Hello Everyone,
I hope you are doing good, Cant run my S7 G930T mobile.
I have upgraded OS via Odin, it passed but phone is not getting work.
Sometimes it doesn't open recovery boot and gets stuck at Recovery Booting.....
Sometimes it restart from the installing applications screen.
If you have any files for binary 11 or anything i need to do before flashing OS via Odin.
Please help me
I'd be very thankful to you.
Thanks!
[email protected]
Related
Hi All
Please help!!!
Model Name: Samsung Note 3 -N9005
Bought in: Dubai
My phone battery went down and upon charging back i found the phone stuck on 'Samsung logo' screen after booting.
Steps taken already:
1. Using ODIN3 V3.11 ran CF Root .tar file for N9005 International Version
2. Flashed the ROM with the help of recent firmware (UAE Version) downloaded from Sam mobile
After flashing, it rebooted and Android started upgrading, then it started Apps and went back to 'Samsung logo screen' and stuck again. I have all my 2 years of data stored and haven't taken any backup as well. I'm fine with the phone dead but I need you guys help to recover the data.
Any help is highly appreciated.
Not going to recover data unless your PC can see the phone and its files .
If it can then try Recuva .
My PC doesn't recognize the phone. :crying:
Any other steps to bring back the device alive?
Flash stock rom via Odin .
Stuck on boot screen factory reset .
Flashing will lose some data .
If the phone is recognized by the computer in download mode, flash twrp, boot into twrp, mount data partition, see if you can copy files to the computer.
Hi guys
Ive flashed this device and everythings fine in odin, just that when it restarts in the boot menu on the Samsung logo, and i cant Wipe/Factoryreset since it comes up with the mdm error.
ANY ideas?
what did you flash to your device >.>
I flaashed A stock firmware from Odin, i Odin itself it goes as it should
Hi,
I recently got me a Galaxy S5 (SM-G900F) and the first thing i wanted to do was installing CM13 as I always do with my new phones. However, when i followed te steps on CM wiki using Heimdall to flash TWRP the blue bar of the downlaod mode increases a small bit, then stops and in the command promt it says something about error with finding PIT. After trying this for three times i decided to go with Odin, which I do prefer anyways.
I tried flashing TWRP , the blue bar is filling to 100% but then on the little screen where Odin usually states FAIL! or PASS! it just says RESET! and my phone is restarting. Shortly after it restarded you can see the RESET! turning to PASS!, but when I tried checking in TWRP is installed, it wasn't. I tried it again and then Odin suddenly says FAIL! After restarting my phone it says "Firmware upgrade encountered an issue. Please select recovery mode in Kies & try again". I couldnt even enter download mode anymore till I tried if getting out the battery would work. I could enter download mode again and flashed the same TWRP on my phone again, and aigain it says RESET! but after that my phone worked again. I tried flashing with another version of Odin and TWRP but same thing happened - First run it said RESET!, second run FAIL!.
I thought maybe rooting the device and installing TWRP via their app afterwards could do the trick. So i tried flashing Autoroot with Odin but it made my phone showing a screen with Samsung logo and in the upper left corner something about recovery mode, seemed to be a loop/freeze. So i took out the battery again and flashed TWRP and that solved the problem again. At last I tried rooting by using TowelRoot but it says the service is not available for my device, even though S5 is listed as a supported device.
I really have no idea what to do anymore, would be very grateful if someone could come up with a solution.
BTW: Is it possible to flash CM13 without using custom recovery by using stock recovery?
Greetings
Khalitas
Khalitas said:
Hi,
I recently got me a Galaxy S5 (SM-G900F) and the first thing i wanted to do was installing CM13 as I always do with my new phones. However, when i followed te steps on CM wiki using Heimdall to flash TWRP the blue bar of the downlaod mode increases a small bit, then stops and in the command promt it says something about error with finding PIT. After trying this for three times i decided to go with Odin, which I do prefer anyways.
I tried flashing TWRP , the blue bar is filling to 100% but then on the little screen where Odin usually states FAIL! or PASS! it just says RESET! and my phone is restarting. Shortly after it restarded you can see the RESET! turning to PASS!, but when I tried checking in TWRP is installed, it wasn't. I tried it again and then Odin suddenly says FAIL! After restarting my phone it says "Firmware upgrade encountered an issue. Please select recovery mode in Kies & try again". I couldnt even enter download mode anymore till I tried if getting out the battery would work. I could enter download mode again and flashed the same TWRP on my phone again, and aigain it says RESET! but after that my phone worked again. I tried flashing with another version of Odin and TWRP but same thing happened - First run it said RESET!, second run FAIL!.
I thought maybe rooting the device and installing TWRP via their app afterwards could do the trick. So i tried flashing Autoroot with Odin but it made my phone showing a screen with Samsung logo and in the upper left corner something about recovery mode, seemed to be a loop/freeze. So i took out the battery again and flashed TWRP and that solved the problem again. At last I tried rooting by using TowelRoot but it says the service is not available for my device, even though S5 is listed as a supported device.
I really have no idea what to do anymore, would be very grateful if someone could come up with a solution.
BTW: Is it possible to flash CM13 without using custom recovery by using stock recovery?
Greetings
Khalitas
Click to expand...
Click to collapse
RESET! is basically the same thing as PASS! What version of TWRP are you installing? The keis screen you got is the same as download mode. Why are you using heimdal? your idea to go with Odin was a good one. Anyways, download TWRP 3.0.2 (not 3.0.2-1 or 3.0.2-2 as they are buggy) and flash it in Odin, reboot to recovery and install the ROM you like, of course following its specific install instructions. No, you cant install a custom rom with stock recovery
Thanks for your answer, meanwhile i managed to fix this problem. Had to flash the latest Firmware because twrp (could just install the oldest version otherwise I had no option to boot into recovery at all) said no OS installed. After rooting via Odin worked like it's supposed to.
Why did I use Heimdall? Because I wanted to stick to CM-wikis instruction and they used Heimdall.
Hello all! I need some help with my Note 3 Sm n900p
I am in root (used win10 and kingo root for this) with absolute success.
Next, I followed this guide on Youtube: watch?v=4LyG5KW5jpQ
Upon flashing the TWRP .img file and rebooting I am stuck on the Galaxy Note 3 startup screen with the message "Set Warranty Bit: Kernel" above it. It wouldn't allow me to shut the phone down, but I was able to reboot into recovery mode and factory reset/wipe the data partition.
It still will not boot or do anything beyond that same splash screen. I removed the battery as the phone will not shut down.
I don't know much about flashing custom ROMs, I was attempting to install TWRP so that I could flash Lineage OS 15.1 without using ODIN, without using a computer. Please help. I can't get it to boot at all as it stands and I'm worried I've bricked it permanently
Usual is wrong TWRP flashed.
What did you use to flash this youtube TWRP ??
As you are posting in a forum not for your phone its 99% a file for a different model .
Suggest you post in the forum for your model .
https://forum.xda-developers.com/note-3-sprint
Did you unlock the phone's bootloader? I believe Sprint phones come with locked bootloaders.
Hello All,
I have a galaxy a8 that I tried to boot into download mode to check if my drivers are working on the PC and it's stuck on the Samsung logo now. The problem is that I have data on it that are important and I have to save otherwise I would perform factory restart or flash it with regular CSC with Odin. I tried flashing the latest official firmware with HOME_CSC binary but it's still stuck.
I also tried simple stuff as cleaning cash and leaving it off for a day to power-drain but it's still stuck.
Can somebody please advise on any tips that I should try I been trying to unblock it for days
Thank you in advance