After i hang up on a call (when the phone is in sleep mode and the screen is locked) the screen unlocks. this is quite contrary to what is mentioned in the phone manual chapter 1 page 45. this becomes an issue since i use a bluetooth headset and the phone remains in its sleeve/case and after every call, a whole bunch of applications will launch since the case is in contact with the screen. have i overlooked some settings or are there other owners who have faced this issue?
ideas and suggestions welcomed
did you check it out if any of the hardware buttons being pressed against the case hence wakening up the phone.?
i had it to only closed al my apps in taskm and it stoped flickering
My HD2 is also behaving in the same way even in controlled test conditions - the phone unlocks when a call comes in (I'm presented with slide to accept or reject call) The phone unlocks during the call, but fails to lock again on disconnect (either by pressing "end call" or hang up via bluetooth).
Can anyone verify this? Is it interacting with something I installed?
I believe I found a (complicated) workaround.
What I want: leave HD2 inside pocket, answer calls with bluetooth headset, hang up and phone will go back to lock.
Problem: After I hang up using bluetooth or press the big red "End Call" button or the other party hangs up, the phone stays unlocked! It stays powered on and all kinds of buttons gets clicked.
Practically all lock sw uses their own lock screen (which I don't want to install). CSDevCtrl does not trigger by phone. TouchLockPro uses its own transparent lock screen but can respond to phone events. Using the !SUSPEND for TAPI\Ended under settings does not seem to work when the screen dims about 50 secs into the call.
Solution: Use TouchLockPro together with LockAndOff. Get TAPI\Ended to run LockAndOff will turn phone off, whether by bluetooth, big red "End Call" button, or the other party hangs up.
BTW: I think there is some confusion on whether the phone locks when you
1. press the big red "End Call" button, or
2. the hard "End call" button
in the forums.
I noticed that HD2 have a light sensor next to the top ear speaker.
During a call, if the phone is put near the ear and cover the light sensor , the screen become non-active which is good.
If anyone can come up with a lock sceen using this light sensor , then the problem with random launch of program when phone inside pocket will be solved.
This lock screen should only activated right after an end of call, beacuse , sometime you may want to use the phone in a dark place.
linivan said:
I noticed that HD2 have a light sensor next to the top ear speaker.
During a call, if the phone is put near the ear and cover the light sensor , the screen become non-active which is good.
If anyone can come up with a lock sceen using this light sensor , then the problem with random launch of program when phone inside pocket will be solved.
This lock screen should only activated right after an end of call, beacuse , sometime you may want to use the phone in a dark place.
Click to expand...
Click to collapse
It's the proximity sensor that turns the screen on and off during a call, not the light sensor. How else would it work in the dark? (which it does)
johncmolyneux said:
It's the proximity sensor that turns the screen on and off during a call, not the light sensor. How else would it work in the dark? (which it does)
Click to expand...
Click to collapse
My proximity sensor does not work, when I am getting a call my screen turn off and when I am taking the phone out from my face it turn on only when I am out side at the sun!! the screen stay off when I am inside room. I tested it with flsh light and it is working also.
I have a T-Mobile US version of the HD2. I am having the same problem when using the bluetooth system in my car. After answering or making a call the phone stay unlocked. And then starts making random calls while I am driving!!!!
There has got to be an easy fix for this!!!
Buy pocketshield, problem solved.
i have this unlock problem with 1.48 rom and i solve it by pressing start button and lock. after that everything works fine unless i change theme in settings. then just repeat first step.
Solved
Same trouble with me until I use the following software. I tried it and it's almost perfect. unzip it and just copy to your HD2, run CallerLoc.exe and click Yes, you'll find:when you hang up, or he/she hang up a call, or a call is established, the screen will turn off.
Why say 'almost perfect', the software is in chinese, but the filename is in english. and it's a call location software but with the function we need.
To stop or before you delete the software, run Callerloc.exe and click Yes again.
Hope this will help you. Sorry I don't find a English version of this software. I esure and I'm using this software perfectlly with my Leo.
theciscokid said:
Buy pocketshield, problem solved.
Click to expand...
Click to collapse
Same for me
Greetings.
I understand this is quite an old thread I'm digging up but I need a little help as well and I didn't want to start a new topic just for that.
I've this silly problem, appeared right out of the blue:
You all know the standard manila behavior, when the phone is idle, the screen first dims and after some more time, depending on your preferences, the screen locks. It also locks if you press the power off button. This all was happening to me till this morning.
I added an event in the calendar (the only change I made today) and after that, my phone dims and then goes in sleep mode after the designated period of time, but DOESN'T lock!!! It doesn't even lock when I press the power off button. I can still lock it by pressing Start and then lock or by press and hold the power button and choose the lock phone option. So one would say that it's still operational, so why bother about it, but I kinda liked the standard function and I have to freaking idea why it changed!!!
I'd be most appreciative if you could offer some help with that.
Oh, I forgot to mention. Soft reset didn't solve the problem. Erasing the calendar event didn't either.
My phone runs the factory ROM (1.66.482.1 ELL), I haven't changed anything other than user settings (yeah, I'm a noob... )
Thanks in advance!
