Hello.. How can I fix my ZTE Blade QLux 4G phone can't reset/format after rooting? This phone always restart by their own or turning on then off again at logo only. While at the logo for 3 second, I use hard reset button Vol Up + On/Off button to use reset option but it can't because turning off again. Then, I connect the device to PC/Laptop, my PC/Laptop can't detect the device. How can I fix this problem?
Related
hello. I have a problem. My ZTE Blade 3 will not start. nacikam when the power button the phone only vibrates every second until you let go of the button, nothing displays. FTM mode is activated (vol- + power) did not cause it can be run through (vol- + usb connection), but turns off after a few moments. I can still run it through (vol- + vol + + usb connection). I would like to install the firmware and run the phone. I tried to install via QPST but I do not know how. The phone is detected as ZTE Handset Diagnostic Interface (DFU) (COM17). Please help to repair your phone. I warn that I do not have service BOX. Thanx for help and advice
Problem: Power button is not working on my D800. It doesnt turn on or off when I try to click on it. If the phone is off, the only way to turn it back on is plug in the USB. However, the phone still reset if I hold it for like 10sec. I can't get into recovery by holding the power button and down.
History: The phone was recently bricked into qhsusb_bulk mode. I followed the instructions on this board and re flashed some files. I think this is when the power button stopped working. After that I used LG Flash tool to restore to stock 4.4.2.
If anyone can help, I would very appreciate.
Problem: Power button is not working on my D800. It doesnt turn on or off when I try to click on it. If the phone is off, the only way to turn it back on is plug in the USB. However, the phone still reset if I hold it for like 10sec. I can't get into recovery by holding the power button and down.
History: The phone was recently bricked into qhsusb_bulk mode. I followed the instructions on this board and re flashed some files. I think this is when the power button stopped working. After that I used LG Flash tool to restore to stock 4.4.2.
If anyone can help, I would very appreciate.
plzzzz help mee
Hi,
I'm having issue with a GT-I9505 S4 phone after droped it in the water, key combinaison to turn the phone up are altered, if i only push "power" button, the phone boot in recovery mode, if i push "volume down + home + power" the phone boot android in normal mode.
I've tryed to re-install samsung stock rom, the problem persist, i've tryed to install cyanogenmod 12 and problem still here too.
It's seem the water have corrupted a firmware (maybe qualcomm's firmware?) so i don't find which one !
When powering the phone with "volume down + home + power", all work just fine !
I've checked if some buttons are stuck, so it's seem they work fine too.
Partition mapping seems good, using adb to restart the phone in recovery, download or normal mode work fine, so if i try to reboot from android's menu, it boot in recovery mode.
Does anyone have some help or infos to help me to solve this problem?
Is it possible to "re-map" the key combinaison for turning up the phone?
Thank in advance
Kev
Hello guys, I have a problem with the Red Magic 5G device. I was in recovery mode and I pressed the bootloader mode and the device turned off and I could not restart it completely and it does not accept working with the power button and volume down, nor through the computer or any other way
Please help me