hi,
I have read a number of posts mentioning that programs / settings are saved to non-volatile mem when you remove the battery.
However, when I remove the bat from my m5000 I loose the date & time after about 10sec.
Is this normal?
See my specs.
Via schema from Sk Tools, I have my device soft reset twice a day. Does soft resets shorten the life span of one device ?
Hi,
My display is cracked and now i want to sell the phone, can I reset the phone to factory defaults without the display? thanks?
/Rickard
yes it should still re set. If you're worried about it you can also remove the battery for a few hours untill the internal battery drains and that will re set it to factory defaults too. maybe 48 to 72 hours to be safe but should be faster I think.
when i remove the battery for a minute my bkup battery goes low and smoetimes my pda soft resets
is my bkup battery could be changed if yes how? or what can i do if not
hi
i have a little problem my s200 turns off at 30% battery without warning... always at 30%, tried the battery in other gsm and it worked till 0%..
im on WM5 original, but i upgraded to WM6 and the same problem... now im back on WM5 with same problem again.. tried some battery apps like batti to change the shutdown % but no luck..
help!
papizdono said:
hi
i have a little problem my s200 turns off at 30% battery without warning... always at 30%, tried the battery in other gsm and it worked till 0%..
im on WM5 original, but i upgraded to WM6 and the same problem... now im back on WM5 with same problem again.. tried some battery apps like batti to change the shutdown % but no luck..
help!
Click to expand...
Click to collapse
Same problem with my qtek s200, WM 6.1 Korand WWE 3.1
I used to have the same problem...after getting a new battery, things seem to work fine....I think it's the battery's aging...after using and recharging for many cycles..after a few years...
S200 is 6 months old, and it starterd to do this afer installing WM 6.1..
donno where to set this turnoff level ?
Mine will also turn off @ 30%. But, it only does this when you use the WiFi.
I had problems with charging my M600. It would also turn of, even when being charged, but not at 30%. It would normally charge to 100% and then turn of and only show the red light....
Looking for sollution, I overlooked the fact that the SDCard was still in it. So I took the SDCard out and now my M600 is working again.
I also have the same problem on I-mate JaMn
Try changing or re calibrating the battery.
Taken from the Universal WiKi (should work on the Prophet)
Charge the battery overnight with the supplied poweradapter, not with the USB cable
Drain the battery without SD-card, powersaving off and backlight on full
At some level, the device will turn off. Switch it on and go to the bootloader and drain the battery until it's really empty
Charge the battery again with the supplied poweradapter