Database Users

can't access to bootloader

hello
i tried to update my tytn with the new schap's rom but my vista crashed
now i can't enter in bootloader
I push buton on/off+ok+reset with stylus and nothing happened
I just have this screen
please help me please
ty

Are you holding the OK button on the left side of the device (under the Jogwheel)?
Entering the bootloader with the OK button on the front is not working.
Please note that you have to hold the 2 buttons until the device resetted.

My bootloader is back!!!
I didn't use "ok" but I used "windows touch" and I entered in bootloader
I'm so happy
ty JR_de for your help

grrr
I succeeded to enter in bootloader mode one times
now I can't again
I remove the battery and i will try later :'(

That ok!! I can enter in bootloader but I can't flash

YES!!!
it's ok!! i can flash my hermes again
thx a lot

diamond 2 unresponsive

i installed the Ezinput from http://forum.xda-developers.com/showthread.php?t=536215 for wvga... i installed it, then it said a reset is required to finish intallation. after the reset, it went to the touch diamond 2 boot up screen, after that was over, then screen displayed nothing. its black, and usb does not respond when i connect it to the computer. any ideas? i already tried the reset using teh red button. took out the memory card, where i install the .cab, still doesnt work. any help would be greatly appreciated.

If it's totally unresponsive from boot, hard reset it. Hold Volume Down and press the "red button" to reset it. It'll go back to factory settings.

same problem here, help needed!!
i tried to restore it to the factory setting using volume down and red button but when the phone flashes it shows me this three color screen with the message "serial" on the bottom side of the screen, any ideas on what should i do???
thanks in advance...

To perform a Diamond 2 hard reset
1. With the device turned off, press and hold the VOLUME UP and VOLUME DOWN buttons, then briefly press the POWER button.
2. Continue pressing the VOLUME UP and VOLUME DOWN buttons until you see a message on the screen.

alwaysrun said:
i tried to restore it to the factory setting using volume down and red button but when the phone flashes it shows me this three color screen with the message "serial" on the bottom side of the screen, any ideas on what should i do???
thanks in advance...
Click to expand...
Click to collapse
What you did is boot in "bootloader mode"; in that mode you can try to flash again the original ROM.

thanks
thanks a lot guys, your help is well appreciated, i finally managed to flash the phone bios and now trying to install the original rom, thank you again

help. Palm pro can not boot to Winmobile

I have a palm pro can not boot to windowmobile. This phone does NOT BOOT UP past the windows mobile start up screen. Now, I don't known how can FIX it. please help me.!!

eo116 said:
I have a palm pro can not boot to windowmobile. This phone does NOT BOOT UP past the windows mobile start up screen. Now, I don't known how can FIX it. please help me.!!
Click to expand...
Click to collapse
did you flash another ROM?

looks like its time for a hard reset. hold down the red button and press the reset button with the stylus without letting go of the red button. press up and it will reset the phone. remember, backups take space, but save you later =]

trickbiker121 said:
did you flash another ROM?
Click to expand...
Click to collapse
yes.! I flash new ROM.! Now, how can i do?? Can repair or not???

eo116 said:
yes.! I flash new ROM.! Now, how can i do?? Can repair or not???
Click to expand...
Click to collapse
hopefully you did Hard SPL before Flashing if so you can relax your phone isn't bricked. to get it working again go to the tri colored screen by holding power and side camera button and while holding that tap the reset button on back. when you get to the tri color screen plug your phone to the computer and flash a different ROM that has been tested to work then your good to go hope this helps

Magic stuck in boot loop! HELP!!

I have a rooted Rogers magic and dont know what happend...but its stuck in a boot loop. All it gets to is the "HTC MAGIC" screen and then the out of box image shows up and then it restarts and does this again and again.
I cant enter recovery or fastboot. ive tried the diff key combinations to boot but nothin works.
ANy help!!???

If you can't get into a recovery, or fastboot from my understandings you now have a very expensive paper weight.

