Please Masters JEDI, Help Me. Suddenly my XDA I don't show anything, even when I reset or hard reset, it just go to O2 screen then white page blank with a blue bar on top of it. When I bootload it, It says Wally patch ver 5.17, then GSM Error. I have tried to make an SD card boot, but not success, it also can't be downgraded to Ver 5.15 since my XDa stop connecting with my cimputer. plsssss.... helppp......!
1. Did you patch to 5.17?
2. ROM and GSM versions?
3. Did you do anything with GSM module?
4. What do you call "Suddenly"? Wake up in the morning and it doesn't work?
I made my one HardReset automatically when I played with processor speed (206 -> 236). Did you try to do something like that?
See my post on the sx56 RSU update a few weeks ago. I had the same problem.
Chris
email to me
email to me may be i can help you.....
ok i think iv killed my m600
i flashed it with the older imate rom the 1.0.9 version
it installed 100% and rebooted and from ther it was stuck on the imate screen for like 10 minutes and i see the following text in red on the top left corner
---------------------
IPL 2.10.0001
SPL 2.15.0001
GSM 01.14.20
OS 1.0.9.25
-------------------------
i tried removing the battery and restarting the fone. still the same thing. can someone please please please help me with this?
what do i do?
im sure orange wont help me out since i flashed it with a non-orange rom.
never mind fixed itby goin into the bootloader
funky_Saggi said:
never mind fixed itby goin into the bootloader
Click to expand...
Click to collapse
hi there i seem to have the same problem as you with the boot screen. top left corner say's
IPL 2.10.0001
SPL 2.10.0001
GSM 02.07.20
OS 1.0.13.21
can you please tell me how you fixed yours please it would be a great help
What you could do is flash it with an newer rom
Hold camera button AND reset (be asure that it hold it while resetting)
Then... you are in you bootloader... connect the PDA with your PC..it will recognized it!
Then run the romupdate ;-)
Hi thanks for trying to help me i got my phone in to the 3 colour screen but my computer does not pic it up at all. is there another way to save my M600
crossy4life said:
Hi thanks for trying to help me i got my phone in to the 3 colour screen but my computer does not pic it up at all. is there another way to save my M600
Click to expand...
Click to collapse
Aren't you getting "USB" written in the bottom left corner of the 3 colour screen when you connect it to USB?
Yes i get the USB come up at the bottom of the screen my computer does not do anything. can you tell me which ROM i will need as the ones i have to run the ROM update but it comes back saying connect to ActiveSync which i can not do is there a way round this?
Final got my SPV M600 Working with the ROM from the download area thanks for the help anyway
cheers
just change the usb port to another one and start rom it should pick it up
Hi Friends,
My new mobile phone SPV M600 got stuck whil starting showing four lines of messages as shown below.
IPL 2.10.0001
SPL 2.10.0001
GSM 02.07.20
OS 2.10.1.22
Can any one please help me in geting my phone to today's screen.
I also attached the screen shot for reference.
did you try a hard reset ?
Ya I tried both hard as well as soft reset but same screen is stuck again and agian.Can any one please help me in this regard as I am very new to PDA family.
Ok, first things first:
Since you are new to this, are you sure you preformed a hard reset?
It is done by holding power + camera + comm manager buttons (one on the right, two on the left) and pressing with stylus in the reset hole at the same time.
A message should appear asking you to press 'send' (green phone button) to confirm reset.
If this does not help, you may have a serious problem.
Please answer the following:
Is the device fully charged?
Phone will fail to boot if the battery is too low.
Did you install any software right before this happened?
This should have been resolved by hard reset, but just in case I am asking.
Did you change the ROM, attempted CID / SIM unlock?
This could require more serious measures than I can advise on.
I did exactly the same thing which you mentioned.But even then it is stuck at the same screen.
Ya u r right I unlocked my mobile using a software from eBay.The unlock was successfull and I tried to insert T-Mobile sim, it also captured the signal and I was able to make and recieve calls then after that I wantedly switched off the phone and then tried to start it, there got the problem.
Can any one help me in this regard please.
I am having the same problem, but my phone is not sim-locked.
