Hey everyone, my ZenFone 5 A501CG running on lollipop has been bricked. I had unlocked my bootloader a few days ago, and then I relocked it using the same person's software as my phone kept freezing. But after I relocked it successfully, my phone couldn't boot.
If it's connected to PC when I try to boot, after the ASUS screen at the start, a USB logo with a white bar shows up and stays there. Afer some time, the bar turns red.
If I try to boot without PC connected to it, the USB logo and white bar flash, the white bar turns red, and my phone switches off. When I try to charge my phone, it shows the battery for a second, then the USB, then it switches off.
Right now my device is rooted and has fastboot working.
PLEASE SAVE ME
Okay, I saved it by flashing stock kitkat firmware using adb sideload.
Related
my x10 suddenly switched off and whenever i tried to power it on , only a vibration and green led flashes continuously like notification, nothing showed up in screen.
when i attach my phone without bringing it "flashmode" to pc via usb Flashtool shows that its in flash mode and after 2 sec it says "device disconnected", this thing continues until i disconnects my phone.
bootloader:- unlocked.
rom:- rooted stock GB.
Please help me.
In my T-Mobile Galaxy S4, I am getting weird loot loop. When I power on the device, It shows Samsung logo, and then go black. When I connect to charger, It shows "charging" for one second and go black. When I try boot into recovery menu, it shows it for a split second and go black. The Only place where I can see the display is "downloading" mode. I managed to put in downloading mode and flash stock ROM twice using Odin, and it was completed successfully, but then when I try boot device, it shows Samsung logo and go black, the whole cycle repeats.
I couldn't understand what is the problem at all. The Display looks fine in "Odin" downloading mode, and since I reflashed firmware, I am going nuts trying to understand.
Please help.
Hi,
Re-flash stock firmware should fix this (I hope it).
Sent from my GT-I9500
Try flashing stock again but don't check anything except f.reset time. After flashing and you see the word "reset" in the status window, remove USB cable, remove battery, replace battery, use button combination to boot to recovery, and perform a factory wipe.
Btw, the T-Mobile s4 forum is here: http://forum.xda-developers.com/galaxy-s4-tmobile
Hi guys,
Was trying to remove the branded rom that came with the phone, neither method of updating worked so i flashed via fastboot the boot, recovery, cust and system images, everything ok the first time, afterwards i tried a different rom and the phone got stuck at the bootlogo, coudn't turn it off, do nothing, left it and i went to sleep, of course the battery died.
Now the phone led is always blinking red no matter how much time i leave charging or connected to pc and can't enter fastboot mode or recovery or update 3 buttons..?
Any ideas? Is it completly dead?
PS: Later was able to turn it off and now it turned itself on (because its connected to charger) and the led isn't blinking anymore, still stuck on bootlogo and nothing happens...
hackerpower said:
Hi guys,
Was trying to remove the branded rom that came with the phone, neither method of updating worked so i flashed via fastboot the boot, recovery, cust and system images, everything ok the first time, afterwards i tried a different rom and the phone got stuck at the bootlogo, coudn't turn it off, do nothing, left it and i went to sleep, of course the battery died.
Now the phone led is always blinking red no matter how much time i leave charging or connected to pc and can't enter fastboot mode or recovery or update 3 buttons..?
Any ideas? Is it completly dead?
PS: Later was able to turn it off and now it turned itself on (because its connected to charger) and the led isn't blinking anymore, still stuck on bootlogo and nothing happens...
Click to expand...
Click to collapse
Hi,you can try what i post here it might work
If you cannot get into fastboot or recovery, try connect it via USB to a PC, then hold volume + power up, release power up when it turns on but keep holding vol up.
cristi.blidariu said:
Hi,you can try what i post here it might work
Click to expand...
Click to collapse
yodaofborg said:
If you cannot get into fastboot or recovery, try connect it via USB to a PC, then hold volume + power up, release power up when it turns on but keep holding vol up.
Click to expand...
Click to collapse
Already tried every sinlge thing/combination, can't get past the boot logo, or seem to charge up the phone, red led always blinking.
Will try to open phone tomorrow disconnect the battery and connect again and try to enter bootloader to flash the 4 .img and get back in business.
Hey! It seems like that you hard bricked your device! Is your P8Lite still under warrenty? Rooting IS allowed in the Huawei warrenty! If you dont have warrenty, Ask some proffesionals.
Have a nice day!
P.S: Im living in Germany. Thats why my english is so bad.
Hello.
I know that this problem is popular but still I can't run my phone.
Everything begins when I was trying to flash twrp and the QFIL crashes. The phone stayed at the EDL mode.
When I plug into charger the phone has blinking red light. When I unplug the charger and try to turn on the device, on the screen shows red empty battery icon and the red led blink once. It seems like the coolpad stayed at EDL mode and can't exit it.
I've tryed to flash rom by QFIL. The programm done everything, succes but the phone still blinking red led and can't turn on. Same with TWRP but not sure is it right versions of firmware and recovery (c103.india.mp.ZIXOSOP5801711191S.user_signed.formal.CPB and EUI_TWRP_6.0.1_V1_ADVANCED_CUOCO92).
Is it permanently deadphone?
Sorry for my english...
Hello friends, I have a pretty specific issue with my Mi A1. My phone suddenly stopped booting and doesn't launch. No matter which buttons I press. When I connect the charger, the blue LED starts blinking and it keeps blinking as long as the charging cable is connected.
I looked at previous forum posts and tried all the solutions but none of them worked for me. However, when I connect the phone to a computer, I get the Qualcomm 9008 mode and when I try to flash a fastboot ROM using MiFlash it actually flashes normally and shows "Success".
Since the phone is able to flash a ROM normally, could this be a faulty LCD screen? Or is this an issue with a faulty motherboard or something else?
if it shows 9008 then its in edl mode when u flash the rom press power on button for 10 to 15 seconds for booting it. and if it won't boot then i think its some kind of hardware issue