Mine did the same, randomly or because i pressed some combination the phone booted again. Sometimes pressing backspace i enter the menu, pressing home+power... nothing.
One or two times pressing home+power enters the menu and then reboots by itself.
Any ideas?

It's happened to me once.
Does anything come up with your computer?
Can you access adb?
Try removing the battery then hold down the menu button.
While still holding menu put the battery back in.
The phone should start up. Keep holding the menu button until you are blue in the face (or for about 30 seconds or so) or until the phone boots.
If that doesn't work try the back button instead of the menu button like above.
If THAT doesn't work... then find a stack of papers and place them in front of a fan. Place your phone onto the stack of papers and let it sit...
Or try calling your provider because you might still be under warranty.

ok guys it on now.
Its working but for some reason it wont read my sd card :S
turns out my bro flashed a recovery he shouldnt hav so it kept rebootin evenwhen i tried entering recovery. i erased it thinkin that ill flash a new recovery...but it wont recognize my sd card. ive tried 3 diff cards...but nothin works.
even in the rom, i get the notification: "SD Card has been removed. Insert a new SD card to increase your device storage."
i cant get the card to work HELP??
........how do i even flash anything without the card?

You can flash through fastboot
Sent from my Epic myTouch 3G using XDA app.

Flash through fastboot like he said and it should read your SD card with a new ROM.

any links to a tutorial on how to flash through fastboot??
thanks in advance!!!

hassan3216 said:
any links to a tutorial on how to flash through fastboot??
thanks in advance!!!
Click to expand...
Click to collapse
Nope. There are no links or tutorials at all anywhere on the web. They do not exist. Except for maybe this one:
http://forum.xda-developers.com/showpost.php?p=4066552&postcount=2
... and about 5,539 more. But yeah... other than those... the answer is no.

The Sapphire Wiki
http://wiki.xda-developers.com/index.php?pagename=HTC_Sapphire_Hacking
Click to expand...
Click to collapse
is also somewhere you should look if you need help rooting.

please help can i recover my magic stuck in box image shows up
without jtag ?
helppppppppppppp

NIRANIK said:
please help can i recover my magic stuck in box image shows up
without jtag ?
helppppppppppppp
Click to expand...
Click to collapse
It you have bootloop - remove battery you turn phone off. Wait a few minutes and place battery back.
Then try flash turn phone on by pressing and holding Back + Power (fastboot-mode)
Write first five rows here (all symbols are important).
It you will have problems, try to load phone into other modes:
Home + Power - recovery-mode
VolumeDown + Power - hboot-mode
Sent from my A7-040 using Tapatalk

no way out
I tried but nothing happend
just a screen with box and yello arrow refers to a mobile
any way thank you sir

NIRANIK said:
I tried but nothing happend
just a screen with box and yello arrow refers to a mobile
any way thank you sir
Click to expand...
Click to collapse
Can you load phone into any mode?
Sent from my NookColor using Tapatalk

first thank you for your time
no I can not enter any mode no fast-boot no recovery -- only the power bottom can be recognized

NIRANIK said:
no I can not enter any mode no fast-boot no recovery -- only the power bottom can be recognized
Click to expand...
Click to collapse
Too bad
It seems like phone flashed by faulty hboot or radio (uncompleted download or something else)
Try disconnect phone from pc or adapter and remove battery for 10-15 minutes
May be it cancels this process.
To restore phone you need to run hboot-mode or fastboot-mode - if you don't then only JTAG can help

ADT-3 - stuck on No Command

Can only get to 'No Command/green Android' screen. No recovery installed and I cannot get one installed.
Are there any toolkits I can use or any suggestions to try to resurrect the device? Never had issues flashing any Android device, but it's been so long since I did, I'm hoping I just missed something.

then you need to hold the only button again(three sec.) ... then you will see menu

ToToHayashi said:
then you need to hold the only button again(three sec.) ... then you will see menu
Click to expand...
Click to collapse
Is that from the No Command screen?

yes