I've got the same problem after attempting smart1_wm6_pp8mb.exe
I'm having the same problem with my G4 QTEK S200:
Attempted to upgrade to WM6 Rom using smart1_wm6_pp8mb.exe
After reboot the phone got stuck at the QTEK Screen
Tried Hard Reset (Camera+Power+Comm+Reset) followed the steps with the same results (bricked)
I also tried re-flashing the rom back to the factory one using RUU_Prophet_220734_2207114_024721_QtekWWE_Ship and ROMUpdateUtility-NoVendorID.exe in Windows Vista with WMDC (Windows Mobile Device Center v. 6.0.6873) and the phone in boot loader mode (tri color screen) with working USB cable, with windows firewall disabled and symantec AV disabled as well, RUU keeps saying error 260 "the update utilitiy cannot connect to your pda phone..." .
Do you think I should try this process using XP instead? No matter what i try i keep getting the error 260
Any help would be greatly appreciated
Got it fixed!
it was definately a Vista issue. once i tried it in XP with ActiveSync it worked like a charm and i got my phone back up and running. also used spb backup and restored all my settings.
ipl/spl screen
i got the same problem with new rom wm6, and the 260 eror, my problem is that i have xp and the activesync does`t connect ...
... means i cant redo the original rom ????
PLEAAASEEE HELPPPP !!
Again My phone SPV M600 got stuck at IPL/SPL screen
Please Can some one advice me how to get my phone back.
I raised the same issue 7 months back after that my phone got recovered automatically and there were no issues till last month. Last month onwards it is again got the same problem and now it is permenantly stuck at that screen what ever you do.
yekanth said:
Please Can some one advice me how to get my phone back.
I raised the same issue 7 months back after that my phone got recovered automatically and there were no issues till last month. Last month onwards it is again got the same problem and now it is permenantly stuck at that screen what ever you do.
Click to expand...
Click to collapse
A rom reinstall on xp solved my problems on that one. retry a couple of times! It may not work the first time! hard reset as well...
Try an official wm5 rom just in case
good luck
Can you please gimme step by step procedure
HI Phil,
I am new to these kind of installations . CAn you please Gimme step by step procedure for ROM installation.
mine is now also stuck, after trying to install new rom. wont connect to active sync either, have i fooked it? tried hard reset etc.
thanks
(with a turned off phone, press and hold camera button then insert USB cable)
then flash provider ROM
RECOVERING FROM ERROR IN STEP 8 WM5->WM6
1. Don't panic
2. Don't panic
3. Unplug the phone
4. Reset with stylus,and keep the Camera Button pressed.
5. A 3 color screen will appear(Bootloader Screen)
6. Connect your device with your PC,and run the NVID(no vendor) WM5 rom.
7. The device will be resetted after RUU(rom update utility)finishes
8. Repeat the WM6 upgrade,from STEP 5..
Click to expand...
Click to collapse
from here http://forum.xda-developers.com/showthread.php?t=310452
hi jay
i seen your post in n00b guys one, i fixed it!!!!, thank you so much, i couldnt remember how to get it to those 3 colours.
thanks again
Colin
Hi Iam unable to get the NVID ROM
Hi,
I am unable to get the NVID ROM. The Rapidshare link that has been provided in the other thread is not working. Can some one tell where can i get the ROM.
collywog19 said:
i seen your post ...
Click to expand...
Click to collapse
no problem mate.
..and yekanth i see what u mean about the dead links. i have the files on my computer at home but i'm posting from my prophet right now, so i can't upload. Try using the "pdaviet temp" from one of the wm6 threads?
(http://rapidshare.com/files/54265407/Prophet_PV_Temp.zip)
Hi Iam able to update the Rom but no use
Hi,
To mention my phone is from orange-UK. I got the orange rom from our FTP site and did the flashing/update what ever you say.But still it is getting stuck at the same IPL/SPL screen. Iam very much worried that I will not get a proper solution for my problem.It will be very grate full if some one resolve my problem.
just seems strange...how did you fix it last time? did it just start working again? A random guess would be that the camera button got liquid spilled on it or is stuck in.
