barely can see what I’m doing as it is almost black. This is kept happening especially after I installed Pocketweather. I reinstalled the Rom, it worked fine then suddenly it is back again when I switch the screen off, or automatically it is switched off, the backlight slider I find it at the lowest end.
Why thus is happening, it’s driving me crazy, please help me
Today I had an alarm set, when the alarm went off I tapped hit the power button on the top of my phone to turn the screen off (and hopefully the alarm... but only the screen went off). The alarm continued to go, but no matter what I did, I couldn't get the screen to come back on.
I can fully interact with the phone (as if the screen was on). For example, pressing talk twice redailed my last call. Pressing power prompted to shut the phone off (could hear the "blurp"), etc.
So, after shutting the phone off (or resetting with pinhole reset), the display works fine while it is displaying the "Cingular - Raising the Bar" nonsense. As soon as that screen is done (where it would have normally showed the today screen), the screen just goes off...
Any ideas?
-Shaun
nevermind, when I put it under a bright light I realized the screen was on, the backlight was just off... somehow I must have hit some shortcut to turn the backlight off.
-Shaun
PEBKAC
Don't sound too relieved...
Say hello to the Backlight bug.
You're backlight will keep setting itself to the lowest setting after every soft-reset, when you let it go into stand-by itself.
I'm still sufferering from it. It started when i first installed PocketZenphone.
So just want to give u a warning. Everytime you reset your phone, remember not to let it go into standby itself. Either tap the power button and turn the screen off, then turn it on agan. Otherwise, the Backlight will go to low again.
Hi,
weird thing here: Always when I awake the device after suspend, the backlight is off. I have PZP installed, but it's configured to do nothing to backlight or power, settings in backlight/power are to never switch off backlight, but suspend after 2 minutes.
Any ideas where else I could check?
after mr.clean update, my backlight auto set itself to turn off after 10sec no matter what i do
I tried to set the back light to never turn off, but it still will not work
all i have running on background is spb pocket plus
CAN ANY HELP?????
hm, also mr. clean here.. coincidence?
My out of the box MDA Vario did this too. I finally figured out that it only did it if I changed the brightness level from the default to max. If I left it at the default, it worked fine on resume...
before the mr. clean rom I had a standard vodafone one, and didn't have the problem. What is default level (steps from topmost) for testing?
TauTau said:
hm, also mr. clean here.. coincidence?
Click to expand...
Click to collapse
ok, i THINK i solved it now
it is caused by a software called vito audio note
http://www.pocketgear.com/software_detail.asp?id=21235&associateid=17
which will uses its power saving mode to turn off Wizard
I had the same problem. Rebooting the device didn't fix it. But when I actually SOFT-resetted the device, it came all back to normal.
Backlight off on resume, not hardware
Hello everyone,
I've got a very frustrating problem. Here's the summary:
My backlight doesn't come on when I resume from standby. However, when I soft-boot the backlight behaves as normal. After boot, if I continue pressing keys to prevent the backlight from turning off, then it operates as normal. However, if the backlight times-out, or if I put it in standby, the backlight refuses to come back on.
Any suggestions?
I bit the bullet
Well, i finally decided I couldn't live with the dark screen anymore and Hard Reset my 8125. It fixed the problem, but now I have to reload everything.
Oh well, now will be a good time to upgrade my ROM I guess...
ok well during the day and everything its fine but now as I type this message and when I'm generally in landscape mode using the keyboard my hermes backlight has a life of its own it turns on and off randomly...
no its not power saving, I'm sim unlocked but I now run the 1.09 bootloader and latest HTC rom and I'm getting to wits end. sometimes it can be fine other times not.
some may think what is he on about but it is happening to me and I don't even think its a hardware fault either or at least I hope not as most of the time my backligt behaves! anhone got any bright ideas as to what could be causing the flicking?
I have had a problem where the keyboard, when slid out, does not light up. Is this what you mean?
If so, I went into the control panel, switched it off in the settings and then closed it all down. I then went back and enabled it, and did a soft reset when it had all calmed down. No problems since
HTH
I get a similar problem, when I have read a message and switch to landscape mode and start typing, the backlight turns off and as i continue to type it will switch itself back on.
its a pain in the arse and is one of the bugs im hoping to get rid of on a rom update.