Nasos
Pocketshield could be the end of your problems. You can try it for 10 days and see how it goes...
But why do I need to buy third party software in order to revert my phone to it's original operation?
No, this is not the answer I am looking for. I was wondering if you know of any kind of settings that might have changed by accident and caused this undesired behavior.
Thanks.
The best to return to normal operation would be a hard reset. Or you can spend a while trying.
You can try
HKLM\Software\Microsoft\Shell\Lockscreen\Enable=1
HKLM\Software\Microsoft\Shell\Lockscreen\Active=1
Thank you very much. I opted for the hard reset option... I hope it stays ok this time!
My HD2 also had some strange unlocking and unwanted calling.
I noticed it appeared when using the android style lockscreen.
When I changed back to the original one, problem solved
i had this too. the andriod lockscreen seems to be a bit buggy last time i used it, i accidentially called 7 random numbers
Hi guys. First post so I'll try to be brief and explain as best as I can. Here's the scenario.
Phone is in shirt pocket screen is off, phone is locked and bluetooth headset is connected. The phone rings, I answer with the headset and complete the call ok. Now, when the other person hangs up, my phone screen stays active in my pocket and ends up getting all sorts of menus activated.
Is theres a way to turn the screen off immediately upon call completion?
Yep. Me too. Ony complaint I have with the phone. Have to take the phone out of my pocket and hit the end key to turn off the screen. Never had this problem with all other HTC touch devices that I have had with countless custom ROMs. Anyone help.......Please.
Try PocketShield. It will replace your WM lock screen and will offer some more possibilities (auto lock after call ends for example)
Thank you very much
Hi there,
I have been a member for a short while but I have learned a lot from the members and enjoyed their genius in answering just about all of my questions ever since I upgraded to HD2.
Even after all my searches I still have one more bugger left with the phone which I could not find the work around as of yet.
I happen to be on the go almost all day long and I use wired or Bluetooth wireless hands free sets to get through my conversations.
Once I answer the phone via either of your headsets the screen stays on in the cramps of my pocket or back pack which mostly houses my HD2 while I am on the go. The proximity sensor seldom turns the screen off and as a result of my moving around some on screen bottoms, namely the end call, are pushed.
The hard key that turns the screen off normally also doubles back as the end call key so pushing it hangs the calls rather than turning the screen off.
In short I am looking for a way to make the screen go off during my conversations, preferably via some other hard key so as to make sure I have no unwanted anything activated, or deactivated for that matter
Thanks
So what seems to be the deal? It’s a weird question or what? I mean not even a simple reply? Have I got it so very off the base here or is this something nobody experienced or has had issues with?!!
Come on people throw me a line here!!
Did You tried a S2U2 ? It has a feature to lock device during incoming calls and many more.
I am using the European Tab, but that probably makes no difference.
For security, I lock the phone automatically after 3 minutes of inaction. This works fine for all apps except phone. Strangely, after dialling (or after picking up a call) the phone first turns off the screen, and briefly thereafter locks the device, within 10 seconds. I can continue the call, but as the screen is off, I can not hang up, unless I first switch it on and enter the password.
I have not found a parameter to influence this behavior. But I know it is not related to the proximity sensor, as the effect happens the same way even when not moving the device from the desk.
Is this a confirmed behavior or does anyone know a cure? It's ok if the screen goes dark, and even if you must turn on via power button, but the password?!
Thanks for any help,
Rolf
rgbigel said:
I am using the European Tab, but that probably makes no difference.
For security, I lock the phone automatically after 3 minutes of inaction. This works fine for all apps except phone. Strangely, after dialling (or after picking up a call) the phone first turns off the screen, and briefly thereafter locks the device, within 10 seconds. I can continue the call, but as the screen is off, I can not hang up, unless I first switch it on and enter the password.
I have not found a parameter to influence this behavior. But I know it is not related to the proximity sensor, as the effect happens the same way even when not moving the device from the desk.
Is this a confirmed behavior or does anyone know a cure? It's ok if the screen goes dark, and even if you must turn on via power button, but the password?!
Thanks for any help,
Rolf
Click to expand...
Click to collapse
It happens to me lately after I flashed a new Rom but I highly doubt that has anything to do with it...it feels like a proximity sensor issue, and a autolock issue as well . I am Clueless sorry
I use my phone a ton for calls , imagine that .
Lately when I put a call on speaker, the screen will not turn off. It will not time out and even if I press the power button to shut the screen off manually, it just comes right back on.
Has anyone else experienced this and if so have you been able to correct it?
p.s. this has only been happening in the past week or so and I can't think of anything I did or any updates that would have caused this.
Thanks
I'm experiencing this same thing. Tried multiple things and even did a hard reset and the issue still persists. Very annoying.
I found a workaround where if I come out of the phone app, then I can lock the screen.
got the same thing. i read something on AC( think it was) regarding the calendar notifications not allowing the screen to go dark too. i wake up, my phone is super hot if i have an all day appt with a notification. did yall find a fix to this? the other forum mentioned possible connection to samsung pay.
Having the same issue. The screen does not turn off when holding the phone to my ear or when I'm using bluetooth headset.