Database Users

[Q] I brick my L7 Help needed

Hey, really i need Yours help, I have a big problem with l7.
Phone is switched on only in emergency, or if i just turn the phone hangs on the LG logo.
I tried to fire up fastboot but jumps secure booting error.
CM10 previously installed according to the instructions in some forum, but did not work the mobile phone network, so I wanted to reinstall the factory soft by KDZ.
Unfortunately, the first attempt was unsuccessful, and now when trying to install any version of the system (V10K, V10a), the phone is detected at the begining, and installs soft, but after this, phone is restarting and freezes on LG logo, and the computer tries to install the driver for "MTP USB Devices" Unfortunately, the driver is not installed and the installation is not coming to an end.
I tried to install the phone in a mode other than CDMA and EMERGENCY, but there is an error in the system "model II msg not found" and the installation ends with the same result.
Mention that several times before installing the factory soft and there were no problems. Perhaps it is a matter of something that I installed on the phone with the CM10 (unlocking bootloader?)
After the installation process in KDZ upgrade error message pops up wparam: 100 lparam: 6
I will be very grateful for any help.
I'm sorry for my english if something is dificult to understand. Then i'll explane everything You need.

solved problem
When the L7 stuck on the LG logo, restart the process, run the file Flash_Bootloader.bat then Flash_Recovery.bat, then Reboot2Recovery.bat. When you get into Recovery Mode, do the restore files that you have done this before, or reinstall CM10 ..... that's all you need to do and your L7 will work again. I hope I helped .... Regards:fingers-crossed::fingers-crossed::fingers-crossed:

I think its communication problem when you flashing through KDZ. Try changing modem port of the phone wich is free and reflash it!

R: [Q] I brick my L7 Help needed
I had this problem too, just flash homero' s V10K and when it finishes DONT disconnect The phone from The PC,when phone is booting fire up terminal on your PC and write adb reboot recovery, Then when you are in CWM wipe data,cache, dalvik and reboot!
Sent from my LG-P700 using xda app-developers app

Hi all,
i have the same Problem, i install the V10K.kdz file
but the L7 freeze at the boot logo... i have no Idea...
i Flash also with this file---> homero' s V10K - the same effect freeze on the Boot logo
hope u can help me
:good: :good: :good:

DuckDagobert007 said:
Hi all,
i have the same Problem, i install the V10K.kdz file
but the L7 freeze at the boot logo... i have no Idea...
i Flash also with this file---> homero' s V10K - the same effect freeze on the Boot logo
hope u can help me
:good: :good: :good:
Click to expand...
Click to collapse
Just follow what I described in the post before yours,and your phone will boot

Hi,
thanks for your Comment :good::good:
I try it 100, but it doesnt work
i dont know, my the Problem is, can u make ah tutorial with Pic ??
or when u are German, can u send me ah PN ??
Greets

Yeah,I'll make a tutorial
Just posted the Thread in Android Development !

LG P700 stuck in a boot loop help!!!

Hi everyone
please accept for my poor English straight away and that i am noob
i bought LG p700 from the ebay saying that it is stuck in a boot loop mode so i thought it will be an easy fix which is not at all,
what i found out that it has a clockwordMod Recovery v6.0.3.2 i am not really sure if it helps or not ,
i red i couple topic's how to go back to the stock Rom but it doesn't work for me the the KDZ doesn't found the phone, even thought when i connect it to the computer the windows 7 automatically installed the drivers of the phone,
also i tried to install from my sdcard cm-10-20131006-NIGHTLY-p700 but it didnt work , everything goes fine but in the end it steal stucks in the boot loop,
so is there anyone could help me with is phone i will appreciate it a lot , also i prepared to install a stock Rom because i am a bit an old fashion i got
KDZ_FW_UPD_EN and V20D_00.kdz but as i said when i tried to install it, it didn't go true because i got a message where it says that the phone was not found
many thanks
gugutm