Imp
The keyboard has a light sensor. It will only light up in dark conditions. Maybe yours is playing up, or the light conditions that your using your phone in may be the cause.
I turn my sensor off so the backlight is always on, Settings---->Buttons----->Backlight
S.K.
Its the screen backlight that goes off, not the keyboard lights.
Imp
Guys its one thing after another!
This thing is in urgent need of a Rom Update!
The back light doesnt turn off after the specified time! Not completely anyway.
What happens is that it just dims out to a very low backlight and still stays on!
The same thing happens even when its connected to activesync on the pc!
Anyone else experience this?
Thanks in advance for any help anybody can provide.
Dead Cell.
I think that is normal behavior. If you need your backlight off while the device is still running, I think there are 3rd party apps that can take care of that. The only time I want that option is when listening to music, and TCPMP can map a button to toggle the screen off.
If your phone is connewcted to PC then it's powered and stays on low light setting when not used. But if you disconnect it from power/pc, after a specified time, the screen turns off. At least on mine. However, when listening to music the screen never turns off.
mihaig said:
If your phone is connewcted to PC then it's powered and stays on low light setting when not used. But if you disconnect it from power/pc, after a specified time, the screen turns off. At least on mine. However, when listening to music the screen never turns off.
Click to expand...
Click to collapse
My Prophet backlight used to go completely off while the device could actually be on, pressing the D-pad could bring the screen backlight on again. It was still possible to see that the screen was on by holding it up to a bright light.
When unplugged from the power supply, my observation has been that the Trinity back-light doesn't go completely off, it changes from normal brightness to very very dim, but not off. It goes completely off when the device goes into standby.
I use Mortplayer for listening to music, which has a feature that turns the screen off, not just the back-light, which saves a lot of battery power.
mihaig said:
If your phone is connewcted to PC then it's powered and stays on low light setting when not used. But if you disconnect it from power/pc, after a specified time, the screen turns off. At least on mine. However, when listening to music the screen never turns off.
Click to expand...
Click to collapse
Not neccessarily... It has a setting on the Battery option where you can select the amount of time after which the back light goes off both on battery power and external power.
Anyway mine stays on even when its not connected to the PC ie, external power.
It just goes dim after the specified amount of time and stays like that untill the device goes off.
Thanks.
When you say 'goes off' do you mean 'enters standby'? When not connected my p3600 dims the backlight after 30 seconds. Two minutes later it enters standby (that's the time I set it up from settings). However it only enters standby if I don't listen to music.
Hi,
I noticed the same proble, I never the used the original Rom coming with the Trinity cos I bought it last Sat and I installed the DOPOD test rom with GPS support straight away.
With my TYTN when I'm on a call after a while (a minute) the screen togles, however with the TRINITY the screen stays on (brightness goes away) but still there (no togle).
Can somebody with a non-gps dopod rom confirm that they do not suffer this behaviour?
thanks,
Elsral
My Trinity is still original (Dutch). When in the backlight settings, I slide the indicator all the way to the left, the backlight still is on (very low, but it is still on).
A colleague of mine has a Hermes; when he does the same thing, his backlight is off completely.
Also, before the P3600, I owned an Ipaq 5550 which also was able to switch backlight off completely.
Hope this is corrected in a future ROM update...
elsral said:
Hi,
I noticed the same proble, I never the used the original Rom coming with the Trinity cos I bought it last Sat and I installed the DOPOD test rom with GPS support straight away.
With my TYTN when I'm on a call after a while (a minute) the screen togles, however with the TRINITY the screen stays on (brightness goes away) but still there (no togle).
Can somebody with a non-gps dopod rom confirm that they do not suffer this behaviour?
thanks,
Elsral
Click to expand...
Click to collapse
German Trinity Original ROM here. The device switches the screen completely off after the amount of time I have selected. It is the same behaviour that I know from my other pocket computers and it seems completely ok. Something wrong with the Dopod ROM?