Whenever (or almost ever) I take a photo it stays upside down, and phone rotates the screen orientation to the sides, but almost never comes back to the "original vertical position"... I already tried hard reset, and ran the stock with Odin again, nothing seems to work. The smartphone has never fallen or anything like it, I am having this problem for a while now (several months).
Can somebody help me?
Related
My father's Hermes has a problem, maybe you guys can help: Now for the second time the screen just began to flicker, as if the picture was interlaced, and the colours are off (see attached picture). The second time it happened while the camera software was running, but without obvious reason.
The first time it happened a hardreset (but only that) helped, now the second time even a hardreset doesn't help. Interestingly the screen was ok for a moment after the device was switched off over the night, but after 2-3 seconds the screen began flickering again and it didn't stop yet. Any ideas what this might be?
Ok, I found this out: It seems to be a hardware problem, because when I open or close the device with a hard push then sometimes the screen gets ok again, and other times when I open/close it it starts flickering again. So I should open the device and take a closer look at the connections between keyboard- and display-part of the device (or, regarding my repairing skills, maybe rather take it to the repair center...).
hello XDA community,
I have here an imate Jasjar which after a screen upgrade is displaying the image reversed. It did not begin like this,
Upon first booting up the device after screen upgrade, all was fine, screen displayed normally. About a week after this, the screen began flickering, not on/off, but instead, reversing the image shown on the screen. (a mirror) effect. I did not know what to make of this. I delt with it best I could.
A day or two after this flickering began, the screen began to remain in this reversed image mode, which I did not enjoy. The same day, I had dropped the JJ into a tub ( a pretty hard fall), but somehow, by the grace of god, the water failed to enter the inside of the Jasjar.
After the fall, I had noticed that the screen had stopped its flickring antics and remained normal for about a week and a half. It is now displaying a reversed image only.
I now am unsure of what to do, I searched throughout the XDA forums and discovered that performing a hard reset should repair this.
I suppose my main question is, is there a registry tweak I can perform to revert the displayed image back to its original state
Many thanks to all who respond.
John
EdmundsProductions
DeserteDNJ.com
I have a Sprint Touch [Vogue]. It has served me very well up until recently.
One day, I was using my phone normally when the battery died. No big deal right?
Well, I charge my phone and reboot it. For some reason, Windows is EXTREMELY slow and unresponsive. I figure that something vital had been corrupted by the battery's death, and that it was nothing that a hard reset couldn't fix.
I performed a hard reset.
I let the utilities for the first boot run to customize the phone. Everything seemed pretty much normal. I configured my settings, re-added my contacts, etc. Then I turned the screen off [with the power button].
I turn it back on later to do something. I touch the screen. It immediately and accurately detects the touch's location, but it continues detecting a touch. For 20-30 seconds, after the input has stopped.
It was strange, so I soft reset the device. It booted, with the same problem. So I performed another hard reset. I did some configuration [the response acting normal at this point], and then turned the screen off. Turning it back on brought the same problem back.
This problem still exists on my phone, even after numerous hard resets and even ROM flashes.
A better description of the problem: When the device is first turned back on [meaning brought out of standby], its touch response is messed up. It will immediately and accurately detect any touch input, but it will continue to detect the input for up to 30 seconds AFTER it has been released, as if you were holding it the whole time.
WHY is this???? My phone is almost unusable because of this!!!! I can still place/ receive calls, using the navigation buttons and the red and green buttons. But the touch response is screwed!
Can someone please shed some light on this problem I'm having?
Phone specs: Windows Mobile 6.1, HTC / Sprint customized. Minimal third party software is currently installed.
[I've already determined that third party software is not the problem, because i haven't installed any!]
Possible solution
Hi,
today I experienced something similar to your description - no touch response when I tried to pickup a call. The strange thing is that last night everything was working and no settings were modified nor programs were added/removed. The screen suddenly 'died'. At the moment I am using it through a program MyMobiler which brings the mobile display to the PC and I can use the mouse to control the phone (it is like VNC for the phone screen, the phone is connected with ActiveSync).
This is temporary solution untill I finish my backups of files, programs, settings. I didnot performed hard reset yet, hope this will solve my problem
In the following link there is a 'magical' solution - to remove the screen protector:
http://www.htcwiki.com/thread/1112981/LCD+or+Touch+screen+not+working
P.S. I had removed the screen protector and voilá - the screen is now touch responsive. The root cause of the problem obviously is the dust between the screen and the protector which results in constant screen pressing - and as a result no accepting my finger presses.
I hope this will work for you and others with similar problem.
I had a similar experience with an old Vogue.....In my case, there was no battery death precursor, but it just started acting up. Not too long thereafter, I noticed the screen/digitizer was forming what looked like an air bubble between the digitizer and the LCD on one place of the screen. The screen was becoming defective. I eventually had to buy another Vogue from a friend who didn't have a clue of the 6900's potential, and didn't want his anymore, so I got it cheap.
Sounds like your screen/digitizer may be on it's last leg.
Hi,
I bought my Flipside at the beginning of June and it's been fine up until yesterday. When I slide the keyboard out the screen spazzes out and sometimes works afterward but usually fades to black, causing me to have to take the battery out and turn the phone back on. I can still use the on-screen keyboard but the screen is too small for that to work very well. If the screen starts spazzing out (everything moving around and flashing and jumping) and I try to turn the screen off and back on once it's off it doesn't come back on. Also almost all the time the first time I try to turn the phone back on it hangs on the "M" screen and i have to take the battery out and try to turn it on again. I tried a hard reset but that didn't help anything. I'm worried since this phone is barely a month old that it might be a hardware issue but I don't think I got insurance on the phone and can't afford a new one right now so..any ideas?
Thanks
EDIT: Also, there is no water damage and I've only dropped the phone a couple times, and there's a case on the phone
Hi,
After Xmas I made factory reset with TWRP and I made an upgrade to CM13.(6.0)
It was working fine.
When I was trying to make next daily update, after reboot, screen became black and nothing shown up.
I was trying a lot of things since that moment.
When I was going back from service point (I really want to sort it out) when they told me it is probably LCD broken (i have broken glass, but 1 year ago, so I do not believe it can be screen),
when I take phone out I spotted that keys are highlighted so I swiped and it locked out and shown screen! it was working perferctly fine,
so I decided that it is best moment to flash newest CM to solve issues, but after reboot screen was black again.
I can enter download mode so it is visible in Odin, but screen is black in every mode.
There is only quick flash on screen when turning on and also really short moment of Samsung Galaxy logo which becoming dark quite quickly.
I flashed stock rom(5.0), but nothing changed, despite of that I know phone is turning on somehow because I hear music on turning on...
Can someone help?
I really doubt that it can be hardware issue.
Can it be something with BL ? How can I solve it...?