If the camera button is pressed in the phone will go to 3 colour screen every time it is turned on.
It won't do any harm if you try to press/move that button to see if u can "unstick" it, not likely I think but u never know...
Hi,
Il from Belgium. SORRY FOR MY BAD ENGLISH
I have a Qtek S100
R 1.01.00
G 133.38
D 1.03.02 FRE ( French i think )
I tryd to change my Extended Rom from French to Dutch or English... with some file i dont know... im new it this stuff and i F**kt it up!!!
My Qtek just goene black and on the screen u can see USB 1.0.0
After open the baterycover and plug in back the qtek starts BUT after starting install the original app. it goes back to thr BLACK screen and nothing happens.
If I plug in the USB and connect it with my pc, it comes on the screen USB 1.0.0 ....
SO PLA HELP ME PLS!!!
I tryd hard / soft reset, NOTHING!
I look at XDA alredy 4 days everyday 4-6 hours I tryd SO MUCH, I take a day off work, so to can fix it!
IM GOIN CRAZY PEOPLE!!! PLS PLS HELP ME!
Best thing to do is go to bootloader mode and installing a new flash.
Bootloader mode can be found on the forum, but to help you out:
press simultaniously: camera button + power + soft reset (last one with the stylus)
Then start the rom update on your pc (do not use this from vista it wont work (or you have to find the fix online..)
Easiest way is to flash from windows xp works like a charm.
I have the same problem than rocky_gent but I can get the bootloader mode
i'm stack in bootloader mode ! And when i connect the usb cable doesn't display the "USB" but insists with "Serial V1.00".
I want to upgrade my rom from a secure digital (sd) cause i don't have another choice!
I 've been surfing through forums but i only found how to make an sd to upgrade your phone when you have an mda or xda (.nb1 files) . Qtek's roms have .nbf files !!! So i'm looking instructions to make an upgrade sd card with .nbf files (Qtek , Htc Magician) and not .nb1 (Xda)!!
http://forum.xda-developers.com/attachment.php?attachmentid=24569&d=1127232848
?
where can i get new flash? and yes im with vista, why it wount work???
hallow evryone...i am just a fresh user of WM and i got a i-mate k-jam g3 from ma elder bro... and i tried to upgrade it with WM6.5
but the stupidity that i did was.... i installed a charmer version in the wizard and now its stuck in the logo screen. :S
this is the rom that i installed:
http://forum.xda-developers.com/archive/index.php/t-502194.html
please guyz..help me out...
now that i cant run my wizard i cant connect with windows mobile device center and cant install new rom...
what should i do now??? how can i go back to my old WM5 ???
m really worried about the wizard...i was so happy to have that and now i messed evrything up...
please assist me how can i recover from this problem.....
thankuuuuuuu
try this
sunxray said:
hallow evryone...i am just a fresh user of WM and i got a i-mate k-jam g3 from ma elder bro... and i tried to upgrade it with WM6.5
but the stupidity that i did was.... i installed a charmer version in the wizard and now its stuck in the logo screen. :S
this is the rom that i installed:
http://forum.xda-developers.com/archive/index.php/t-502194.html
please guyz..help me out...
now that i cant run my wizard i cant connect with windows mobile device center and cant install new rom...
what should i do now??? how can i go back to my old WM5 ???
m really worried about the wizard...i was so happy to have that and now i messed evrything up...
please assist me how can i recover from this problem.....
thankuuuuuuu
Click to expand...
Click to collapse
can u see the bootlload mode??
is a coloured screen (varoius colors in horizontal bars)
if is possible then, flash again, with a wizard ROM now...
i hope you can fix it........
bro... its not the 4coloured screen...
its the screen written "IMATE" and its only blue...
and to flash with a new rom i need to sync my wizard with the PC... but my wizard is stuck in the one color (blue with the imate logo) screen...
To sync with your pc you must be at bootloader (tricolor) screen.
I took the following from the Wizard Wiki.
''To go to the 3 coloured bars , just press and hold the power button (top) + voicedial button(right top) keep it pressed and hit the soft reset hole (keep the other 2 buttons pressed until the 3 coloured bars come up)''.-