I've updated my 6T to OxygenOS 10 successfully and factory reset my phone after the update as well. The phone now has a stuck yellow ting everywhere but on the lock screen?
Any have any idea whats gone wrong or how to fix it?
I'm in the same situation but then i tried changing display settings in below location
Display -->Screen calibration
In the Advanced setting you can go for
1.AMOLED Wide gamut
2. Display P3
Where you can avoid that yellow tint
sounds like night mode is on always on night mode did you have any magisk mods installed and if you use xxx rom you needed to uninstall and reinstall after you boot 10
Related
I dont often use flight mode, but when I did recently, about an hour later I noticed the phone was dimly lit and on. It was on the Samsung logo, like it rebooted and stuck on boot. The blue LED was on and the 'kernel not seandroid enforcing' in the corner. Could not turn it off without removing battery. Even when I put battery back in, again stuck on boot.
Eventually managed to get into recovery and wiped dalvik and cache, but still same problem. This is on MM 6.01 stock debloated (either xXx 2.1 or _andr 3.3 devbase). Restored a full backup and managed to boot and seemed to work OK, but it again froze after 10-15 min.
Problem was only fixed when I restored an older LP backup (xXx 1.6). 2 days later works fine even in flight mode. Anyway, googling this issue, seems a few others experienced same, but on LP. Havent seen instances of it happening on MM, but not sure I want to go back to MM so soon.
Anyone else experienced similar issue? And what could have caused this to happen when in flight mode?
Same thing happened to me with the BTU modded MM 6.0.1 ROM G900FXXU1CPDF-BTU, but nothing to do with flight mode, I just noticed the phone dim and stuck trying to boot
I went back to G900FXXU1CPD7-BTU and it's been fine since
So for a few weeks now, my phone has been having bootloop issues. I've been trying to fix it on my own, but no luck so far.
I can get it into download mode. Up until I tried to restore it to its stock version via the User Tool, I could get it to the factory reset options, which led to the options to wipe cache, reboot, etc. However, none of those options worked. When I attempted to reset to factory settings, I got the "dead" green android with the red triangle. Then the screen goes black and starts bootlooping again.
Once in awhile I can manage to turn it on after having it turned off for hours, or even days and it works like normal, except that if I lock it or turn it off it will end up restarting and starting to bootloop again. Which is bad seeing as it drains somewhat fast due to being overheated while having the screen constantly on.
As for my experience trying to use update recovery, it gets to the downloading part then stops and gives me this message "[011.700.147.062.092]??? ??? ? ? ????". I don't even know if I am using the correct stock rom for my phone, since I only know its MEID and model name.
do u resolved this, i have the same problem
I have some issues with my s4 a few weeks ago it started
first i couldnt change my brightness right after that my boot animation disappear and now i cant enter my recovery i found that out because today i tryed to delete everything and install new in hope that the bugs will go away but then this
i think i can go in to the recovery but my screen does not show it but i am not shure about that.
also after i tryed to install 5.1.0 android to maybe get in recovery, (befor i had 4.4.4 installed because i have a weird input lag in 5.1.0) i noticed that the screen is flickering but only in 5.1.0 in 4.4.4 i never had this
what i already tryed: install I9515XXU1ANK2_I9515YXY1ANL2_I9515XXU1ANK2_HOME.tar and I9515XXU1BPK3_I9515YXY1BPK2_I9515XXU1BPK3_HOME.tar ,
adb reboot to recovery , tryed to change kernel with app but i think that didnt worked
installed twrp, cmw both didnt worked
please help me to fix my phone
Does the phone boot properly to the desktop after flashing the latest stock ROM?
yes it boots normal
btw little update i found out i can use my recovery my screen just dont show any thing
i found that out because everytime i was downgrading from 5.1.0 to 4.4.2 i had to do wipe data or it wont boot
i tryed to go in recovery and go 3 down (wipe data) and then 7 down (yes) just with youtube videos and it worked before the wipe my phone does not start on 4.4.2
that means that my recovery is working but screen just doesnt show it
it doesnt show anything but the white samsung logo, normal system, downloadmode
at any other time my display ist blank
as an example when i turn it on i see the white logo then screen turns blank i hear the bootup sound, after 15 sec screen goes black and when i press unlock i can normal use the phone
but why is it blank while booting and in recovery and also is a bit flickering when phone is turned on normal
Recovery works on stock lollipop?
yes recovery works but screen does not when i enter it
the screen is turned on but it only shows black
same thing when the phone boots up screen in turned on but only shows black untill the phone is booted then screen works but is flickring a tiny bit
i called in a repair shop they told me maybe the backlight control is broken???
because i also cant change my brightness its set to max and doesent get darker when i move the slider
Hello,
I was using my Zenfone 3 (in the back of the device is written ZE520KL) normally: Stock ROM, no Root, Never touched the bootloader (It means that I DID NOT installed Custom ROM nor Unlocked the bootloader nor rooted it). Then suddenly the brightness of the device went crazy. I mean, when I boot de device every thing works fines, but when the screen locks up when I unlock it or wake it up the brightness is lower than the lowest brightness configuration possible.
To try to fix it I:
- Change the brightness in the Android - NO success
- Turn off the automatic brightness adjustment - NO success
- Reseted it to Factory settings - NO success
- Flashed a older version of the android using the script from the package downloaded, i think they call it AFT(Actually, here comes something weird: If I try to flash it with the ZE520KL version of the ROM it does not flashes it, I had to use the ZE552KL version to get the flash working) - NO success
- Unlocked bootloader (Installed the TWRP 3.2.3 and the weird thing is that the extreme low brightness problem that I was facing in the Android when the screen wakes up is present in the TWRP. And the worst part is, it happens from boot into it. I even tried to change the settings and set the brightness to the maximum value in the TWRP's settings and nothing changed) - NO success
As I did not have success with anything, I locked the bootloader and flashed the stock image of Android again.
What really bugs me is that if I restart my device by holding the power button for some seconds, the display starts correctly, the auto-brightness works correctly and the brightness settings works just fine.
Could anyone please help me?
Thank you in advance
Freeny
Hi y'all! I have a serious issue I can't, for the love of me, resolve.
I installed the "Insert Custom Text" mod onto my rooted Android 7.0 Honor 8 phone and it broke my display so my phone boots to a black lock screen and all I can do is power off or restart. Restarting in safe mode yields same result. I can't factory reset either. I can't access my file system through my laptop either. Does anyone know how to go about fixing this, please?