gugutm1 said:
Hi everyone
please accept for my poor English straight away and that i am noob
i bought LG p700 from the ebay saying that it is stuck in a boot loop mode so i thought it will be an easy fix which is not at all,
what i found out that it has a clockwordMod Recovery v6.0.3.2 i am not really sure if it helps or not ,
i red i couple topic's how to go back to the stock Rom but it doesn't work for me the the KDZ doesn't found the phone, even thought when i connect it to the computer the windows 7 automatically installed the drivers of the phone,
also i tried to install from my sdcard cm-10-20131006-NIGHTLY-p700 but it didnt work , everything goes fine but in the end it steal stucks in the boot loop,
so is there anyone could help me with is phone i will appreciate it a lot , also i prepared to install a stock Rom because i am a bit an old fashion i got
KDZ_FW_UPD_EN and V20D_00.kdz but as i said when i tried to install it, it didn't go true because i got a message where it says that the phone was not found
many thanks
gugutm
Click to expand...
Click to collapse
Install LG PC Suite, the LG Mobile Support Tool and the LG L7 USB driver. Then try again. Make sure your phone is set on 3GQCT and EMERGENCY on KDZ.

Before you install a ROM, you're recommended to wipe data.
Bootloops can occurs in many ways, if you can logcat your problem, maybe we can help you.

F4uzan said:
Before you install a ROM, you're recommended to wipe data.
Bootloops can occurs in many ways, if you can logcat your problem, maybe we can help you.
Click to expand...
Click to collapse
hi there im stuck in lg logo i had 4.4.2 but i had some problems with my gps so i decided to go back on v20d i used kdz emergency 3gqct battery out phone in emergency mode and im stuck in lg logo please can someone help me and sorry if my english is bad im from croatia.

[Q] Optimus L5 E610 stuck on download in progress

Hello guys,
I tried to change firmware with KDZ updater and put europian open V20G something went wrong program force closed during process and now my phone is tottaly stack on "Dowload is in progress. Do not disconnect cable.", hard reset doesnt do, anything I tried did not work...
Anyone has some idea, or I can throw my phone?

Its simple enter EMERGENCY MODE (battery out then VOL DOWN and plug USB cable) and flash KDZ again. Phone will work.

[Q] Stuck at security error

Hi everybody!
I have Lg g2 D802 Baltics. Yesterday I tried to return to Stock KitKat via Lg mobile support tool and Flashtool, both of them didn't work, they just didn't find my phone in download mode. Then I decided to reroot and reinstall TWRP. The first was done and the second too, but unfortunately my phone restarted and got a Security error and LG logo and can't boot, just permanently restarts. I've already read a hundreds of articles like http://forum.xda-developers.com/showthread.php?t=2432476 . The method written here isn't working for me because the Flashtool just can't find my phone when trying to install a firmware. So, any program like Lg support tool and Flashtool don't find my phone, so I can't do anything with my phone to get it to work. I'm facing i real problem for me and i'm quite shocked. So, please, tell me what to do, how to fix my phone. I tried a lot of thins, nothing helped. What to do?

[Q] Bricked my LG G2 need help

Hello XDA-Community
Today i accidently briked my G2 (D802 KitKat 4.4.2). I was flashing it because i wanted to unroot it but during the process an error showed up and my phone was dead.
So i tried to fix it with this method http://forum.xda-developers.com/showthread.php?p=48765620#post48765620 but it didn't worked as planned.
Now i have an G2 which is stuck in a bootloop and i can't even reach the recovery or the download mode and i don't have any custom recovery installed.
Anyone who can help me with this get's an 10€/$ PSC. I can't give more because i dont have any money left (16 years old).
Big thanks to everyone who can help me with this
PS: Sorry for my bad english i'm not a native speaker

While you wait for an answer make sure your phone is kept charged.
Have you tried LG flashtool and your stock ROM?

make sure it's off, hold the VOLUME UP button while plugging it into your computer, and that should get it into download mode.
Next try using the TOT method (google it) and voila!

Yeah the problem is that i can't even reach the download mode and my computer doesn't recognize my phone it's just an qshub device. ;(

I had the same issue bricking my lg g2 and i was stuck with the logo and nothing more not even download mode,recovery etc...
The way i got it to stock was i installed the lg g2 drivers and from there on just flashed it with flashtools kdz and got it workking again i think this shoould help you out just plug your phone and install the drivers and use flashtools

Install this driver then report me back or cap screen device manager to me.I will help you for fee.
https://www.dropbox.com/s/a69s06mkpzao01m/qhsusb_bulk_DRIVER_G2.zip?dl=0